Manual do usuário Silicon Laboratories Debug Adapter

Resumo do conteúdo contido na página número 1

ToolStick Debug Adapter
TOOLSTICK DEBUG ADAPTER USER’S GUIDE
1. Handling Recommendations
To enable development, the ToolStick Base Adapter and daughter cards are distributed without any protective
plastics. To prevent damage to the devices and/or the host PC, please take into consideration the following
recommendations when using the ToolStick:
Never connect or disconnect a daughter card to or from the ToolStick Base Adapter while the Base Adapter is
connected to a PC.
Always connect and dis

Resumo do conteúdo contido na página número 2

ToolStick Debug Adapter 2. Contents The ToolStick Debug Adapter package contains the following items: ToolStick Debug Adapter (USB to Debug Interface) 7” Ribbon Cable Note: The ToolStick Debug Adapter requires a ToolStick Base Adapter for proper operation. 3. ToolStick Debug Adapter Specifications The ToolStick Debug Adapter, in conjunction with a ToolStick Base Adapter, provides the interface between the PC’s USB port and the target device’s in-system debug/programming circuitry. The 10-pin

Resumo do conteúdo contido na página número 3

ToolStick Debug Adapter 4. Hardware Setup using a ToolStick Debug Adapter Configure the ToolStick Debug Adapter 1. Place the jumper J1 in the appropriate position for the I/O voltage of the Target Board being used. Connect pins 1 and 2 (V and V ) for 2.5 V I/O or connect pins 2 and 3 (V and V ) for 3.3 V I/O. REG IO DD IO 2. If the Target Board will be powered from the ToolStick Debug Adapter, place a jumper on header J2. If the Target Board will be separately powered, ensure that no jumper i

Resumo do conteúdo contido na página número 4

ToolStick Debug Adapter 5. Software Setup using a ToolStick Debug Adapter The Silicon Laboratories Integrated Development Environment (IDE), along with other software tools, are provided for device development and debugging. The IDE is available for download from the Silicon Laboratories website and is also available on microcontroller development kit CD-ROMs. Once the IDE has been installed and the hard- ware has been connected as shown in Section 4, follow the steps below to built a project,

Resumo do conteúdo contido na página número 5

ToolStick Debug Adapter 6. ToolStick Debug Adaper Schematic Rev. 0.1 5

Resumo do conteúdo contido na página número 6

ToolStick Debug Adapter CONTACT INFORMATION Silicon Laboratories Inc. 400 West Cesar Chavez Austin, TX 78701 Tel: 1+(512) 416-8500 Fax: 1+(512) 416-9669 Toll Free: 1+(877) 444-3032 Email: MCUinfo@silabs.com Internet: www.silabs.com The information in this document is believed to be accurate in all respects at the time of publication but is subject to change without notice. Silicon Laboratories assumes no responsibility for errors and omissions, and disclaims responsibility for any consequences