Manual do usuário Eicon Networks Dialogic D/480JCT-2T1-EW

Resumo do conteúdo contido na página número 1

®
The Dialogic D/480JCT-2T1-EW board has three when a jumper clip is installed over the indicated
manually configurable items: pins.
■
Board ID Note: Only the two boards at each end of the CT
Bus ribbon cable must have their terminations
■ CT Bus termination
enabled. All other boards must not have the
■
Remote loopback mode
jumper clips installed.
■ Power budgeting (see Choosing a Slot section
®
below)
Dialogic
Setting Remote Loopback Mode
Setting the Board ID ®
The Dialogic D/480JCT-2T1-

Resumo do conteúdo contido na página número 2

systems, or in nuclear facility applications. It is possible that 6. Connecting to External 8. Removing the Board ® the use or implementation of any one of the concepts, WARNING! Installing the Dialogic Equipment ® applications, or ideas described in this document, in marketing Removal of the Dialogic D/480JCT-2T1-EW board D/480JCT-2T1-EW board in a x1 slot with the collateral produced by or on web pages maintained by Dialogic is essentially the reverse of the installation Each RJ-48C ja