Manual do usuário Stiga 8211-3011-07

Resumo do conteúdo contido na página número 1

STIGA PARK
121M
8211-3011-07

Resumo do conteúdo contido na página número 2

5b. D 5c. Pro18 - Pro20 1. Park -1993 5a. 2. Park -1993 6b. Park 2000- 6a. Park -1999 F G H 3. Park -1993 7. I I 4. Park -1993 8. 2

Resumo do conteúdo contido na página número 3

J 9. 13. 10. 14. Z X V Y W 11. 15. Denna produkt, eller delar därav, omfattas av följande mönsterskydd: This product, or part of it, is covered by the following design registration: Sverige/Sweden 62 435 Tyskland/Germany M97 07 997.9 (pending) 12. 3

Resumo do conteúdo contido na página número 4

GB ENGLISH SYMBOLS ASSEMBLY The following symbols are displayed on the ma- chine in order to remind you about the safety pre- MOWER DECK cautions and attention necessary when using the machine. 1. Bolt the mower deck to the attachment brackets D (fig 5a). The symbols mean: 2. Then hook the lower S-hook on to the mower Warning! deck (fig 5b-c). Read the instruction book and safety man- ual before using the machine. 3. Connect the electrical contact to the outlet on the side of the machine (applie

Resumo do conteúdo contido na página número 5

GB ENGLISH height positions CLEANING - art. no. 13-2921 has stepless adjustment of the After use the underside of the mower deck should mowing height. be hosed down. N.B. Thestatedmowingheights applywhenthe If grass cuttings have dried on to the mower deck, machine is standing on firm ground. scrape the underside clean. MOWING HINTS If necessary touch-up the underside using a suita- ble paint to prevent corrosion. For the best "Multiclip" effect follow this advice: - mow regularly. DRIVE BELTS -

Resumo do conteúdo contido na página número 6

GB ENGLISH Always use original spare parts. Using non-original spare parts can result in the risk of damage even if they fit in the machine. The cutting system consists of three blade bars, each with two interchangeable blade tips Y (fig 15). Both blade tips should be replaced at the same time to avoid any imbalance. Fit the new blade tips. Tighten the screws V and W fully. Tightening torque: V - 9.8 Nm, W - 24 Nm. And heavy impact can result in the blade tip being folded aside. Loosen the locki