Resumo do conteúdo contido na página número 1
MOW’N MACHINE
FZ25D
Power Unit
MAN0646
(Rev. 3/7/2012)
OPERATOR'S MANUAL
Resumo do conteúdo contido na página número 2
TO THE DEALER: ® Assembly and proper installation of this product is the responsibility of the Woods dealer. Read manual instructions and safety rules. Make sure all items on the Dealer’s Pre-Delivery and Delivery Check Lists in the Operator’s Manual are completed before releasing equipment to the owner. The dealer must complete the online Product Registration form at the Woods Dealer Website which certifies that all Dealer Check List items have been completed. Dealers can register all Woods pro
Resumo do conteúdo contido na página número 3
TABLE OF CONTENTS INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 GENERAL INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 SAFETY RULES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 - 8 SAFETY DECALS . . . . . . . . . . . . . . . . . . . . . . . . .
Resumo do conteúdo contido na página número 4
SPECIFICATIONS Engine . . . . . . . . . . . . . . . . . . . . . . . . . . . Kubota 3-cylinder, 4-cycle, liquid cooled (See engine manual for complete specifications) Horsepower . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 HP Fuel Type. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Diesel Standard Tire Size: Front . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 x 10.50 - 12
Resumo do conteúdo contido na página número 5
SAFETY RULES ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Safety is a primary concern in the design and PREPARATION manufacture of our products. Unfortunately, our Check that all hardware is properly installed. efforts to provide safe equipment can be wiped Always tighten to torque chart specifications out by an operator’s single careless act. unless instructed otherwise in this manual. In addition to the design and configuration of Always wear relatively tight and belted clothing equipme
Resumo do conteúdo contido na página número 6
SAFETY RULES ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Never fill fuel containers inside a vehicle or a Operate only in daylight or good artificial light. truck or trailer bed with a plastic liner. Always Keep hands, feet, hair, and clothing away from place container on the ground away from the vehi- equipment while engine is running. Stay clear of all cle before filling. moving parts. Remove gas-powered equipment from the truck Because a ROPS is not offered with this unit, a or tra
Resumo do conteúdo contido na página número 7
SAFETY RULES ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Stop power unit and equipment immediately Do not modify or alter or permit anyone else to upon striking an obstruction. Turn off engine, modify or alter the equipment or any of its compo- remove key, inspect, and repair any damage before nents in any way. resuming operation. Do not work on mower in tilt-up position unless Do not drive or operate mower in tilt-up posi- deck is in a stable position. tion. Power unit stability is no
Resumo do conteúdo contido na página número 8
SAFETY RULES ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Battery posts, terminals, wiring insulation, and Never store the machine or fuel container near related accessories contain lead and lead com- an open flame, spark or pilot light such as on a pounds, chemicals known to the State of California water heater or other appliance. to cause cancer and birth defects or other repro- Do not run engine indoors. Exhaust gases con- ductive harm. WASH HANDS AFTER HANDLING. tain carbon monoxide,
Resumo do conteúdo contido na página número 9
SAFETY & INSTRUCTIONAL DECALS ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Replace Immediately If Damaged! 1 - PN 72407 2 - PN 72404 3 - SERIAL NUMBER PLATE MODEL NO. SERIAL NO. Woods Equipment Company Oregon, Illinois, U.S.A. W W Woods Equipment Company Oregon, Illinois, U.S.A. (Safety Decals continued on next page) MAN0646 (7/6/2007) Safety 9
Resumo do conteúdo contido na página número 10
SAFETY & INSTRUCTIONAL DECALS ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Replace Immediately If Damaged! (Safety Decals continued from previous page) 5 - PN 72648 4 - PN 72408 CAUTION ENGINE COOLANT (SEE ENGINE MANUAL) DO NOT OPEN WHEN HOT 72648 9 - PN 07754100 10 - PN 72801 07754100 8 - PN 72406 6 - PN 70376 7 - PN 72405 BE CAREFUL! Use a clean, damp cloth to clean safety decals. Avoid spraying too close to decals when using a pressure washer; high-pressure water can enter through very s
Resumo do conteúdo contido na página número 11
OPERATION The operator is responsible for the safe operation of this Mow’n Machine. The operator must be properly trained. Operators should be familiar with the power unit, all attachments that will be used, and all safety Moving steering levers rapidly from forward to practices before starting operation. Read the safety reverse or reverse to forward could cause loss of rules and safety decals on page 5 through page 10. control. Look down and to the rear and make sure area is clear be
