Resumo do conteúdo contido na página número 1
OPERATING MANUAL
MODE D’EMPLOI
MANUAL DE FUNCIONAMIENTO
AIR CONDITIONER
FLOOR CONSOLE/
UNDER CEILING
DUAL TYPE
KEEP THIS MANUAL FOR FUTURE REFERENCE
CONSERVEZ CE MODE D'EMPLOI AFIN DE POUVOIR VOUS Y RÉFÉRER ULTÉRIEUREMENT
GUARDE ESTE MANUAL PARA PODERLO CONSULTAR EN EL FUTURO
P/N9359944065
9359944065_OM_cover.p65 1 13/1/06, 14:13
Español Français English
Resumo do conteúdo contido na página número 2
CONTENTS SAFETY PRECAUTIONS ....................................... 1 ADJUSTING THE DIRECTION OF FEATURES AND FUNCTIONS .............................. 2 AIR CIRCULATION ............................................... 10 NAME OF PARTS ................................................... 3 SWING OPERATION ............................................ 11 PREPARATION ....................................................... 5 CLEANING AND CARE ........................................ 12 OPERATION ......
Resumo do conteúdo contido na página número 3
FEATURES AND FUNCTIONS AUTOMATIC OPERATION COOLING MODEL Merely press the START/STOP button, and the unit will begin automatic operation in the Cooling or Dry mode as appropriate, in accordance with the thermostat setting and the actual temperature of the room. HEAT & COOL MODEL (REVERSE CYCLE) Merely press the START/STOP button, and the unit will begin automatic operation in either the Heating, Cooling or Monitor modes as appropriate, in accordance with the thermostat setting and the actual
Resumo do conteúdo contido na página número 4
NAME OF PARTS Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle). Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 6 Fig. 5 En-3 9359944065_OM_en.p65 3 13/1/06, 14:14
Resumo do conteúdo contido na página número 5
Fig. 1 Indoor Unit Fig. 4 Remote Control Unit 1 Operating Control Panel (Fig. 2) C SLEEP button 2 MANUAL AUTO button D MASTER CONTROL button 3 Remote Control Signal Receiver E SET TEMP./SET TIME buttons ( ) 4 OPERATION Indicator Lamp (red) F Signal Transmitter 5 TIMER Indicator Lamp (green) G TIMER button 6 SWING Indicator Lamp (orange) H FAN CONTROL button (VERTICAL SWING) I START/STOP button 7 SWING Indicator Lamp (orange) J AIR FLOW DIRECTION (HORIZONTAL SWING) VERTICAL SET button If the
Resumo do conteúdo contido na página número 6
PREPARATION CAUTION! Load Batteries (R03/LR03/AAA × 2) Take care to prevent infants from accidentally swallowing batteries. Press and slide the battery compartment lid on the re- When not using the remote control unit 1 verse side to open it. for an extended period, remove the batteries to avoid possible leakage and Slide in the direction of the arrow while pressing the mark. damage to the unit. If leaking battery fluid comes in contact Insert batteries. with your skin, eyes, or mouth, i
Resumo do conteúdo contido na página número 7
OPERATION Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle). To Select Mode Operation Press the START/STOP button. 1 The indoor unit’s OPERATION indicator lamp (red) will light. The air conditioner will start operating. Press the MASTER CONTROL button to select the de- 2 sired mode. Each time the button is pressed, the mode will change in the following order: sAUTO sCOOL s DRY t t *HEAT FAN About three seconds later, the entire display will reappear.
