Manual do usuário Milan Technology MIL-140TRM

Resumo do conteúdo contido na página número 1

Installation Guide: MIL-140TRM
Regulatory Approvals
• FCC Class A
• UL 1950
• CSA C22.2 No. 950
• EN60950
• CE
– EN55022 Class B
– EN50082-1
Canadian EMI Notice
This Class A digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur
MIL-140CRM and MIL-140TRM
du Canada.
European Notice
10BASE-FL to 10BASE-T
Product

Resumo do conteúdo contido na página número 2

Installation Guide: MIL-140TRM About this Manual 4 5 3 6 2 7 8 This document covers both the MIL-140CRM and the 1 MIL-140TRM media converter modules. The terms “MIL-140” and “converter” are used throughout this document to describe these devices. Introduction Figure 2. RJ-45 Pinouts The MIL-140 converters are part of a series of modules Fiber Specifications: SC and ST Connector designed to be installed into MiLAN's Media Conversion System. These half-/full-duplex devices • 85

Resumo do conteúdo contido na página número 3

Installation Guide: MIL-140TRM Indicators Installation There are four LEDs, including: Do the following to install the MIL-140 into a rack mount chassis: • TP/ACT: Receiving packets from the 10BASE-T port 1. Make any configuration changes to the module (i.e., • TP/LINK: There is an active connection on the DIP switch settings). 10BASE-T port : There is an active connection on the • FX/LINK 2. Remove the screws securing the faceplate and 10BASE-FL port remove it from the

Resumo do conteúdo contido na página número 4

Installation Guide: MIL-140TRM Link Sentry Configuration The Link Sentry feature on the MIL-140 is configured through the 4-position DIP switch (refer to Figure 1). Default setting for the DIP switches: All switches are in the “up” position. 4 3 Link Sentry allows users to add new management tools 2 1 to the network. When enabled, it monitors the selected 4-pin DIP Switch receiver port and, if the Link test signal is not seen, the unit will stop sending a signal through the selec