Resumo do conteúdo contido na página número 1
Serial WAN Router
ERT-805
User’s Manual
Resumo do conteúdo contido na página número 2
Trademarks Copyright © PLANET Technology Corp. 2004. Contents subject to revision without prior notice. PLANET is a registered trademark of PLANET Technology Corp. All other trademarks belong to their respective owners. Disclaimer PLANET Technology does not warrant that the hardware will work properly in all environments and applications, and makes no warranty and representation, either implied or expressed, with respect to the quality, performance, merchantability, or fitness for a par
Resumo do conteúdo contido na página número 3
TABLE OF CONTENTS Chapter 1 Introduction ............................................................................................................1 1.1 CHECKLIST.........................................................................................................................1 1.2 ABOUT ERT-805................................................................................................................1 1.3 PRODUCT FEATURE.......................................................
Resumo do conteúdo contido na página número 4
4.7 X.25 PROTOCOL .............................................................................................................. 33 4.8 FRAME RELAY PROTOCOL................................................................................................. 37 Chapter 5 Security ................................................................................................................. 41 5.1 ACCESS-LIST.........................................................................................
Resumo do conteúdo contido na página número 5
Chapter 1 Introduction 1.1 Checklist Thank you for purchasing Planet’s ERT-805 Enterprise Serial Router. Before continuing, please check the contents of your package for following parts: Ø ERT-805 Serial WAN Router Ø Power Cord Ø DB9 adapter Ø RJ-45 to RJ-45 modem cable Ø User’s Manual CD Ø Quick installation Guide if any of these pieces are missing or damage please contact your dialer immediately. 1.2 About ERT-805 ERT-805 provides single WAN port, which is T1/E1 serial
Resumo do conteúdo contido na página número 6
Ø ERT-805 supports SNMP and can be managed by using SNMP management software 1.3 Product Feature Ø Support PPP, FR, X.25, HDLC, LAPB, SDLC, SLIP and Stun Ø Complies with IEEE802.3 10Base-T, IEEE 802.3u 100Base-TX Standard Ø One serial WAN port, one RJ-45 10/100Mbps LAN port and one Console port Ø Provide RIP, EIGRP, OSPF and Static routing protocol Ø Provide Access-list, AAA, RADIUS, PAP, CHAP and CBAC for network security Ø Network Address Translator (NAT) simultaneous use of one IP addr
Resumo do conteúdo contido na página número 7
Power Input 100 ~ 240V AC (+/-10%); 50/60Hz (+/-3%) auto-sensing Power Consumption 10 watts / 34BTU Dimensions 217 x 135 x 43 mm (1U height) Weight 1 Kg 0 to 50 degree C (operating) Temperature -20 to 70 degree C (storage) Humidity 10 ~ 90% RH (non-condensing) Regulatory FCC, CE class A 3
Resumo do conteúdo contido na página número 8
Chapter 2 HARDWARE INSTALLATION 2.1 Package Contents Item includes with ERT-805 serial router. Ø ERT-805 Serial WAN Router Ø Power Cord Ø DB9 to RJ-45 changer Ø Console cable Ø Quick Installation Guide and CD-ROM Console Cable Light blue console cable Black power cord DB-9-to-RJ-45 adapter CD-ROM user’s Guide & (for use with light blue console cable) (for Console Cable) Quick Install Guide 2.2 ERT-805 outloo
Resumo do conteúdo contido na página número 9
Green blink This indicator light blink when packets is transmit LNK/ ACT Green This indicator light green when port is connected This indicator light green when port is connect with Green serial port Serial Blink This indicator light blink when packets is transmit Green blink Configuration process Console Lights Off Not in configuration Rear Panel 100~240V AC Console Fast Ethernet Serial Sync. LAN 50/60HZ Async. Printing Ports Type Description Asynchronies port of ER
Resumo do conteúdo contido na página número 10
2.3 Installation requirements & Physical Installation To install the ERT-805 serial router, the following is required: Ø An Ethernet device, hub or switch with a free MDI-X RJ-45 interface Ø One Category 3, 4, 5, EIA568A straight UTP cable within 100 meters Ø The asynchronous modem or CSU/DSU (Channel Service Unit/Data Service Unit) that is planned to connect the router Ø A serial cable that used to connect the router and the CSU/DSU Ø Rack mount accessories, such as rack ears, screws, an
Resumo do conteúdo contido na página número 11
