Resumo do conteúdo contido na página número 1
® ™
Hotwire 8620 GranDSLAM
Installation Guide
Document No. 8620-A2-GN20-40
July 2003
Resumo do conteúdo contido na página número 2
Copyright © 2003 Paradyne Corporation. All rights reserved. Printed in U.S.A. Notice This publication is protected by federal copyright law. No part of this publication may be copied or distributed, transmitted, transcribed, stored in a retrieval system, or translated into any human or computer language in any form or by any means, electronic, mechanical, magnetic, manual or otherwise, or disclosed to third parties without the express written permission of Paradyne Corporation, 8545 126th Ave
Resumo do conteúdo contido na página número 3
! Important Safety Instructions 1. Read and follow all warning notices and instructions marked on the product or included in the manual. 2. The AC product version is intended to be used with a 3-wire grounding type plug — a plug which has a grounding pin. This is a safety feature. Equipment grounding is vital to ensure safe operation. Do not defeat the purpose of the grounding type plug by modifying the plug or using an adapter. Prior to installation, use an outlet tester or a voltmeter to ch
Resumo do conteúdo contido na página número 4
12. In addition, if the equipment is to be used with telecommunications circuits, take the following precautions: — Never install telephone wiring during a lightning storm. — Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations. — Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface. — Use caution when installing or modifying telephone lines. — Avoid using a telephone (o
Resumo do conteúdo contido na página número 5
Notice to Users of the Canadian Telephone Network The Industry Canada label identifies certified equipment. This certification means that the equipment meets telecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal Equipment Technical Requirements document(s). The Department does not guarantee the equipment will operate to the user’s satisfaction. Before installing this equipment, users should ensure that it is permissible to be con
Resumo do conteúdo contido na página número 6
E July 2003 8620-A2-GN20-40
Resumo do conteúdo contido na página número 7
Contents About This Guide Document Purpose and Intended Audience . . . . . . . . . . . . . . . . . . . . iii New Features for this Release. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . iii Document Summary . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . iii Product-Related Documents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . iv 1 Introduction The Hotwire 8620 GranDSLAM . . . . . . . . . . . . . . . . . . . . . . . . . . .
Resumo do conteúdo contido na página número 8
Contents 3 Cabling Making Cable Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1 Installing Network Tip and Ring Connections . . . . . . . . . . . . . . . . . . . 3-2 Connecting a DSL Card Using Cable Ties . . . . . . . . . . . . . . . . . . 3-3 Connecting a DSL Card Using Locking Pivot Brackets . . . . . . . . . 3-4 Connecting an SCP Card to a Terminal or PC . . . . . . . . . . . . . . . . . . 3-5 Connecting an SCP Card to an SNMP Management System . .
Resumo do conteúdo contido na página número 9
About This Guide Document Purpose and Intended Audience This guide is written for administrators and technicians who install devices at the central office (CO) or at a Network Service Provider (NSP) location adjacent to the CO. It should be used in conjunction with the appropriate Hotwire DSL Card User’s Guide. To install the customer premises portion of the Hotwire 8620 GranDSLAM, refer to the appropriate Hotwire Remote Termination Unit (RTU) Customer Premises Installation Instructions and
Resumo do conteúdo contido na página número 10
About This Guide Section Description Appendix B, Technical Lists Technical Specifications for the Hotwire 8620 Specifications GranDSLAM. Glossary Defines terms and acronyms used in this document. Index Lists key terms, concepts, and sections in alphabetical order. A master glossary of terms and acronyms used in Paradyne documents is available online at www.paradyne.com. Select Support → Technical Manuals → Technical Glossary. Product-Related Documents Complete documentation for this product
Resumo do conteúdo contido na página número 11
