Resumo do conteúdo contido na página número 1
OperatiOn and p arts Manual
series
plaster/MOrtar Mixer
MOdel wM45H
(Honda Gx160ut1Hx2 Gasoline engine)
MOdel wM45e
(1 Hp electric Motor)
Revision #0 (09/27/12)
To find the latest revision of this
publication, visit our website at:
www.multiquip.com
THIS MANUAL MUST ACCOMPANY THE EQUIPMENT AT ALL TIMES.
Resumo do conteúdo contido na página número 2
nOtes page 2 — WM45H/e pLaSTeR/MORT aR MIXeR • OpeRa TIOn and paRTS ManuaL — Rev. #0 (09/27/12)
Resumo do conteúdo contido na página número 3
silicOsis/respiratOry warninGs WARNING WARNING SILICOSIS WARNING RESPIRATORY HAZARDS Grinding/cutting/drillingofmasonry,concrete,metaland Grinding/cutting/drillingofmasonry,concrete,metaland othermaterialswithsilicaintheircompositionmaygive other materials can generate dust, mists and fumes off dust or mists containing crystalline silica. Silica is a containing chemicals known to cause serious or fatal basiccomponentofsand,quartz,brickclay,graniteand injury or illness, such as respiratory diseas
Resumo do conteúdo contido na página número 4
t able Of cOntents component drawings wM45H/wM45e plaster/ Nameplate and Decals Assembly ..................... 30-31 Mortar Mixer Steel Tub Assembly .......................................... 32-33 Silicosis/Respiratory Warnings ................................ 3 Paddle Shaft Assembly ..................................... 34-35 Table Of Contents .................................................... 4 Frame Assembly ............................................... 36-37 Parts Ordering Procedures ..
Resumo do conteúdo contido na página número 5
parts OrderinG prOcedures Ordering parts has never been easier! Choose from three easy options: Effective: st January 1 , 2006 Best Deal! Order via Internet (Dealers Only): If you have an MQ Account, to obtain a Username Order parts on-line using Multiquip’s SmartEquip website! and Password, E-mail us at: parts@multiquip. com. ■ View Parts Diagrams To obtain an MQ Account, contact your ■ Order Parts District Sales Manager for more information. ■ Print Specification Information Use the int
Resumo do conteúdo contido na página número 6
safety infOrMatiOn Do not operate or service the equipment before reading Potential hazards associated with the operation of this the entire manual. Safety precautions should be followed equipment will be referenced with hazard symbols which at all times when operating this equipment. may appear throughout this manual in conjunction with Failure to read and understand the safety safety messages. messages and operating instructions could Symbol Safety Hazard result in injury to yourself and o
Resumo do conteúdo contido na página número 7
safety infOrMatiOn geneRaL SaFeTY NOTICE CauTIOn This equipment should only be operated by trained and qualifi ed personnel 18 years of age and older. neveR operate this equipment without proper protective clothing, shatterproof glasses, respiratory protection, Whenever necessary, replace nameplate, operation and hearing protection, steel-toed boots and other protective safety decals when they become diffi cult read. devices required by the job or city and state regulations. Manu
Resumo do conteúdo contido na página número 8
safety infOrMatiOn MIXeR SaFeTY engIne SaFeTY dangeR dangeR neveR operate the equipment in an explosive Engine fuel exhaust gases contain poisonous carbon monoxide. This gas is colorless and odorless, and can atmosphere or near combustible materials. An explosion or fi re could result causing severe cause death if inhaled. bodily harm or even death. The engine of this equipment requires an adequate dO nOT mix fl ammable or explosive substances. free fl ow of cooling air. neveR ope
Resumo do conteúdo contido na página número 9
safety infOrMatiOn FueL SaFeTY TRanSpORTIng SaFeTY dangeR CauTIOn dO nOT add fuel to equipment if it is placed inside truck neveR allow any person or animal to stand underneath bed with plastic liner. Possibility exists of explosion or the equipment while lifting. fi re due to static electricity. NOTICE FUEL aLWaYS make sure forklift forks are inserted into pockets (if applicable) as far as possible when lifting the mixer. aLWaYS shutdown engine before transporting. neveR lift
Resumo do conteúdo contido na página número 10
specificatiOns Table 1. Mixer Specifications Capacity 4.5 cu. ft (127 liters) Bag Capacity 1-1/2 to 2-1/2 bags Weight 380 lbs. (172 kg.) Height W/Dump Handle 57.5 in. (146 cm.) Discharge Height 7.5 in. (19 cm.) Drive V-Belt/Gear Dump Action Manual Table 2. engine/electric Motor Specifications BaLdOR Model Honda gX160uT1HX2 35S772T980g1 Air-cooled 4 stroke, Single Cylinder, 1.0 HP 115/230 VAC Type OHV, Horizontal Shaft Gasoline Single-Phase, 60 Hz Engine Electric Motor 2.70 in. X 1.80 in.