Resumo do conteúdo contido na página número 8
OPERATION Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle). About Mode Operation AUTO: COOLING MODEL When the room temperature is 4 °F higher Cooling Operation than the set temperature, the mode will switch between Cooling and Drying. Dry Operation During the Drying mode operation, the FAN setting should be switched to LOW Thermostat control for a gently cooling effect during which the fan may temporarily stop rotating. 4 °F If the mode automa
Resumo do conteúdo contido na página número 9
TIMER OPERATION Before using the timer function, be sure that the Remote Control Unit is set to the correct current time (See page 5). To Use the ON timer or OFF timer To Cancel the Timer Press the START/STOP button Use the TIMER button to select “TIMER 1 RESET”. (if the unit is already operating, proceed to step 2). The air conditioner will return to normal The indoor unit’s OPERATION indicator lamp (red) will light. operation. Press the TIMER button to select the OFF timer or ON To Change the
Resumo do conteúdo contido na página número 10
SLEEP TIMER OPERATION Unlike other timer functions, the SLEEP timer is used to set the length of time until air conditioner operate is stopped. To Use the SLEEP timer To Cancel the Timer: While the air conditioner is operating or stopped, press the Use the TIMER button to select “TIMER SLEEP button. RESET”. The air conditioner will return to normal Both the indoor unit’s OPERATION indicator lamp (red) and the TIMER indicator operation. lamp (green) will light. To Stop the Air Conditioner During
Resumo do conteúdo contido na página número 11
ADJUSTING THE DIRECTION OF AIR CIRCULATION Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle). Vertical (up-down) direction of airflow is adjusted by pressing the remote control unit’s AIR FLOW DIRECTION VERTICAL SET button. Horizontal (right-left) direction of airflow is adjusted by pressing the remote control unit’s AIR FLOW DIRECTION HORIZONTAL SET button. DANGER! Vertical Air Direction Adjustment Never place fingers or foreign objects inside the
Resumo do conteúdo contido na página número 12
SWING OPERATION Begin air conditioner operation before performing this procedure. To select Vertical airflow SWING Operation Press the AIR FLOW DIRECTION VERTICAL SWING button. The SWING indicator lamp (VERTICAL SWING) (orange) will light. In this mode, the UP/DOWN air direction flaps will swing automatically to direct the air flow both up and down. To Stop Vertical airflow SWING Operation Press the AIR FLOW DIRECTION VERTICAL SWING button once again. The SWING indicator lamp (VERTICAL SWING) wi
Resumo do conteúdo contido na página número 13
CLEANING AND CARE Before cleaning the air conditioner, be sure to turn it off and disconnect the power supply cord. CAUTION! Be sure the intake grille is installed securely. When removing and replacing the air filters, be sure not to touch the heat exchanger, as per- sonal injury may result. Cleaning the Air Filter 1. Pull out both sides and the center of the 4. Re-attach the air filters to the intake grille. 1 The air filters fit onto the inside of the intake grille. intake grille. (figu
Resumo do conteúdo contido na página número 14
SELECTING THE REMOTE CONTROL UNIT SIGNAL CODE When two or more air conditioners are installed in a room and the remote control unit is operating an air conditioner other than the one you wish to set, change the signal code of the remote control unit to operate only the air conditioner you wish to set (four selections possible). To operate only When two or more air conditioners are installed in a room, please contact your one of multiple retailer to set the individual air conditioner signal codes
Resumo do conteúdo contido na página número 15
TROUBLESHOOTING Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle). In the event of a malfunction (burning smell, etc.), immediately stop operation, disconnect the WARNING! power supply plug, and consult authorized service personnel. Merely turning off the unit’s power switch will not completely disconnect the unit from the power source. Always be sure to disconnect the power supply plug or turn off your circuit breaker to ensure that power is complet
Resumo do conteúdo contido na página número 16
TROUBLESHOOTING Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle). Symptom Items to check See Page CHECK ONCE Doesn’t operate at all: Has there been a power failure? — MORE Has a fuse blown out, or a circuit breaker been tripped? 8 to 9 Is the timer operating? Poor Cooling (or *Heating) Is the air filter dirty? performance: Are the air conditioner’s intake grille or outlet port blocked? Did you adjust the room temperature settings (thermo
Resumo do conteúdo contido na página número 17
OPERATING TIPS AUTO Restart In Event of Power Interruption Should the power supply to the air conditioner be inter- Use of other electrical appliances (electric shaver, etc.) or rupted by a power failure, the air conditioner will restart nearby use of a wireless radio transmitter may cause the automatically in the previously selected mode once the air conditioner to malfunction. In this event, temporarily power is restored. disconnect the power supply plug, reconnect it, and then use the rem
Resumo do conteúdo contido na página número 18
OPERATING TIPS Notice Instructions relating to heating (*) are applicable only to “HEAT & COOL MODEL” (Reverse Cycle). * During use of the heating mode, the outdoor unit will * During use of the heating mode, the top of the indoor occasionally commence the defrost operation for brief unit may become warm, but this is due to the fact that periods. During the defrosting operation, if the user sets coolant is circulated through the indoor unit even when the indoor unit for heating again, the defr
Resumo do conteúdo contido na página número 19
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa a a a a aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa a a a a aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa a a a a aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa a a a a aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa a a a a aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa a a a a aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa a a a a aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Resumo do conteúdo contido na página número 20
SOMMAIRE PRÉCAUTIONS DE SÉCURITÉ ................................. 1 FONCTIONNEMENT MANUEL-AUTOMATIQUE .... 9 CARACTÉRISTIQUES ET FONCTIONS ................... 2 RÉGLAGE DE LA DIRECTION DU FLUX D’AIR .. 10 NOMENCLATURE DES ORGANES.......................... 3 FONCTIONNEMENT OSCILLANT ...................... 11 PRÉPARATIFS ........................................................... 5 NETTOYAGE ET ENTRETIEN .............................. 12 FONCTIONNEMENT ............................................
