Resumo do conteúdo contido na página número 1
SpeedTouch™516
Residential ADSL Gateway
User’s Guide
Release R5.3.1
Resumo do conteúdo contido na página número 2
Resumo do conteúdo contido na página número 3
SpeedTouch™ 516 User’s Guide R5.3.1
Resumo do conteúdo contido na página número 4
Copyright Copyright ©1999-2005 THOMSON. All rights reserved. Passing on, and copying of this document, use and communication of its contents is not permitted without written authorization from THOMSON. The content of this document is furnished for informational use only, may be subject to change without notice, and should not be construed as a commitment by THOMSON. THOMSON assumes no responsibility or liability for any errors or inaccuracies that may appear in this document. Thomson Telecom
Resumo do conteúdo contido na página número 5
Contents Contents About this User’s Guide .............................................. 1 1 Your SpeedTouch™......................................................3 1.1 SpeedTouch™ Features.................................................................. 4 1.1.1 Hardware Specifications.................................................................................. 5 1.1.2 Software Features .......................................................................................... 6 1.2 SpeedTo
Resumo do conteúdo contido na página número 6
Contents 4.1 Navigation.................................................................................... 32 4.1.1 Menu.......................................................................................................... 33 4.1.2 Language Bar............................................................................................... 34 4.1.3 Navigation Bar ............................................................................................. 35 4.1.4 Notification Area ..........
Resumo do conteúdo contido na página número 7
Contents 4.6 Home Network ............................................................................. 73 4.6.1 Devices....................................................................................................... 74 4.6.2 Device Settings............................................................................................ 75 4.6.3 Assign Public IP ........................................................................................... 76 4.6.4 Interfaces......................
Resumo do conteúdo contido na página número 8
Contents E-DOC-CTC-20050429-0098 v1.0 iv
Resumo do conteúdo contido na página número 9
About this User’s Guide About this User’s Guide Used Symbols A note provides additional information about a topic. A tip provides an alternative method or shortcut to perform an action. A caution warns you about potential problems or specific precautions that ! need to be taken. Terminology Generally, the SpeedTouch™516(i) will be referred to as SpeedTouch™ in this User’s Guide. Typographical In interactive input and output, typed input is displayed in a bold font and commands are displayed l
Resumo do conteúdo contido na página número 10
About this User’s Guide E-DOC-CTC-20050429-0098 v1.0 2
Resumo do conteúdo contido na página número 11
Chapter 1 Your SpeedTouch™ 1 Your SpeedTouch™ Introduction With the SpeedTouch™516(i) Residential ADSL Gateway you can surf the Internet at high speed. Installation For more information on how to set up your SpeedTouch™, installation and wiring and how to do a first Internet connection setup, refer to the provided Installation and Setup Guide. Contents This User’s Guide will assist you in configuring your SpeedTouch™. Safety instructions Before connecting the SpeedTouch™, please read the Spe
Resumo do conteúdo contido na página número 12
Chapter 1 Your SpeedTouch™ 1.1 SpeedTouch™ Features Introduction Your SpeedTouch™ offers you a wide range of outstanding features. In this section you will find a comprehensive overview of the: Hardware Specifications Software Features E-DOC-CTC-20050429-0098 v1.0 4
Resumo do conteúdo contido na página número 13
