Resumo do conteúdo contido na página número 1
IMPORTANT MANUAL Do Not Throw Away
OPERATOR'S MANUAL
WARNING:
MODEL:
Read this Man u al and follow all Warnings and
Safety Instructions. Fail ure to do so can re sult
in serious in ju ry.
PK20H42YT
LAWN TRACTOR
ALWAYS WEAR EYE PROTECTION DURING OPERATION
Visit our website: www.poulan-pro.com
194804 Rev. 1 01.06.07 CL
Printed in U.S.A.
Resumo do conteúdo contido na página número 2
SAFETY RULES Safe Operation Practices for Ride-On Mowers IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate machine without the entire grass catcher, WARNING: In order to prevent ac- discharge guard, or other safety devices in place and ci den tal starting when setting up, working. trans port ing, ad just ing or making re- • Slow down b
Resumo do conteúdo contido na página número 3
SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE Tragic accidents can occur if the operator is not alert to • Never operate machine in a closed are. • Keep all nuts and bolts tight to be sure the equipment the presence of children. Children are often attracted to the ma chine and the mowing activity. Never assume that is in safe working condition. • Never tamper with safety devices. Check their proper children will remain where you last saw them. • Keep
Resumo do conteúdo contido na página número 4
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manu fac tured to give Gasoline Capacity 4.0 Gallons you the best possible dependability and performance. and Type: Unleaded Regular Should you experience any problem you cannot easily rem- Oil Type (API-SG-SL): SAE 10W30 (above 32°F) edy, please contact your nearest authorized service center/ SAE 5W-30 (below 32°F) department. We have com pe tent, well-trained tech ni cians
Resumo do conteúdo contido na página número 5
UNASSEMBLED PARTS Steering Wheel Seat (1) Washer 17/32 x 1-3/16 x 12 Gauge Steering Wheel (1) Knob Insert Steering Wheel Adapter Key (1) Large Flat Washer Steering Sleeve (2) Keys (1) Oil Drain Tube Slope Sheet (1) Hex Bolt 1/4-28 x 1-1/4 (1) Hex nut 1/2-20 Gauge Wheels (4) Retainer Springs (double loop) (4) Washers (4) Locknut 3/8-16 3/8 x 3/4 x 14 Ga. (4) Wheels (4) Adjusting Bar (4) Shoulder Bolt (4) Clevis Pins 5
Resumo do conteúdo contido na página número 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. TOOLS REQUIRED FOR ASSEMBLY STEERING WHEEL A socket wrench set will make assembly easier. Stan dard INSERT wrench sizes are listed. LOCK NUT (1) 3/4" wrench Pliers (1) 9/16" wrench
Resumo do conteúdo contido na página número 7
02173 ASSEMBLY TO ROLL TRACTOR OFF SKID (See Op- er a tion section for location and function of SEAT SHOULDER con trols) BOLT • Press lift lever plunger and raise attachment lift lever to its highest po si tion. • Release parking brake by de press ing clutch/brake ped al. SEAT PAN • Place freewheel control in "trans mis sion dis en gaged position" (See “TO TRANS PORT” in the Op er a tion section of this manual). • Roll tractor forward off skid. • Remove banding holding the deflector shie
Resumo do conteúdo contido na página número 8
ASSEMBLY RETAINER ✓CHECKLIST SPRING BEFORE YOU OPERATE YOUR NEW TRAC TOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PER- FORMANCE AND SATISFACTION FROM THIS QUALITY PIN PRODUCT. SHOULDER BOLT PLEASE REVIEW THE FOLLOWING CHECKLIST: AD JUST ING BAR ✓ All assembly instructions have been com plet ed. ✓ No remaining loose parts in carton. ✓ Battery is properly prepared and charged. (Minimum 1 hour at 6 amps). ✓ Seat is adjusted comfortably and tightened securely. GAUGE ✓ All tires are pr
Resumo do conteúdo contido na página número 9
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. FAST SLOW REVERSE NEUTRAL HIGH LOW CHOKE IGNITION SWITCH P ENGINE ON ENGINE START PARKING BRAKE ENGINE OFF REVERSE PARKING BRAKE PARKING BRAKE OPERATION LOCKED UNLOCKED SYSTEM (ROS) OIL PRESSURE BATTERY OVER TEMP FUEL REVERSE FORWARD MOWER HEIGHT MOWER LIFT LIGHT 15 15 ATTACHMENT ATTACHMENT SLOPE HAZARDS DANGER, KEEP HANDS KEEP AREA CLEAR CLUTCH DISENGAGED CLUTCH
Resumo do conteúdo contido na página número 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. ROS "ON" POSITION IGNITION SWITCH LIFT LEVER AT TACH MENT PLUNGER CLUTCH THROTTLE/CHOKE SWITCH CONTROL ATTACHMENT LIFT LEVER CLUTCH/BRAKE PEDAL HEIGHT ADJUSTMENT KNOB LIGHT SWITCH PARKING BRAKE FREE WHEEL MOTION CONTROL CONTRO
Resumo do conteúdo contido na página número 11
OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while op- erating your tractor or per form ing any adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY HOW TO USE YOUR TRACTOR POSITION OTHER THAN "STOP" WILL CAUSE THE BATTERY TO BE DIS CHARGED, (DEAD). TO SET PAR
