Resumo do conteúdo contido na página número 1
IMPORTANT MANUAL Do Not Throw Away
02478
OWNER'S MANUAL
WARNING:
Read this Owner's Man u al and follow all Warn-
MODEL:
ings and Safety Instructions. Fail ure to do so
can re sult in serious in ju ry.
PD18542STA
LAWN TRACTOR
ALWAYS WEAR EYE PROTECTION DURING OPERATION
188737 11.18.03 MH
Printed in U.S.A.
Resumo do conteúdo contido na página número 2
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS IMPORTANT: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. Avoid starting or stopping on a slope. If tires lose trac- I. GENERAL OPERATION tion, disengage the blades and proceed slowly straight Read, understand, and follow all instructions in the down the slope. manual and on the machine before
Resumo do conteúdo contido na página número 3
SAFETY RULES SAFE OPERATION PRACTICES FOR RIDE-ON MOWERS Be sure the area is clear of other people before mowing. Stop WARNING: In order to prevent ac- machine if anyone enters the area. ci den tal starting when setting up, Never carry passengers or children even with the blades trans port ing, ad just ing or making re- off. pairs, alwa ys dis con nect spark plug Do not mow in reverse unless absolutely necessary. Al ways wire and place wire where it can not look down an
Resumo do conteúdo contido na página número 4
CONGRATULATIONS on your purchase of a new tractor. PRODUCT SPECIFICATIONS It has been designed, engineered and manu factured to giv e you the best possible dependability and performance. GASOLINE CAPACITY 2.0 GALLONS AND TYPE: UNLEADED REGULAR Should you experience any problem you cannot easily rem- edy, please contact your nearest authorized service center/ OIL TYPE (API-SF-SJ): SAE 30 (above 32°F) department. We have com pe tent, well-trained tech
Resumo do conteúdo contido na página número 5
CONTENTS OF HARDWARE PACK Steering Wheel Seat (1) Washer Steering Boot 17/32 x 1-3/16 x 12 Gauge Steering Wheel Steering (1) Knob Insert Extension Shaft Steering Wheel Key Adapter (1) Large Flat Washer (1) Locknut 1/2-20 (2) Keys (1) Oil Drain Tube Slope Sheet (1) Locknut 1/4-28 (1) Hex Bolt 1/4-28 x 1-1/4 Gauge Wheels (4) Retainer Springs (double loop) (4) Washers (4) Locknut 3/8-16 3/8 x 3/4 x 14 Ga. (4) Wheels (4) Adjusting Bar (4) Shoulder Bolt (4) Clevis Pins
Resumo do conteúdo contido na página número 6
ASSEMBLY Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness. INSERT TOOLS REQUIRED FOR ASSEMBLY A socket wrench set will make assembly easier. Stan dard 1/2 HEX NUT wrench sizes are listed. (2) 7/16" wrenches Utility knife LARGE FLAT WASHER (2)
Resumo do conteúdo contido na página número 7
ASSEMBLY Remove banding holding defl ector shield up against SEAT SHOULDER tractor. BOLT TO DRIVE TRACTOR OFF SKID (See Op- er a tion sec tion for lo ca tion and func tion of con trols) SEAT PAN WARNING: Before starting, read, un der stand and follow all in struc tions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects. Be sure all the above assembly steps have been co
Resumo do conteúdo contido na página número 8
ASSEMBLY CHECK TIRE PRESSURE INSTALL MULCHER PLATE (See Fig. 5) The tires on your tractor were overinfl ated at the factory (If previously removed) for shipping purposes. Correct tire pressure is important Raise and hold defl ector shield in up right po si tion. for best cutting performance. Place front of mulcher plate over front of mower deck Reduce tire pressure to PSI shown in “PRODUCT open ing and slide into place, as shown. SPEC I FI CA TIONS” section of this manual.