Resumo do conteúdo contido na página número 11
diMensiOns A B C D Table 3. Mixer dimensions Reference designator dimension in. (cm.) A 57.5 (146) Figure 1. Dimensions B 74.0 (188) C 32.5 (82) D 29.0 (74) WM45H/e pLaSTeR MORT aR MIXeR • OpeRa TIOn and paRTS ManuaL — Rev. #0 (09/27/12) — page 11
Resumo do conteúdo contido na página número 12
General infOrMatiOn geneRaL gasoline engine Care The MQ Model WM45H and WM45E plaster and mortar For care and operation of the Honda engine, refer to the maintenance procedures in this manual and the engine mixers are shipped completely assembled and each mixer has been factory tested. manufacturer’s operating instructions furnished with the engine. We recommend draining and refilling the engine The drum batch capacity of these mixers is between 1.5 and crankcase at least every thirty hour
Resumo do conteúdo contido na página número 13
cOMpOnents Figure 2. Major Components Figure 2 illustrates the basic components and controls of the WM45H and WM45E mixer. 6. engine Cover — Lift this cover to gain access to the 1. Lifting Handle Bars — Use these handle bars to lift engine compartment. and maneuver the mixer. 7. Lifting Handle Bars (engine Side) — Use these 2. pivot point/Zerk Fitting — There is, on each end of fold-down handle bars to lift and maneuver the mixer. the mixing drum a zerk grease fitting. These fittings lubr
Resumo do conteúdo contido na página número 14
asic en b Gine Figure 3. Engine Controls and Components 6. Choke Lever — Used in the starting of a cold engine, InITIaL SeR vICIng or in cold weather conditions. The choke enriches the The engine (Figure 3) must be checked for proper fuel mixture. lubrication and filled with fuel prior to operation. Refer to 7. air Cleaner — Prevents dirt and other debris from the manufacturers engine manual for instructions and entering the fuel system. Remove wing-nut on top of details of operation and
Resumo do conteúdo contido na página número 15
electric MOtOr Figure 4. Single-Phase Electric Motor 18-Inch Pigtail Cable electric Motor electric Motor voltage Switch 1. a LWaYS make certain the electric motor switch For maintenance care and operation of the electric motor, refer to your electric motor instruction booklet furnished is "OFF" (Figure 4)and the power cord has been disconnected from the power source. with the motor. 2. Remove the voltage lock-out bolt. Change the position Protect the electric motor from dust as much as poss
Resumo do conteúdo contido na página número 16
pre-inspectiOn (enGine/Mixer) BeFORe STaRTIng Table 6. Oil Type Season Temperature Oil Type 1. Read safety instructions at the beginning of manual. Summer 25°C or Higher SAE 10W-30 Spring/Fall 25°C~10°C SAE 10W-30/20 2. Clean the mixer, removing dirt and dust, particularly the engine cooling Winter 0°C or Lower SAE 10W-10 air inlet, carburetor and air cleaner. dangeR 3. Check the air filter for dirt and dust. If air filter is dirty, replace air filter with a new one as required. Motor fuel
Resumo do conteúdo contido na página número 17
initial start-up (enGine) 3. Place the choke lever (Figure 9) in the “CLOSed ” CauTIOn position if starting a cold engine. dO nOT attempt to operate the mixer until the Safety, General Information and Inspection sections of this manual have been read and thoroughly understood. This section is intended to assist the operator with the initial start-up of the mixer. It is extremely important that this section be read carefully before attempting to use the mixer in the field. Figure 9. Eng
Resumo do conteúdo contido na página número 18
initial start-up (enGine/electric MOtOr) 1. Grasp the starter grip (Figure 12) and slowly pull it out. CauTIOn The resistance becomes the hardest at a certain aLWaYS run engine at full speed while mixing. position, corresponding to the compression point. Pull the starter grip briskly and smoothly for starting. STaRTIng THe eLeCTRIC MOTOR 1. Using an adequate size extension cord (see Table 4), connect one end of the extension cord to the plug on the electric motor, connect the other end to
Resumo do conteúdo contido na página número 19
sHutdOwn STOppIng THe engIne STOppIng THe eLeCTRIC MOTOR normal Shutdown 1. Place the electric motor's ON/OFF switch (Figure 19) in the OFF position. 1. Move the throttle lever to the IDLE position (Figure 16) ON and run the engine for three minutes at low speed. OFF Figure 19. Electric Motor ON/OFF Switch (ON) 2. Disconnect the electric motor's extension cord from its power source. Figure 16. Throttle Lever (Idle) Storage (daily) 2. After the engine cools, push the engine ON/OFF switch 1. C
Resumo do conteúdo contido na página número 20
Maintenance (enGine) engIne MaInTenanCe Perform engine maintenance procedures as referenced by Table 7 below: Table 7. engine Maintenance Schedule every 3 every 6 every every 2 First description (3) Operation Before Month or Months or Months or Year or Years or 10 hrs 25 hrs 50 hrs 100 hrs 200 hrs CHECK X Engine Oil CHANGE X CHECK X Air Cleaner CHANGE X (1) All Nuts and Re-tighten If X Bolts Necessary CHECK-CLEAN X Spark Plug REPLACE X Cooling Fins CHECK X Spark Arrester CLEAN X Fuel Tank