Available connection is as tables below: WAN Option WAN Encapsulation RS-232 Link control (HDLC) or ppp X.21 Frame-relay V.24 X.25 V.35 2.3.4 Power on the device ERT-805 accepts power input from 100 to 240VAC, 50/60Hz power source. Before connect the power cable to the router, please be sure the AC power output from your power outlet. The router must connected to earth ground during normal use. ERT-805 is a power-required device, it means, ERT-805 will not work until it is powere
Resumo do conteúdo contido na página número 12
Chapter 3 Command Line Interface This chapter describes the basic commands to access the router through console interface or telnet. Be noted if you want to login to ERT-805 through the telnet, then enable password must be configure. The user can input system command configuring system protocol by command line port. When you first login a new router by terminal, the system will give a prompt router>. Now you are in user mode. After typing the command “enable”, the prompt will change to ro
Resumo do conteúdo contido na página número 13
ERT_805> ? disable Turn off privileged commands, enter GUEST user mode enable Turn on privileged commands exit Exit from the EXEC help Description of the interactive help system logout Exit from the EXEC pad Open a X.29 PAD connection ping Send echo messages ppp Start IETF Point-to-Point Protocol (PPP) schedule Schedule one task show Show running system information telnet Open a telnet connection traceroute
Resumo do conteúdo contido na página número 14
clockrate 48000 ! ERT_805(config-serial0/0)# 3.4 Ctrl-Z, Ctrl-C and exit To exit from the configuration mode directly to privilege mode, you should type Ctrl-Z or Ctrl-C or type exit. Ctrl-C can be available in other occasions .For example it can stop the current operation that hasn’t been accomplished. 3.5 Login from Console port Once the terminal has connected to the device, power on the device, the terminal will display that it is running POST (Power on self-test) procedures.
Resumo do conteúdo contido na página número 15
telnet. If configures like below, the system will only ask for password when anyone access. For example set the password as “1234”. ERT805> enable ERT805# config t ERT805(config)# enable password 1234 ERT805(config)#line vty 0 4 ERT805(config-line)# login ERT805(config-line)# password cisco ERT805(config-line)# exi ERT805(config)# exit ERT805# The password is set by the command “password” in vty and has no concern with what have been configured above by the command username. The
Resumo do conteúdo contido na página número 16
Router Software Version 4.2c on Hex_1f73 (3805a) User Access Verification Username: rr Password: (type the password cisco) ERT805> 3.7 Password Encryption Security is a most important issue for all the company in the world because all the system is require password to protect important information from hacker, such as username, enable password…etc. In default the system will display these password by clear. So the password is not very secure. The ERT-805 is offers a command that
Resumo do conteúdo contido na página número 17
crypto isakmp key 12345678 address 10.0.0.2 255.255.255.192 ! interface fastethernet 0/0 ip address 192.168.99.64 255.255.255.0 ! interface serial 0/0 encapsulation ppp ip address 10.0.0.1 255.255.255.192 crypto map dynmap clockrate 48000 ! interface async 0/0 ! line vty 0 5 login password 7 wAVcXxom8sGSOA ! ip route 0.0.0.0 0.0.0.0 10.0.0.2 ! access-list 100 permit ip 192.168.99.0 0.0.0.255 192.168.98.0 0.0.0.255 ! end ERT_805# 13
Resumo do conteúdo contido na página número 18
Chapter 4 Router Communication Protocol 4.1 RIP- Router Information Protocol The routing information Protocol (RIP) is a distance-vector protocol that used to exchange routing information between routers. RIP uses broadcast User Datagram Protocol (UDP) data packets to exchange routing information and rip is based on distance-vector algorithm. This routing protocol is determines the best path through an Internet by looking at the number of hops between the two end nodes. The maximum hops c
Resumo do conteúdo contido na página número 19
convergence. Whenever a router changes the metric of a route, it is required to send update messages almost immediately 4.1.1.5 RIP Command router rip – enable rip in global configuration mode version - To specify a RIP version used globally by the router (version 1 and 2) auto-summary – enable automatic network number summarization. Network – Enable routing on an IP network Neighbor – specify a neighbor router Bind-interface – Enable RIP protocol on some interface Default-metric – se
Resumo do conteúdo contido na página número 20
Building configuration ... description fault service password-encryption service timestamps debug ! hostname ERT_805 ! enable password 7 3EDRIxtqRWCA ! username router password 7 65WeJR6evnrR3mP crypto ipsec transform-set transform-1 esp-3des esp-md5-hmac ! crypto map dynmap 1 ipsec-isakmp set transform-set transform-1 set peer 10.0.0.2 match address 100 ! crypto isakmp policy 1 authentication pre-share group 1 hash md5 ! crypto isakmp key 12345678 address 10.0.
