Resumo do conteúdo contido na página número 1
™
Garage Pro
V ACUUM
USER’S GUIDE
18P0 SERIES
43Z3 SERIES
Safety Instructions
3
4 Product View
5-6 Assembly
6-9 Operation
10-12 Maintenance and Care
13 Troubleshooting
14 Consumer Services
15 Replacement Parts
16 Warranty
ug110-4053_18P0_608.indd 1 6/13/08 12:35:27 PM
Resumo do conteúdo contido na página número 2
Thanks for buying a BISSELL vacuum We’re glad you purchased a BISSELL Garage Pro™ vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your BISSELL Garage Pro™ vacuum is well made, and we back it with a limited two year warranty. We also stand behind it with a knowledgeable, dedicated Consumer Services Department, so, should you ever have a problem, you’ll receive fast, considerate assistance. My great-grandfa
Resumo do conteúdo contido na página número 3
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic ■ This appliance is provided with double-insulation. Use precautions should be observed, including only identical replacement parts. See instructions the following: for servicing of double-insulated appliances. ■ Turn off all controls before plugging or unplugging REaD all InSt RUct Ion S vacuum cleaner. ■ Use extra care when cleaning stairs. bEfoRE USInG yoUR ■ Do not pick up flammable materials (lighter fluid, Ga
Resumo do conteúdo contido na página número 4
Product view Face Plate Power Switch Wet/Dry Hose Inlet Blower Hose Outlet Muffler Power Cord Slots Dirt Tank Handles Dirt Tank 4 www.bissell.com 800.237.7691 ug110-4053_18P0_608.indd 4 6/13/08 12:35:28 PM
Resumo do conteúdo contido na página número 5
Assembly your unit will require no tools to put together. 1. Remove the dirt tank by pulling up on both handles to unlatch. Lift upper half of unit to remove. 2. Remove all accessories and parts stored in the bottom of the tank prior to use. 3. If the round funnel comes out of dirt tank, set back inside the dirt tank before reas- sembling vacuum. 4. To reassemble, place the top of the unit on the dirt tank so the edges fit together and latch handles to secure top and bottom of unit. 5. M
Resumo do conteúdo contido na página número 6
Assembly Mounting & installation continued concrete Wall (fasteners not included) you will need; (4) 3/8” x 2-1/4” concrete sleeve anchors. Use (4) Outer Holes To Mount Bracket 1. Drill a 3/8” x 1-3/4” hole with a masonry drill bit. 2. Insert a bolt and anchor sleeve into the hole. 3. Align the bracket over the hole and mark remaining hole locations using the (4) outer holes of the mounting bracket; remove bracket and drill remaining holes. Slots 4. Mount the bracket starting at top corner
Resumo do conteúdo contido na página número 7
Operation Wet or dry vacuuming mode 1. Attach hose to the wet/dry hose inlet opening (located on the front left side of the unit) by pushing fitted end of hose and turning clockwise until you feel it is secure. 2. Attach extension wand, if desired, to end of hose by pushing it firmly into the hose. WaRnInG: 3. Attach additional wand or tool, if desired, by Do not tamper with firmly inserting onto the wand. float/water sensor. always make sure the 4. Plug in the unit and push the po
Resumo do conteúdo contido na página número 8
Operation thermal motor protection: an internal thermal protector has been designed into your cleaner to protect it from overheating. When the thermal protector activates, the main vacuum motor will stop operating. If this happens, proceed as follows. 1. Turn the vacuum OFF and unplug from electrical outlet. 2. Check the vacuum for the source of overheating problem (i.e. full dirt tank, dirty filters or clog). 3. Fix the problem by following the steps in the maintenance section of th
Resumo do conteúdo contido na página número 9
Operation Floor cleaning (2) Extension wands Use with desired attachment for a longer reach. large area cleaning tool Use on large surfaces for maximum pick up. Multi surface floor tool May be used on both carpet/rugs or hard floor surfaces. f or use on carpets, make sure the tab is Carpet Hard Floor in the down position . t his will hide the soft outer brushes. f or hard floor surfaces, press the opposite tab in the down position . this will engage the sof
Resumo do conteúdo contido na página número 10
Maintenance and care Cleaning the dirt tank 1. Unplug the unit from electrical outlet. 2. Remove the dirt tank by pulling up on both handles to unlatch. 3. Ensure the dirt tank has been emptied. 4. The dirt tank may be washed in warm water. Make sure it is completely dry before reassembling. 5. Reattach the dirt tank to the main unit by aligning the top of the dirt tank to the upper portion of the vacuum. Use one hand to hold the tank and use the other hand to clip the handles to hol
Resumo do conteúdo contido na página número 11
Maintenance and care Cleaning the filters continued Secondary filter 1. The secondary filter is located above the primary filter. 2. To remove the primary filter, see instructions on page 10. 3. To remove the secondary filter, pull filter down and out. 4. Shake filter over trash can to release any loose debris. 5. Rinse filter with warm water. 6. To replace filter, insert into top portion of vacuum. Clearing clogs low suction or poor pickup may be due to a clog in the vacuum. If this occu
Resumo do conteúdo contido na página número 12
Maintenance and care Clearing clogs continued If the clog is contained near the bottom of the hose (close to where tools are attached), follow these steps: 1. Remove wand or tool. 2. Attach hose to the blower outlet and turn the power on. 3. This should dislodge the clog by blowing out debris. If the above methods are not successful, find the clog by hand, then squeeze the hose and shake until the debris dislodges. tool maintenance Keep tools clean and free of debris. 1. Wipe tools clean w
Resumo do conteúdo contido na página número 13
Troubleshooting Wa Rn In G: to reduce the risk of electric shock, turn power off and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting. Vacuum cleaner won’t turn on Possible causes Remedies 1. Power cord not plugged in 1. Check electrical plug 2. Blown fuse/tripped breaker in home 2. Check/replace fuse or reset breaker 3. Thermal protector activated 3. Allow cleaner to cool for 30 minutes, see pg 8. This will reset thermal protector 4.
Resumo do conteúdo contido na página número 14
BISSELL Consumer Services For information about repairs or replacement parts, or questions about your warranty, call: bISSEll consumer Services 1-800-237-7691 Monday - Friday 8 a.m. — 10 p.m. ET Saturday 9 a.m. — 8 p.m. ET Or write: BISSELL Homecare, Inc. PO Box 3606 Grand Rapids MI 49501 ATTN: Consumer Services Or visit the BISSELL website - www.bissell.com When contacting BISSELL, have model number of cleaner available. Please record your Model Number: ___________________ Please record y
Resumo do conteúdo contido na página número 15
Replacement parts - BISSELL Garage Pro™ Vacuum you may purchase parts from your retailer, by calling bISSEll consumer Services or by visiting our website. below is a list of common replacement parts. While not all of these parts may have come with your specific model, they are available for purchase if desired. Please note, all attachments may not store on board your vacuum. Item Part no. Part name 1 203-0151 Hose Assembly- 32 ft 2 203-0152 Hose Holder 3 203-0153 Accessory Caddy 4 203-0154
Resumo do conteúdo contido na página número 16
Warranty - BISSELL Garage Pro™ Vacuum This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state. If you need additional instruction regarding this warranty or have questions regarding what it may cover, please contact BISSELL Consumer Services by E-mail, telephone, or regular mail as described below. limited two year Warranty Subject to the *EXcEPtIonS anD EXclUSIonS identified below, upon receipt of the product BISSELL Homecare, In
