Manual do usuário LSI SCSI 320-2 Controller

Resumo do conteúdo contido na página número 1

Quick Hardware Setup Guide
®
Step Action
LSI Logic MegaRAID SCSI
8 Set SCSI termination.
320-2 Controller
9 Replace the computer cover and turn the power on.
10 Run the MegaRAID BIOS Configuration Utility.
11 Install the operating system driver.
Step 1: Unpack MegaRAID Controller
Unpack and install the MegaRAID SCSI 320-2 Controller in a static-free
environment. Remove the MegaRAID controller from the anti-static bag and
inspect it for damage. If it appears to be damaged, or if the Driver and

Resumo do conteúdo contido na página número 2

Quick Hardware Setup Guide Step 6: Connect SCSI Devices to MegaRAID Controller J4 J5 Internal High-Density Connect SCSI devices to the internal high-density 68-pin SCSI connectors SCSI Connectors J2 and/or the external very high-density 68-pin SCSI connectors. To achieve J3 maximum data throughput, use only Ultra320 SCSI devices. The MegaRAID Channel 0 Channel 1 SCSI 320-2 Controller supports up to 15 Ultra320 devices per channel at a maximum SCSI bus cable length of 12 m. You can also conne

Resumo do conteúdo contido na página número 3

Quick Hardware Setup Guide
RAID 5 (Disk striping with distributed parity): Data is striped across all External disks in the array. Part of the capacity of each disk is used to store parity SCSI Drives information that is used to reconstruct data if a disk fails. Provides good data throughput for applications with high read request rates. (3 to 15 disk ID 0 drives) ID 1
RAID 10 (RAID 1 and RAID 0 in spanned arrays): Uses mirrored pairs of disks to provide complete data redundancy. Provid