Manual do usuário Revolabs Inc.XG-80

Resumo do conteúdo contido na página número 1

TM
Revolabs Fusion Microphone System — Sony XG-80 Setup Guide
This setup guide will guide you through the steps needed to properly connect a
Revolabs Fusion Microphone System to a Sony XG-80 video codec.

Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Fusion Microphone System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if

Resumo do conteúdo contido na página número 2

Connecting the Cables 1. Connect a Female XLR – 1/8” audio cable between the XLR “CONF OUT” port on the Fusion and the “MIC 1” port on the Sony XG-80. 2. Connect a Male RCA-RCA audio cable between the “CONF IN” port on the Fusion and the L “AUDIO OUT” port on the XG-80. 3. Connect a Male RCA audio cable between the “Room Out” port on the Fusion and the Amplified Speakers. 3 1 1 2 2 NOTE: You must use your Fusion remote control to control the room volume for both the audio and v

Resumo do conteúdo contido na página número 3

Configuring the Sony XG-80 Video Codec 1. Push the TOOLS button on the remote control 2. Select SETUP 3. Select AUDIO 1 4. Select AUDIO INPUT as MIC 5. Verify that Mic (A1/A3) has a checkmark 6. Turn ECHO CANCELLER to OFF 7. Verify INPUT as MONAURAL 8. Increase Sony volume level on remote to maximum NOTE: You must use your Fusion remote control to control the room volume for both the audio and video conference calls. Adjusting the volume in the video codec will cause echo.