About This Guide Document Number Document Title 8700-A2-GB20 Hotwire TDM SDSL Termination Units, Models 8777 and 8779, User’s Guide 8700-A2-GN10 Hotwire TDM SDSL Termination Units, Models 8777 and 8779, Installation Instructions 8700-A2-GN15 Hotwire TDM SDSL Termination Units, Models 8775 and 8785, Installation Instructions 8774-A2-GB20 Hotwire 8774 TDM SDSL Termination Unit, with DSX-1 Interface, User’s Guide 8774-A2-GZ40 Hotwire 8774 TDM SDSL Termination Unit, with DSX-1 Interface, Instal
Resumo do conteúdo contido na página número 12
About This Guide vi July 2003 8620-A2-GN20-40
Resumo do conteúdo contido na página número 13
Introduction 1 The Hotwire 8620 GranDSLAM ® ™ The Hotwire 8620 GranDSLAM , which is designed to be installed in an Internet Service Provider (ISP) or Network Access Provider (NAP) location, is a low-startup-cost alternative chassis to the Hotwire 8820 GranDSLAM chassis. The 8620 GranDSLAM can also be placed in a Remote Terminal (RT) adjacent to the Telco’s Digital Loop Carrier (DLC) systems. It provides high-speed Internet or intranet access. The System Interface Module (SIM) is shipped wit
Resumo do conteúdo contido na página número 14
1. Introduction Central Office (CO) Customer Premises (CP) Data Interface Network Service ATM Provider SCP Card SN DSL POTS/DSL Card MDF CO POTS GranDSLAM Voice POTS Interface Splitter CP POTS Splitter Switched Network Optional Optional Legend: DSL – Digital Subscriber Line SN – Service Node MDF – Main Distribution Frame POTS – Plain Old Telephone Service 03-17428 Hotwire 8620 GranDSLAM Cards The GranDSLAM chassis accepts the following types of cards: SCP card Provides aggregation of DSL traff
Resumo do conteúdo contido na página número 15
1. Introduction DSL cards Provide a processor and an Ethernet or ATM interface to the NSP. The processor controls the modems and forwards the packet traffic to and from the Ethernet, ATM and DSL interfaces. Models include: — 8303 24-port Integrated Services Digital Network (ISDN) Digital Subscriber Line (IDSL) card that interoperates with the 6301 and 6302 IDSL Routers. — 8304 24-port Packet IDSL 2B1Q card with ATM uplink that interoperates with the 6301 and 6302 IDSL Routers. — 8312 12-p
Resumo do conteúdo contido na página número 16
1. Introduction Table 1-1 shows which DSL cards can be used with the different SCP card, MCP, and SCM configurations. Table 1-1. DSL Card Interoperability SCP Card SCP Card and MCP SCM and MCP 8955 8775 8303 8965 8777 8304 8985 8779 8312 8799 8314 8335 8343 8344 8355 8365 8373 8374 8385 8777 8779 8799 Hotwire 8620 GranDSLAM Features The Hotwire 8620 GranDSLAM chassis has the following features: AC and DC Powered Models Two versions of the Hotwire 8620 GranDSLAM chassis are available: — AC p
Resumo do conteúdo contido na página número 17
1. Introduction Hotwire 8620 GranDSLAM Components 3 ESD 2 1 A -48V RTN DC FUSES ALARMS ALARM AB CLOCK SCM SERIAL MCP SCM LAN MCP B A M M SIM A I DC SIM F J N POWER A O O AB N R R AB A B AC INPUT 03-17429 The Hotwire 8620 GranDSLAM is a 4-slot chassis designed to house one of the following combinations: One SCP card and up to three DSL cards One SCP card, one MCP card, and up to two DSL cards One MCP card, one SCM card, and up to two DSL cards. Before installing the Hotwire 8620 GranDS
Resumo do conteúdo contido na página número 18
1. Introduction 1-6 July 2003 8620-A2-GN20-40
Resumo do conteúdo contido na página número 19
Installation 2 Preinstallation Considerations Consider the following before performing installation of the Hotwire 8620 GranDSLAM chassis: Installation Site Your installation site should be well ventilated, clean, and free of environmental extremes. If you are installing the Hotwire 8620 GranDSLAM chassis in a central office (CO) rack, make sure there is a clearance of 2 to 3 feet at the front of the rack to allow access for the installation of the chassis, circuit cards, and cables. If
Resumo do conteúdo contido na página número 20
2. Installation Cabling Use only CAT3 or better twisted-pair network connection cables for DSL Termination Unit connections and interface patch cabling. Untwisted analog cables of any length anywhere in the loop substantially contribute to crosstalk and reduced loop reach. The following customer-provided cables and cable adapters are required with this product: — Plug-ended Telco 50-pin cable for connection from the Hotwire 8620 GranDSLAM Line ports to the CO POTS splitter shelf or MDF,
