Resumo do conteúdo contido na página número 1
Ffirm
Atlas5010™
Point-to-Point
Wireless Ethernet Bridge
USER MANUAL
June, 2007
Revision 3.0
Resumo do conteúdo contido na página número 2
Preface FCC Information Table of Contents Preface...................................................................................................................................................................iv FCC Information .......................................................................................................iv Warranty Information ...............................................................................................iv Contact Information..................
Resumo do conteúdo contido na página número 3
Preface FCC Information Upgrade Procedure................................................................................................. 32 Example 1 Upgrade main image firmware to 1.0a6.................................................. 33 Example 2 Upgrade web firmware to 1.0a6 ............................................................. 33 Appendix A Using the HTTP Interface.........................................................................................................34 C
Resumo do conteúdo contido na página número 4
Preface FCC Information Preface This manual covers the basic configuration and installation of the Atlas5010 Wireless Point to Point Broadband System, and applies to the following radio part numbers: P5010M-INT Unit with internal patch antenna P5010M-EXT Unit with external antenna connectors The Atlas5010-INT consists of two P5010M-INT radios which have internal 23 dBi antennas. The Atlas5010-EXT consists of two P5010M-EXT, and must be used in conjunction with an FCC certified e
Resumo do conteúdo contido na página número 5
Preface Contact Information Contact Information Corporate Headquarters Trango Broadband Wireless, a division of Trango Systems, Inc. 15070 Avenue of Science Suite 200 San Diego, CA 92128 USA Web Sites www.trangobroadband.com www.trangosys.com Sales Inquiries email: sales@trangobroadband.com Telephone: 1-858-653-3900 Technical Support email: techsupport@trangobroadband.com Telephone: 1-858-653-3900 Firmware Update Notices Mailing List http://www.trangobroadband.com/mailinglist/m
Resumo do conteúdo contido na página número 6
Overview OFDM Chapter 1 Overview The Atlas5010 is a point-to-point (PtP) wireless Ethernet transmission system which provides network connectivity at speeds up to 45 Mbps depending on the transmission distance and noise floor. The Atlas5010 utilizes OFDM technology and is designed for use in long range backhaul and wide area data networking applications. Users are required to simply specify one P5010M (INT or EXT) unit type as master unit (MU) and one unit as remote unit (RU). Ea
Resumo do conteúdo contido na página número 7
Overview Range vs. Throughput Range vs. Throughput The following table shows approximate maximum ranges (at recommended fade margins) achievable with the Atlas5010 system using various antenna configurations. Longer ranges are achievable, but will result in lower fade margins. To estimate theoretical throughput and fade margin for any distance, download the link budget / fade margin calculator tool . from www.trangobroadband.com ISM (5725 MHz to 5875 MHz) Line-of-Sight Range & Th
Resumo do conteúdo contido na página número 8
Overview System Contents System Contents The Atlas5010 system is available in two versions: Atlas5010-INT - Radios with integrated 23 dBi antennas (part numbers P5010-INT) Atlas5010-EXT - Connectorized radios (part numbers P5010-EXT) Each Atlas5010 kit consists of two radios, two power-over-Ethernet (PoE) injectors, two AC adapters, port covers, and mounting hardware. A dual-polarized integrated antenna is located behind the radome of the P5010M-INT. 2X Radio w/ Internal Ant
Resumo do conteúdo contido na página número 9
Overview Location of Serial Number & MAC Address Location of Serial Number & MAC Address The serial number and MAC address label can be found on the back of each radio. The serial number and MAC address is also provided within the system information (sysinfo) screen. Trango Broadband Wireless P5010M- INT Rev. A S/N: 000001420 MAC: 00 01 DE 00 02 F2 FCC ID: NCYP5010M Canada: XXXXXXXXXX THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES: OPERATION IS SUBJ
Resumo do conteúdo contido na página número 10
Getting Started Connections and Power Chapter 2 Getting Started It is always a good idea to first provision and test the radios on the bench before deploying them in the field. This is a particularly useful exercise for the novice user. Connections and Power • Connect a Cat-5 (straight through) Ethernet cable (we recommend shielded twisted pair) between the ODU (out door unit) port of the J-box and the RJ-45 connector on the radio. Note that this cable will carry power-over- Ethernet
Resumo do conteúdo contido na página número 11
