Resumo do conteúdo contido na página número 1
Panasonic
ng Instructions
Operati
Commercial
Microwave Ovens
Model NE-l0547
NE-l0247
please read these instructions completely.
Betore operating this oven,
Resumo do conteúdo contido na página número 2
TABLE OF CONTENTS EXPOSURE TO EXCESSIVE TO AVOID POSSIBLE PRECAUTIONS MICROWAVE ENERGY IMPORTANT SAFETY INSTRUCTIONS...............,..... Instructions..... Installation and Grounding Saietv Precautions ......6 How Does the Microwave Work? ...... Outline Diagram (NE-1 024T) How to Operate (NE-1024T) Outline Diagram (NE-'l 054T) How to Operate ( N E- 1 054T) Heating ....... .. ............10 .... . . Manual Single Stage Heating.............. A. ... ...... .. .. . ...'......10 3 Stage Heat
Resumo do conteúdo contido na página número 3
you or any other cooking device. is cooking device and you should use as much care as use with a stove Your microwave oven a to use this appliance, unless closely electric appiiance, basic safety precautions 9. Do not allow children When using this lollowed. includrng the following: supervised by an adult. should be '10. or Do not operate this appliance if it has a damaged cord reduce tne risk ot burns, etectric WARNING-To properly, damaged plug, if it is not working or if it has been p
Resumo do conteúdo contido na página número 4
Your Wiring Requirements Examine Oven 'L packing plugged into least a 15 AMP 120 Unpack oven, remove all material, and examine the The oven must be at OUTLET, oven for any damage such as dents, broken door latches or VOLT, 60 Hz GBOUNDED cracks in the door. Notify dealer immediately if oven is is it is the Where a standard two-prong outlet encountered, damaged. DO NOT install if oven is damaged. personal user to have it responsibility and obligation of the properly grounded replaced with a
Resumo do conteúdo contido na página número 5
Food General Use '1 1 . lt is better to UNDERHEAT RATHER THAN OVERHEAT . DO NOT tamper with or make any adjustments or repairs to panel foods. lf food is underheated, it can always be returned to door, control housing, satety interlock switches or any is nothrng part of the oven. Do NOT remove outer panel from the oven for further heating. li lood overheated, other heating times. Repairs should only be done by a qualified service can be done. Always start with minimum oven. person. 2. SMALL
Resumo do conteúdo contido na página número 6
Microwaves are a form of high frequency radio waves similar Absorption to those used by a radio including AM; FM and CB. They are, During heatlng, microwaves will be absorbed by tood. They however, much shorter than radio waves; approximately tive oenetrate to a deoth of about % to 1'l-inches. Microwave inches long. Electricity is converled into microwave energy by energy excites the molecules in the food (especially water, fat the magnetron tube. From the magnetron tube, microwave and suga
Resumo do conteúdo contido na página número 7
Control Panel I ,ziN- ml.!l ( l't ); .-:*-:- Il i=::: \l 'l .l I icl6 t&t --):t;^:'-' r ri.i D.! Q) z m @ '14.'Iffilo'.,0 r H-rrF r c'|racr(tr't rfl.s N) r IrJc..Fr r:a.tn i -1 !L,i.M5f.*o o @ Timer Oven Window \pj Control Panel Oven Lamp @ Door Lock System Splash Guard/Light Diffuser Saiety plugged grounded a boll will ring and the unit will tum 1 . Make sure unit is into a three-prong 120 V 6. When time has elapsed, circuit. otf. > Oven light turns otf. FOOD in 2. Open the door. PLACE CONT
Resumo do conteúdo contido na página número 8
NE-'10547 Control Panel (1) (see Digital Display Windov, below) (2) Pads iriemory (3) Por,v€r t.ercl Selec.tor Pad (4) PROG. Pad (s) STOP/RESET Pad (6) DOUBLE OUANTTTY (x 2) Pad (7) START Pad (8) ControlPanel (9) Door Safety Lock System ('10) Oven Window with Heawapor Film (Do Not Remg\€) (11) tamp Ol/En (12) Guard,/Light Oitluser \f Splash IJJ z (1 1) Digital Display Window Indicator Locations HI iI,HI MED LOW OEF HOLD POWER LEVEL - - A PBOG lndicator E Power Level Indicator - (x
Resumo do conteúdo contido na página número 9
Before Operating Vake sure the oven is connected to a properly groundgd outlet. electrical "0". lvren is is is the Display Window shows the door closed, the Display Window still blank. When the door opened, .cr page feature. the detail operation, see the on each preset This oven is at the factory for the following: ' preset Memory Pads are to High Power for the indicated heating times Jor single stage heating. - - 1 10 min. 30 sec. 6 1 sec. - 2 20 sec. 7-2min. - - 3 30 sec. 8 2 min.
