Manual do usuário American Standard PIVOT SHOWER DOORS 710007-100

Resumo do conteúdo contido na página número 1

Owner’s Manual
PIVOT SHOWER DOORS
Thank you for selecting our product...the benchmark of fine quality for over 100 years. To ensure that your installation
proceeds smoothly--please read these instructions carefully before you begin.
Record Model Number _______________
710007-100
BEFORE YOU BEGIN...
Local building codes vary by location. Observe all local plumbing and building codes.
Unpack your new shower doors and inspect them carefully for damage. Verify that the doors are the correct size fo

Resumo do conteúdo contido na página número 2

INSTALLATION PROCEDURES: 2 1 Determine side at which the door will pivot (left or right). Flat edge of threshold should face inside of shower. The pivot side should be opposite the showerhead. Identify end of threshold which will be pivot side. Measure width of the opening at the centerline of bottom. Mark the OPPOSITE end for drilling. Cut threshold to size NOTE: This door swings out only. Verify door will clear any W measured in step 1. obstructions before installing. THRESHOLD FLAT EDGE

Resumo do conteúdo contido na página número 3

7 8 Remove pivot jamb with threshold. Drill six holes using a Apply 1/4" bead of silicone caulk where bottom of pivot 3/16" drill bit. (Use a masonry bit for ceramic tile.) jamb and threshold meet (see inset detail). Insert one screw anchor in each hole. Mount assembled pivot jamb to wall using six #8 x 1-1/2" flat head screws. NOTE: When drilling into fiberglass or plastic walls, use a 1/8" drill bit and do not use screw anchors. SILICONE CAULK SCREW ANCHOR #8 x 1-1/2" Phillips Flat Head Sc

Resumo do conteúdo contido na página número 4

14 13 Remove debris and clean threshold & base. Place magnetic jamb over adjustment rail with magnetic strip facing to outside of shower. Caulk end of threshold at wall per detail. Close door and adjust magnetic jamb to allow 1/8" to 1/4" Match holes in magnetic jamb with holes in adjustment rail to clearance between magnetic jamb and door panel. determine which mounting hole is for adjustment rail only. NOTE: If magnets repel each other, remove and reverse. Remove magnetic jambs and moun

Resumo do conteúdo contido na página número 5

HOW TO CARE FOR YOUR ENCLOSURE Do not use scouring powder, pads or sharp instruments on metal or glass panels. Occasionaly wipe with mild detergent diluted in water to keep the panels and metal parts looking new. Use squeegees following each shower to eliminate water spots on the inside of the glass panels. HOW TO ORDER REPLACEMENT PARTS Provide the following information to your Dealer. 1. Part Name 2. Part Number 3. Part Description (Length, Size, Color, etc.) 4. Model Number Key Part Par

Resumo do conteúdo contido na página número 6

AS AMERICA, INC. LIMITED LIFETIME WARRANTY FOR SHOWER DOORS AS America, Inc. (“American Standard”) warrants to the original consumer purchaser that it will, at its sole option, repair or replace this product or any part of this product, if it confirms that the product is defective in materials or workmanship under normal use and maintenance for the lifetime of this product. This warranty does not apply to commercial installations. Commercial installations shall have a limited warranty of 3 yea