Manual do usuário Philips CD196

Resumo do conteúdo contido na página número 1

Register your product and get support at
www.philips.com/welcome
CD191
CD196
Quick start guide
Connect
1
Get started
2
Enjoy
3

Resumo do conteúdo contido na página número 2

Important safety instruction Connect 1 • Use only the power supply listed in the technical data. • Dispose of used batteries according to the instructions. (Refer Connect the base station • Do not allow the product to come into contact with liquids. to the user manual online) • Risk of explosion if battery is replaced by an incorrect type. 1 Connect each end of the power adapter to: • the DC input jack In call In idle mode In menu at the back of the Earpiece Speaker MENU/OK Enter the opt

Resumo do conteúdo contido na página número 3

Get started 2 Configure your phone Charge your phone 1 The batteries are pre-installed in the handset. Pull the battery tape off from the battery door before charging. Charge 8 hours 2 When using y our phone f or the fir st time , y ou see a w elcome message (country dependent). Place the handset on the base station to charge the handset. 3 Set the country and language if prompted. When the handset is placed correctly on the base station, you 4 Set the date and time. hear a docking sound.

Resumo do conteúdo contido na página número 4

Enjoy 3 Call Call log Record an announcement • To make a call, press and dial the phone number. 1 Press and select a record. (for CD196 only) • To answer a call, press when the phone rings. To make a call 1 Press MENU/OK > [Answ. Machine] > • To end a call, press . 2 Press . [Announcement], then press MENU/OK to confir m. Adjust the earpiece volume To view more details 2 Select [Answer only] or [Record also], then press 2 Press MENU/OK. MENU/OK to confir m. Press or to adjust the vol

Resumo do conteúdo contido na página número 5

Technical data Battery • HFR: 2 x AAA NiMH 1.2V Rechargeable 650mAh batteries • SANIK: 2 x AAA NiMH 1.2V Rechargeable 650mAh batteries Adapter Base and charger: • Philips: S003PB0600050: Input: 100-240V 50/60Hz 0.2A; Output: 6V 500mA • Philips: SSW-1920UK-2: Input: 100-240V 50/60Hz 0.2A; Output: 6V 500mA Note • Y ou can install a DSL (digital subscr iber line) filter to prevent noise and caller ID problems caused by the DSL interference. Note • Y ou can find the Declar ation of Conf

Resumo do conteúdo contido na página número 6

Frequently asked questions No signal bar displays on the screen. The handset on the charger does not charge. • The handset is out of range. Move it closer to the base station. • Ensure the batteries are inserted correctly. • If the handset displays [Unregistered], register your handset • Ensure the handset is placed properly on the charger. The (See the section on Register the handsets). battery icon animates when charging. • Ensure the docking tone setting is turned on. When the handset