Manual do usuário Renesas Single-Chip Microcomputer H8SX/1622

Resumo do conteúdo contido na página número 1

1. Installation
Do not connect the E10A debugger hardware until the software support has been installed.
1. Insert the CD into your computer’s CD-ROM drive. The CD should automatically run the installation program. If the installer does not start, browse to the CD root
folder and double click on ‘setup.exe’.
2. The installer will ask you which language is to be used, please choose the appropriate one.
3. On the first screen of the installer proper, click .
4. The Li

Resumo do conteúdo contido na página número 2

2. Connection 11. Fit the LCD module to the LCD connector on the RSK, so it lies above J3. Ensure all the pins of the connector are correctly inserted in the socket. 12. Now connect the E10A to E10A header on the RSK using the ribbon cable. 13. Connect the E10A debugger to a spare USB port. Fit ‘J5’ jumper. Connect external power supply to RSK board (5 Volts) at PWR_D connector, ensure the polarity is correct! The ‘Found New Hardware’ Wizard will appear. Please follow the steps below to inst

Resumo do conteúdo contido na página número 3

35. The ‘System Clock’ dialog will be shown, enter ‘12’ MHz and click . 36. The ‘ID code’ dialog box will appear, enter “0000E10A” for the ID code and check the “New ID code” tick-box and click . 37. Right click on the download module listed in the left hand pane and select ‘Download’. The code will be downloaded to the microcontroller. This may take several seconds. 38. Click the button. The code will run and you will see the LEDs flash on the boa