Resumo do conteúdo contido na página número 12
OPERATION ATTACHMENT NOTE:Adjust gauge wheels with tractor on a flat level "ENGAGED" PO SI TION LIFT LEVER surface. HIGH PO SI TION • Adjust mower to desired cutting height (See “TO AD- JUST MOWER CUT TING HEIGHT” in the Operation sec tion of this manual). LOW • Remove retainer spring and clevis pin which secure POSITION each gauge wheel bar. • Lower gauge wheels to ground. Raise gauge wheels slightly to align holes in bracket and gauge wheel bar and insert clevis pin. Gauge wheels should b
Resumo do conteúdo contido na página número 13
OPERATION • Pull up and remove oil fill cap/dipstick; wipe oil off. Re- • Avoid stopping or changing speed on hills. insert the dipstick into the tube and push down firmly • If slowing is necessary, move throttle control lever to into place. Remove and read oil level. If necessary, slower position. add oil until “FULL” mark on dipstick is reached. Do • If stopping is absolutely necessary, push clutch/brake not overfill. pedal quickly to brake position and engage parking • For cold weath
Resumo do conteúdo contido na página número 14
OPERATION • Move motion control lever to neutral (N) position. Shut- WARM WEATHER STARTING (50° F and above) off engine and set parking brake. • When engine starts, move the throttle control to the fast position. • Engage transmission by placing freewheel control in engaged position (See “TO TRANSPORT” in this sec- • The attachments and ground drive can now be used. If tion of manual). the engine does not accept the load, restart the engine and allow it to warm up for one minute using the
Resumo do conteúdo contido na página número 15
maint_sch-tractore.ROS.e MAINTENANCE MAINTENANCE SCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check Brake Operation Check Tire Pressure Check Operator Presence and ROS Systems T R Check for Loose Fasteners 5 A Sharpen/Replace Mower Blades 3 C Lubrication Chart T Check Battery Level 4 0 Clean Battery and Terminals R Check Transaxle Cooling Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1,2 Change Engine Oil (without oil filter) 1,2 E Clean Air Fil
Resumo do conteúdo contido na página número 16
MAINTENANCE TRACTOR BLADE CARE Always observe safety rules when per form ing any main- For best results mower blades must be kept sharp. Re place te nance. bent or damaged blades. BRAKE OPERATION CAUTION: Use only a replacement blade If tractor requires more than five (5) feet to stop at highest approved by the manufacturer of your speed in high est gear on a level, dry concrete or paved tractor. Using a blade not approved surface, then brake must be checked and ad just ed. (See by the
Resumo do conteúdo contido na página número 17
MAINTENANCE • Slide blade on to an unthreaded portion of the steel bolt TRANSAXLE PUMP FLUID or pin and hold the bolt or pin parallel with the ground. The transaxle was sealed at the factory and fluid main te - If blade is balanced, it should remain in a horizontal nance is not required for the life of the transaxle. Should position. If either end of the blade moves downward, the transaxle ever leak or require servicing, contact your sharpen the heavy end until the blade is balanced. n
Resumo do conteúdo contido na página número 18
MAINTENANCE • After oil has drained completely, close and lock the MUFFLER drain valve by pushing inward and turning clockwise Inspect and replace corroded muffler and spark arrester until the pin is in the locked position as shown. (if equipped) as it could create a fire hazard and/or dam- • Remove the drain tube and replace the cap onto to the age. bottom fitting of the drain valve. • Refill engine with oil through oil fill dipstick tube. Pour SPARK PLUGS slowly. Do not overfill.
Resumo do conteúdo contido na página número 19
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST - MENTS: • Depress clutch/brake pedal fully and set parking brake. • Place motion control lever in neutral (N) position. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug
Resumo do conteúdo contido na página número 20
SERVICE AND ADJUSTMENTS SIDE-TO-SIDE ADJUSTMENT (See Figs. 17 and 18) • Raise mower to its highest position. • At the midpoint of both sides of mower, measure height MANDREL from bot tom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other. "D" "D" • If adjustment is necessary, make adjustment on one side of mower only. FIG. 19 • To raise one side of mower, tighten lift link ad just ment nut on that side. BOTH FRONT LINKS MUST BE EQU
