Manual do usuário Amana MEW5527

Resumo do conteúdo contido na página número 1

MICROWAVE OVEN BUILT-IN TRIM KIT
INSTALLATION INSTRUCTIONS
Built-In Trim Kit Models UMTK27, UMTK30
UL listed for use over built-in electric ovens:
27 (68.6 cm): MEW5527, MEW6527
30 (76.2 cm): MEW5530, MEW6530, JJW8130DD, JJW8330DD, JJW9130DD, JJW9330DD
Table of Contents
MICROWAVE OVEN SAFETY........................................................... 1
INSTALLATION INSTRUCTIONS ..................................................... 2
Tools and Parts................................................

Resumo do conteúdo contido na página número 2

2 1 26⁷⁄₈" (68.3 cm)* 29³⁄₄" (75.6 cm)** 24" (61.0 cm) INSTALLATION INSTRUCTIONS Tools and Parts Minimum Cutout Dimensions Tools Needed 23³⁄₄" Gather the required tools and parts before starting installation. (60.3 cm) Read and follow the instructions provided with any tools listed here. 1⁹⁄₁₆" (4.0 cm) ■ Measuring tape ■ Drill ■ Pencil ■ 7/64" drill bit 25" (63.5 cm) A 16⁷⁄₈" ■ Phillips screwdriver ■ Tape (42.9 cm) Parts Supplied ¹¹⁄₁₆" (1.8 cm) 3" (7.6 cm) B A. Trim kit frame overhang Duct b

Resumo do conteúdo contido na página número 3

Electrical Requirements Microwave Oven Preparation 1. Unplug microwave oven before proceeding with installation. 2. Remove any loose items inside microwave oven. WARNING Duct Assembly 1. Remove 4 existing screws (2 on each side) from the microwave oven. The screws are located at the lower edge. These screws will be used in the next step. 2. Secure duct base to the microwave oven with the 4 existing Electrical Shock Hazard screws removed in Step 2. Plug into a grounded 3 prong outlet. Do not r

Resumo do conteúdo contido na página número 4

4. Install the 3/16" screw, and leave 1/8" (3.2 mm) to 3/16" NOTE: If Template 2 is missing or unusable, measure straight (4.7 mm) protruding from the cutout floor. up from upper end holes on bottom bracket, and mark the new holes at 12¹⁵⁄₁₆" (32.9 cm) and 15²¹⁄₃₂" (39.8 cm). Make sure the bottom bracket end holes and the new holes on each A side are plumb. ¹⁄₈" (3.2 mm) (min) B ³⁄₁₆" (4.7 mm) (max) C D D C TEMPLATE 2 D C C D 12¹⁵⁄₁₆" A. 3/16" screw (32.9 cm) B. Cutout floor 15²¹⁄₃₂" (39.