Manual do usuário Cisco Systems RV082

Resumo do conteúdo contido na página número 1

Connect the Router Configure the Router
1 2
®
A Division of Cisco Systems, Inc.
A Before you begin, make sure In Step 2, you will need the setup
E Connect the included AC
that all of your hardware is power cable to the Router’s instructions provided by your Inter-
powered off, including the net Service Provider (ISP). If you do
Power port on the back of the
Router, PCs, hubs, switches, not have this information, then con-
Router, as shown in Figure E,
and cable or DSL modem. tact your ISP b

Resumo do conteúdo contido na página número 2

tinue with the instruction, dynamic IP address from your the Internet, then select PPPoE H Power your cable or DSL below, to complete the Net- ISP, then select Obtain an IP as the WAN Connection Type. modem off and back on work page. automatically as the WAN again. Connection Type. If you also b Enter the User Name and Pass- D Depending on the setup infor- select Use the Following DNS word provided by your ISP. I Restart or power on your PCs so mation from your ISP, you may Server Addresses,