Manual do usuário Blue Sea Systems PN9010

Resumo do conteúdo contido na página número 1

W ARNING
Marine Electrical Products
] These instructions are intended to provide assistance with the
AC Rotary Switch
installation of this product, and are not a substitute for a more
comprehensive understanding of electrical systems. We strongly
3 Positions + OFF, 2 Pole
recommend that a competent electrical professional perform the
installation of this product.
PN 9010 ] If either the switch front or back is to be exposed to water it must be
Features protected with a wat

Resumo do conteúdo contido na página número 2

Installation (continued) It is possible to verify most connections using an ohmmeter before ] T est Shore Power power is applied. These procedures take a little time, but are Connect the shore power cable to the shore power source. Turn recommended, especially if some elements of a previous installation on the shore source to make power available to the boat. might not have been clearly or correctly labeled or follow the expected a. Turn the selector switch to SHORE. No Reverse colo

Resumo do conteúdo contido na página número 3

Installation (continued) DOUBLE POLE CIRCUIT BREAKER FROM AC REQUIRED WITHIN TEN FEET OF HOT SHORE INLET BETWEEN AC SOURCE SELECTOR SWITCH AND SHORE POWER SOURCE FROM AC NEUTRAL 2 FROM AC HOT FROM AC SOURCE NEUTRAL FROM AC 3 HOT FROM AC SOURCE NEUTRAL 1 2 3 1 1 5 9 7 3 11 2 8 FROM AC FROM AC HOT NEUTRAL W iring Diagram AC Rotary Selector Switch PN 9010 Panel Mounting Hole Pattern PN 9010 Panel Mounting Assembly Page 3 of 3 6684 Rev 002