Resumo do conteúdo contido na página número 10
HEATING "0" place Open the door and food in lhe oven cavity. Close the door. must be shor,ving in the Display Window. A. Manual Single Stage Heating: gives This fealure the user maximum llexibility to power set the oven to desired heating time and level. Ideal for menus that require various h€ating requirements. Example: To heat for 2 minutes at High Power Oisplay Window .Press 1. the POWER Level Selector PowER il I Pad one time. t l- l .Press q,- the Memory Pads 2, 0 and 0. E3 FTO] s
Resumo do conteúdo contido na página número 11
C. Programmed Heating: Example: 1 stage; Memory Pad I to heal tor 3 minutes at HIGH Power .Press 1. the Memory Pad 9. ln Program Lock Mode oven will start without pressing START page Pad. See 15. .Press ,@ the START Pad. Heating will start. The time in the Display Window will count down. .All 3. Beep tone will sound. heating will stop. When opening the door, the display will stop blinking. z Example: 2 stage; Memory Pad 3 (toheat for 3 minutes at HIGH and 2 minutes at DEFROST) m page prog
Resumo do conteúdo contido na página número 12
Programming Disolav Window - _ DO NOT OPEN THE DOOR The Display Window MUST be blank before programming can begin. lf any indicator light is l press illuminated in the digital Display Window: Close Pad and wait 1 the door, STOP/RESET tl minute until the Display Window goes blank. A. Programming Memory Pads for Stage Heating: Single program Example: To 30 seconds at Medium Power for Memory Pad Number 5 Disolay Window .Press the PFOG. Pad. NOTE: .lf no PROG Indicator appeared in the l "Pro
Resumo do conteúdo contido na página número 13
. NOTE: Program remaining the Memory Pads as desired by repeating steps 1-5. You may insert up to 10 memory Programs. . When the PROG indicator program pressing is blinking, the can be cancelled and/or the Pad erased by the STOP/RESET Pad. B. Programming Memory Pads for 2 or 3 Stage Heating: Example: To program Pad tor 2 minutes at DEFROST for 2 stage heaiing using Memory Number 5 Display Window ---l!99---l- 1. Complele 4 page Steps 1 to or 12. [-i0] '.""'. .Press POWER Level Selector Pad
Resumo do conteúdo contido na página número 14
- portion For multiple heating: Pad C. Programming the Double Quantity - is setting your programmed for multiple portion heating this the correct double thg time oven is lactory set to automatically for these lood items programming of the time is necessary most small foods items. No Iurther tor heating multipleportions of than double that ol a food loads is slightly less portions planers and most bulk iequired to heat multiple ot some large The time portion. single you customize
Resumo do conteúdo contido na página número 15
Other Features A. To Activate Program Lock: Disolav Window "Locks" procedure This the control panel Memory Pads into their programmed heating power times and levels. DO NOT OPEN THE DOOR. The Display Window must be blank before the Program Lock leature can be activated. .Press '@ and hold in the PBOG. Pad until the display shows 'P' "1". and (for 6 seconds) .Program feature is now Lock actrvated. z NOTE:.DonotpressPROG.Padlorlongerthan30secondscontinuously,orfalsefailurecodemayresult. m
Resumo do conteúdo contido na página número 16
C. To Read Program List: power level for eachstage. you programmed Pad Number, heating time and Allows to review all currently Displav window 1. Open the door. t-n--l ul I .While pressing Pad, the STOP/RESET , press and hold in the START Pad. F;;;I in The Beep Tone setting will show the + Display Window. 'l: Indicator Beep tone is ON Example; Stage I START I 2: BeeP tone is OFF Stage Indicator F 2 seconds later, the Program Lock s setting will show in the Display Window. "P Program Lo
Resumo do conteúdo contido na página número 17
D. To Select Beep Tone Options: The Display Window Beep Tone can be set. ON or OFF. 1. Open the door. .Press the PFOG. Pad. The display will not change. @ .Press the Memory Pad 0. ''- E "OFF" .Repeat pressing ol 0 Pad. Select of Beep Tone. @ -ON Stage lndicator l z m Stagelndicator2=OFF (t .Press the PROG. Pad again. 5 -.t You have completed programming l the beep tone. .2 seconds later, the Display Window will go blank. E. To Read the Cycle Counter: The oven can dispiay the total
Resumo do conteúdo contido na página número 18
This oven monitors its operation and displays Failure when problem a Code in the Display Window a occurs. Whal to do when a failure code appears: CODE CAUSE WHAT TO DO 'Overcooked 'Press F01 lood STOP/RESET Pad to stop beep. .Temperature 'Wait of exhaust high. for reset. air too oven to cooi down and 'lt flame is not a Dresent, do open oven door. 'lf normal operation does not resume, call the service agent with information of tailure code. 'Defective . F33-34 sensor circuit Unplug t
Resumo do conteúdo contido na página número 19
NE-10547 NE-10247 phase Power Source 120V,60 Hz, single Required Power 13.44 1500W Output' 1000 w Frequency 2,450 MNZ '12" Outer Dimensions x2O'/;' x 14'/;' (HxWxD) 306 mm x 510 mm x 360 mm Cavity Dimensions x 13' 8'l," 13'x (HxWxD) 205 mm x 330 mm x 330 mm Net (15.4 Approximately 34 lb kg) (17.7 Approximately 39 lbs kg) Timer 99 min 99 sec (Digital) minutes Rotary 6 x 10 Memory Pads with Double Quantity (x2) Pad .lEC 705-88 Test Procedure Specifications subject to change without notice.
Resumo do conteúdo contido na página número 20
PANASONIC CONSUMER ELECTONIC COMPANY COMPANY DIVISION OF MATSUSHITA ELECTRIC CORPORATION OF AMERICA One Panasonic Way,4A-4, Secaucus, NJ 07094 TooogopooAp )rinted 348-5377 in Taiwan {€01l