Chapter 1 Your SpeedTouch™ 1.1.1 Hardware Specifications Gateway Integrated multi-mode ADSL modem, supporting: ADSL over POTS for a SpeedTouch™ADSL/POTS variant) ADSL over ISDN for a SpeedTouch™ ADSL/ISDN variant) ADSL/RE-ADLS2/ADSL2/ADSL2+ for both ADSL over POTS and ADSL over ISDN Physical interfaces WAN: One RJ-11 port for ADSL/POTS or ADSL/ISDN connection LAN: A single RJ-45 port for Ethernet connection (10/100Base-T) Power inlet LEDs LED indicators for all interfaces Reset button One
Resumo do conteúdo contido na página número 14
Chapter 1 Your SpeedTouch™ 1.1.2 Software Features ADSL compliance If POTS in overlay: G. handshake, Full Rate ADSL, G.dmt, G.lite (splitterless ADSL), ADSL2, RE-ADSL and ADSL2+ If ISDN in overlay: G.handshake, G.dmt, ADSL2, RE-ADSL and ADSL2+ ATM features Up to 16 simultaneous PVCs, allowing multiple simultaneous destinations ATM QoS per PVC: CBR, VBR-rt, VBR-nrt, UBR RFC 1483 / 2684 multiprotocol encapsulation over AAL5 / ATM: both LLC / SNAP and VC-based multiplexing supported Bridging
Resumo do conteúdo contido na página número 15
Chapter 1 Your SpeedTouch™ Management Multi-level user protection, Event logging DHCP server, client and relay, DHCP-to-PPP spoofing DNS server, client and relay Time synchronization: SNTPv1, SNTPv2, SNTPv3 and SNTPv4 System logging SNMPv1 agent with MIB-II Firmware upgradeable via upgrade wizard on Setup CD E-DOC-CTC-20050429-0098 v1.0 7
Resumo do conteúdo contido na página número 16
Internet DSL Ethernet Power Chapter 1 Your SpeedTouch™ 1.2 SpeedTouch™ LED Behaviour Front panel LEDs The SpeedTouch™ is equipped with a number of LEDs on its front panel, indicating the state of the device during normal operation. Following table shows the meaning of the different LEDs: Indicator Description Name Colour State Power Green On Power on, normal operation Red On Power on, self-test failed, indicating device malfunction Orange On Bootloader active Off Power off Ethernet Green Fl
Resumo do conteúdo contido na página número 17
Chapter 1 Your SpeedTouch™ 1.3 How to Access your SpeedTouch™ Access methods Your SpeedTouch™ is accessible in one of following ways: Access Method Can be used to: Web Configure your SpeedTouch™ via HTTP or HTTPS. For more information, see “1.3.1 Access via the Web Interface” on page 10. Command Line Interface (CLI) Fine tune your SpeedTouch™ configuration. For more information, see “1.3.2 Access via CLI” on page 11. File Transfer Protocol (FTP) Backup and restore data on your SpeedTouch™. F
Resumo do conteúdo contido na página número 18
Chapter 1 Your SpeedTouch™ 1.3.1 Access via the Web Interface Procedure To access the SpeedTouch™ via the web interface: 1 Open a web browser. 2 In the address bar type your SpeedTouch™’s IP address or DNS host name, by default that is ‘http://speedtouch.lan’ or ‘192.168.1.254’. You can access the pages via the http protocol. For remote assistance the secure version, https, in combination with certificates is used; provide your ISP with the https link, user name and password before he can lo
Resumo do conteúdo contido na página número 19
Chapter 1 Your SpeedTouch™ 1.3.2 Access via CLI Command Line You can access the Command Line Interface (CLI) via: Interface (CLI) A Telnet session This requires that TCP/IP connectivity exists between the host from which the Telnet session is opened and the SpeedTouch™. Your SpeedTouch™ and the connected PC must have an IP address in the same subnet. Quote site commands (over FTP) For more information, see “ Quote site command” on page 15. For information on CLI commands, see the SpeedTouch™
Resumo do conteúdo contido na página número 20
Chapter 1 Your SpeedTouch™ Telnet session Proceed as follows: 1 Open a telnet application. You can use the Command Prompt window. In Windows XP for instance: 1 On the Windows task bar, click Start. 2 Select (All) Programs > Accessories > Command Prompt. 2 Connect to your SpeedTouch™. . In the Command Prompt window: At the prompt, type telnet followed by the IP address of your SpeedTouch™ (default is 192.168.1.254). 3 Enter your SpeedTouch™ security user name and password. The default user i