Resumo do conteúdo contido na página número 12
brake and turn ignition key switch to the “ON” position. CONTROLS AND SWITCHES Control panel brake light (3) should be on. Temperature Light NOTICE Know your controls and how to stop engine and ■ For overheating, clean radiator grill and check attachment quickly in an emergency. engine coolant level. Control and indicator console is located on the right The temperature light will alert you when the engine fuel tank. This console contains controls needed to temperature is excessive. Th
Resumo do conteúdo contido na página número 13
STARTING ENGINE NOTICE ■ Never engage PTO if the mower blades are plugged with grass or other material. This may Do not run engine indoors. Exhaust gases con- cause damage to the electric clutch. tain carbon monoxide, an odorless and deadly poi- 1. With engine running, position throttle at half speed. son. 2. Engage PTO by pulling up on the PTO switch. To enhance starter life, use short starting cycles not exceeding 10 seconds. If engine does not start within 3. Move throttle to full sp
Resumo do conteúdo contido na página número 14
forward. Pulling handles to the rear will move the power unit in reverse. The further forward or rearward CAUTION the steering handles are moved, the faster the machine will move. Mow up and down slopes, not across. If the tires lose traction on a slope, disengage Steering Handle Positions the blade(s) and proceed slowly straight down the slope. NOTICE ■ If you become confused during operation, Practice steering maneuvers at half throttle. return both handles to the center neutral position an
Resumo do conteúdo contido na página número 15
Manually move a disabled power unit by following STOPPING ENGINE these steps. 1. Move throttle to 1/3 setting. 2. Allow engine to idle for several minutes. 1. Locate dump valves on bottom of both hydraulic pumps. 3. Turn key to OFF position and remove. 2. Turn hex head two full revolutions counter-clock wise to open valve, using a 5/8" wrench or round CAUTION punch. Remove key and store in a secure location to prevent unauthorized persons from operating WEIGHT TRANSFER equipment. Manual Fuel Sh
Resumo do conteúdo contido na página número 16
___ Do not allow riders. OWNER PRE-OPERATION CHECK LIST (OWNER'S RESPONSIBILITY) ___ Inspect area and remove stones, branches or other hard objects that might be thrown, causing ___ Review and follow all safety rules and safety injury or damage. decal instructions on pages 5 through 10. ___ Clean air intake screen. Check air cleaner; ser- ___ Check that all safety decals are installed and in vice if necessary. good condition. Replace if damaged. ___ Clean area around oil fill dipstick. Remove di
Resumo do conteúdo contido na página número 17
OWNER SERVICE The information in this section is written for operators 1. Park power unit on a level surface. who possess basic mechanical skills. If you need help, 2. Stop engine and clean off dirt and dust from around your dealer has trained service technicians available. dipstick. For your protection, read and follow the safety informa- tion in this manual. 3. Remove dipstick, check oil level. Oil level should be between marks on dipstick. Avoid touching exhaust manifold if unit has been runn
Resumo do conteúdo contido na página número 18
Lubrication Service Intervals 1. Hydrostatic Fluid Level (check) 8 hours 2. Deck Pivot 8 hours 3. Driveline 80 hours 4. Driveshaft 8 hours 5. Blade Spindles 40 hours 6. Front Wheels 8 hours 7. Engine Oil Level (check) 8 hours 8. Parking Brake Handle Pivot 80 hours 9. Gearbox (under deck) 500 hours 10. Front Lift Linkage 40 hours 11. Caster Pivot 40 hours 12. Radiator Clean 40 hours/annually 13. Prescreen Clean Daily Figure 6. Lubrication Diagram TAILWHEEL MAINTENANCE Once a year, disassemble ta
Resumo do conteúdo contido na página número 19
3. Remove case drain hose fitting from bottom of HYDROSTATIC TRANSMISSION SERVICE reservoir, located outside of power unit frame. NOTICE Allow reservoir to completely drain. ■ Keep transmission oil clean. When adding fluid 4. Remove automotive type filter (Figure 8) by turning take precautions to prevent dirt and other foreign counter-clockwise. material from entering the system. 5. Replace filter by turning until gasket is seated; then NOTE: Check fluid level every 8 hours of operation. turn a
Resumo do conteúdo contido na página número 20
4. Inspect battery case for cracks or leaks; replace CLEANING battery if necessary. After Each Use 5. Test battery with hydrometer; recharge battery if less than 75% charge is indicated. ● Remove large debris such as clumps of dirt, grass, crop residue, etc. from machine. 6. Add water if necessary. ● Inspect machine and replace worn or damaged 7. Check that the positive terminals on the battery, parts. starter and alternator are properly covered with protective boots from exposure to grounding.