Resumo do conteúdo contido na página número 9
OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. HIGH LOW FAST SLOW IGNITION REVERSE NEUTRAL CHOKE P LIGHTSON ENGINESTART ENGINEOFF ENGINEON PARKINGBRAKE PARKINGBRAKE PARKINGBRAKE LOCKED UNLOCKED FUEL OILPRESSURE BATTERY REVERSE FORWARD OVERTEMP MOWERHEIGHT MOWERLIFT LIGHT 15 15 ATTACHMENT ATTACHMENT SLOPEHAZARDS CLUTCHENGAGED CLUTCHDISENGAGED DANGER,KEEPHANDS KEEPAREACLEAR ANDFEETAWAY (SEESAFETYRULESSECTION) DA
Resumo do conteúdo contido na página número 10
OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. IGNITION LIGHT SWITCH SWITCH ATTACHMENT POSITION CLUTCH LEVER AMMETER LIFT LEVER THROTTLE/ PLUNGER CHOKE CONTROL ATTACHMENT LIFT LEVER HEIGHT CLUTCH/ ADJUSTMENT BRAKE LEVER PEDAL PARKING BRAKE GEAR SHIFT LEVER FIG. 6 Our tract
Resumo do conteúdo contido na página número 11
OPERATION The operation of an y tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per forming an y adjustments or repairs. We rec om mend a wide vision safety mask over spectacles or stan dard safety glasses. NOTE: Under certain conditions when tractor is standing HOW TO USE YOUR TRACTOR idle with the engine running, hot engine exhaust gases may cause “brown ing”
Resumo do conteúdo contido na página número 12
OPERATION TO ADJUST GAUGE WHEELS (See Fig. 8) "ENGAGED" POSITION Gauge wheels are properly adjusted when they are slightly ATTACHMENT LIFT LEVER off the ground when mower is at the desired cutting height HIGH PO SI TION in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions. LOW NOTE:Adjust gauge wheels with tractor on a fl at level POSITION surface. Adjust mower to desired cutting height (See “TO AD- AT TACHMENT
Resumo do conteúdo contido na página número 13
OPERATION Insert key into ignition and turn key clockwise to “START” BEFORE STARTING THE ENGINE position and release key as soon as engine starts. Do not run starter continuously for more than fi fteen CHECK ENGINE OIL LEVEL sec onds per minute. If the engine does not start after The engine in your tractor has been shipped, from the several attempts, move throttle control to fast position, factory, already fi lled with sum mer weight oil. wait a few minutes and try again. If engi
Resumo do conteúdo contido na página número 14
OPERATION MULCHING MOWING TIPS MOWING TIPS IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER Mower should be properly leveled for best mowing per- HOUSING FREE OF BUILT-UP GRASS AND TRASH. CLEAN fo r mance. See "TO LEVEL MOWER HOUSING" in the AFTER EACH USE. Service and Adjustments section of this manual. The spe cial mulch ing blade will recut the grass clip- The left hand side of mower should be used for trim- pings man y times and reduce them in size so that as ming. they fal
Resumo do conteúdo contido na página número 15
MAINTENANCE MAINTENANCE SCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check Brake Operation Check Tire Pressure Check Operator Presence and Interlock Systems T Check for Loose Fasteners R 5 A Sharpen/Replace Mower Blades 3 C Lubrication Chart T Check Battery Level 4 0 Clean Battery and Terminals R Check Transaxle Cooling Check V-Belts Check Engine Oil Level Change Engine Oil (with oil filter) 1,2 Change Engine Oil (without oil filter) 1,2 E Clean Air Filter N 2 G Clean Air
Resumo do conteúdo contido na página número 16
01202 MAINTENANCE TRACTOR TRAILING MANDREL EDGE UP ASSEMBLY BLADE Always observe safety rules when performing any main- te nance. CENTER HOLE BRAKE OPERATION FLAT WASHER If tractor requires more than six (6) feet stopping distance LOCK WASHER at high speed in highest gear, then brake must be adjusted. STAR (See “TO ADJUST BRAKE” in the Service and Ad just ments section of this manual). BLADE BOLT TIRES Maintain proper air pressure in all tires (See “PROD UCT FIG. 12 SPECIFICATIONS” s
Resumo do conteúdo contido na página número 17
MAINTENANCE Rinse the battery with plain water and dry. Unlock drain valve by pushing inward and turning coun ter clock wise. Clean terminals and battery cable ends with wire brush To open, pull out on the drain valve. until bright. After oil has drained completely, close and lock the Coat terminals with grease or petroleum jelly. drain valve by pushing inward and turning clockwise Reinstall battery (See “REPLACING BATTERY” in the until the pin is in the
Resumo do conteúdo contido na página número 18
MAINTENANCE IN-LINE FUEL FILTER (See Fig. 16) The fuel fi lter should be replaced once each season. If fuel fi lter becomes clogged, ob struct ing fuel fl ow to car bure tor, re place ment is re quired. With engine cool, remove fi lter and plug fuel line sec- tions. Place new fuel fi lter in position in fuel line with arrow pointing towards carburetor. Be sure there are no fuel line leaks and clamps are properly positioned. Immediately wipe up any spilled gasoline. CLAMP C
Resumo do conteúdo contido na página número 19
SERVICE AND ADJUSTMENTS WARNING: TO AVOID SE RI OUS IN JU RY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS: Depress clutch/brake pedal fully and set parking brake. Place gearshift lever in neutral (N) position. Place attachment clutch in “DISENGAGED” position. Turn ignition key to “STOP” and remove key. Make sure the blades and all moving parts have completely stopped. Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug. IMPORTAN
Resumo do conteúdo contido na página número 20
SERVICE AND ADJUSTMENTS When distance “D” is 1/8" to 1/2" lower at front than TO LEVEL MOWER HOUSING rear, tighten nuts “F” against trunnion on both front Adjust the mower while tractor is parked on level ground links. or driveway. Make sure tires are properly infl ated (See To raise front of mower, loosen nut “F” from trunnion on “PROD UCT SPECIFICATIONS” section of this manual). If both front links. Tighten nut “E” on both front links an tires are over or underinfl ated, you