Getting Started Configuration Tools Configuration Tools Atlas5010 radios can be configured using either the Command Line Interface (CLI), or the Web Browser (HTTP) interface. The CLI method provides slightly more functionality. This text covers configuration through the CLI. For HTTP configuration please see Appendix A. Telnet Open a command prompt (DOS) session on your PC. Open a Telnet session by typing: telnet Example: C:>telnet 192.168.100.100
Resumo do conteúdo contido na página número 12
Getting Started Troubleshooting Ethernet Connections Troubleshooting Ethernet Connections If you cannot telnet into the radio or open an HTTP browser session, check your cable connections to ensure proper use of cross-over vs. straight-through cable, and ensure your PC’s subnet is routable to the radio’s IP address. System Information (sysinfo) Page To display system configuration and status information type the command sysinfo. The sysinfo screen is divided into 7 sections (0 –7)
Resumo do conteúdo contido na página número 13
Getting Started System Information (sysinfo) Page Sysinfo Example: #> sysinfo ********************************* 0 ********************************* [Model] P5010M [Unit Type] MU [Hardware Version] 5010 [Firmware Version] 3p0r1D07061901 [System Up Time] 1 day(s) 21:52:14 ********************************* 1 ********************************* [MAC] 00 01 DE FF FF F3 [S/N] 16777203 [IP] 10.8.2.138 [Subnet Mask] 255.255.255.224 [Gateway] 10.8.2.129 ************************
Resumo do conteúdo contido na página número 14
Getting Started System Information (sysinfo) Page [Eth In] 55,256,030 bytes 24 Kbps [Eth Out] 3,348,202 bytes 3 Kbps [RF In] 1,377,125 bytes 0 Kbps [RF Out] 45,499,374 bytes 44 Kbps [ARQ Retransmission] 881 pkts Success. #> To view only a particular section of the sysinfo screen, type sysinfo followed by the desired section number. Example: #> sysinfo 2 ********************************* 2 ********************************* [Radio Temp] 32 C [PoE Voltage] 14.2 V [
Resumo do conteúdo contido na página número 15
Getting Started System Information (sysinfo) Page Section 3 Channel Table: (MHz, n/a: not available in current area) [Ch#01] 5700 n/a [Ch#02] 5700 n/a [Ch#03] 5700 n/a [Ch#04] 5700 n/a [Ch#05] 5700 n/a [Ch#06] 5700 n/a [Ch#07] 5700 n/a [Ch#08] 5700 n/a [Ch#09] 5700 n/a [Ch#10] 5700 n/a [Ch#11] 5700 n/a [Ch#12] 5700 n/a [Ch#13] 5700 n/a [Ch#14] 5700 n/a [Ch#15] 5700 n/a [Ch#16] 5700 n/a [Ch#17] 5700 n/a [Ch#18] 5840 n/a [Ch#19] 5735 [Ch#20] 5755 [Ch#21] 5775 [Ch
Resumo do conteúdo contido na página número 16
Configuration Key Concepts Chapter 3 Configuration Key Concepts Prior to configuring the radios it is important to understand several key concepts: Master Unit (MU) The MU is typically considered the primary radio within the link. For management purposes it is recommended to install the MU closest to the head-end of the network. Remote Unit (RU) The RU is typically installed at the remote end of the link. The primary distinction between the MU and RU is that when the radios ar
Resumo do conteúdo contido na página número 17
Configuration Remote Unit Configuration 2. Set the Peer ID with the MAC address of the RU. Only use the last 8 digits of the MAC address. #> peerid de1B7850 Success. #> 3. Set channel and polarization. (in this example set the channel to 2 and polarization to H). #> freq 20 v Ch# 20 v (5775 MHz) Success. 4. Set default Opmode to ON. #> defaultopmode on Success. 5. Turn Opmode ON. #> opmode on Success. . Remote Unit Configuration Configure the RU in the same manner a
Resumo do conteúdo contido na página número 18
Configuration Changing IP Address [Speed] 54 Mbps [Tx Power] 17 dBm [Power Range] -4..17 dBm [Peer ID] DE1B7747 [Status] connected [RSSI] -44 dBm [Peer IP Config] 10.8.2.139 255.255.255.224 10.8.2.129 Success. The [status] field indicates whether the MU and RU are connected or disconnected. If connected, the MU and RU will automatically start passing Ethernet traffic over the wireless link. Changing IP Address Use the ipconfig command to change the radio’s ip address, subnet mask
Resumo do conteúdo contido na página número 19
Configuration RF Link Loopback Test (linktest command) In addition, these 4 LEDs shall flash ON for 2 seconds, then OFF for 2 seconds to indicate the 'factory reset' button has been activated and the reset successful. ASSOCiation LED (green): The ASSOC led blinks at the following rates: - Once every second when unit is powered on but opmode is OFF. - Twice per second while in opmode ON and scanning for an MU or RU. - Solid after unit is associated with the RU or MU. RF Link L
Resumo do conteúdo contido na página número 20
Configuration Link Speed & Power Settings Link Speed & Power Settings Users may change the radio’s over-the-air data rate and conducted output power using the speed and power commands. Keep in mind that the lower data rates offer higher receiver sensitivity and higher allowable conducted RF power in the ISM band. The following table shows the relation between speed settings, modulation scheme, receiver sensitivity, and allowable maximum power settings for each band. The lowest power s
