Resumo do conteúdo contido na página número 1
Operator ’s Manual
RT380H T ractor
with Recycling/Side Discharge Deck
G006889
Code 135E
Serial No. 280000001
Manual Part No. 1 1 1-2091 Rev C
Resumo do conteúdo contido na página número 2
Contents Introduction Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 R ead this infor mation carefully to lear n ho w to operate Safe Operation Practices for Ride-on (Riding) and maintain y our product properly and to a v oid injur y R otar y
Resumo do conteúdo contido na página número 3
Fuel System Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Safety Draining the Fuel T ank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 R e placing the Fuel Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Safe Operation Practices for Electrical System Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Ser vicing the Batter y . . . . . . . . . . . . . .
Resumo do conteúdo contido na página número 4
• T horoughly inspect the area where the equipment • Use care when pulling loads or using hea vy is to be used and remo v e all objects whic h ma y be equipment. thro wn b y the mac hine . – Use only appro v ed dra wbar hitc h points . • W ar ning —Fuel is highly flammable . – Limit loads to those y ou can safely control. – Store fuel in containers specifically designed for – Do not tur n shar ply . Use care when rev ersing . this pur pose . – Use counterw eight(s) or wheel w eights when – R efu
Resumo do conteúdo contido na página número 5
• R educe the throttle setting during engine r un-out and, if the engine is pro vided with a shut-off v alv e , tur n the fuel off at the conclusion of mo wing . • Use only Ha yter -appro v ed attac hments . T he w ar ranty ma y be v oided if y ou use the tractor with unappro v ed attac hments . Maintenance and Storage • K ee p all n uts , bolts and screws tight to be sure the equipment is in safe w orking condition. • Nev er store the equipment with fuel in the tank inside a building where fume
Resumo do conteúdo contido na página número 6
Slope Chart 6
Resumo do conteúdo contido na página número 7
Safety and Instructional Decals Safety decals and instr uctions are easily visible to the operator and are located near any area of potential dang er . R e place any decal that is damag ed or lost. 92-5730 1. Choke 3. Continuous variable setting 2. Fast 4. Slow 1 14-3236 1. Parking brake—to engage, press the brake/clutch pedal and lift the parking brake lever; to disengage press and release the brake/clutch pedal. 2. Brake and clutch—to engage, press the brake/clutch pedal. 3. T raction drive—to
Resumo do conteúdo contido na página número 8
93-6677 1. W arning—don’t operate the mower with the deflector up or removed; keep the deflector in place. 99-2986 2. Cutting/dismemberment hazard of hand or foot, mower blade—stay away from moving parts. 1. Crushing/dismemberment hazard of bystanders—do not turn the key while children are present; keep children a safe distance from the machine. 99-5340 1. Reverse interlock key—turn to enable reverse mowing. 93-6679 1. Engine 93-7009 1. W arning—don’t operate the mower with the deflector up or r
Resumo do conteúdo contido na página número 9
Battery Symbols Some or all of these symbols are on your battery 1. Explosion hazard 6. Keep bystanders a safe distance from the battery . 2. No fire, open flame, or 7. W ear eye protection; smoking. explosive gases can 100-7449 cause blindness and other injuries 1. Pull the lever out to push 3. Read the instructions the machine. before servicing or 3. Caustic liquid/chemical 8. Battery acid can cause blindness or severe burns. performing maintenance. burn hazard 4. W ear eye protection 9. Flush
Resumo do conteúdo contido na página número 10
Setup Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty . Use Front wheels 2 Shim washers (as required) 2 Flat washers 2 Install the front wheels. 1 Cotter pins 2 Hub caps 2 No parts required – Check the tyre pressure. 2 Steering wheel 1 Install the steering wheel. 3 Spirol pin 1 Seat 1 Knobs 2 Install the seat. 4 Flat-washer 2 Bulk electrolyte, 1.260 specific gravity As (purchase separately) needed Activate the battery . 5 Bolt (1/4 x 3/4 inch
Resumo do conteúdo contido na página número 11
1 2 Installing the Front Wheels Checking the T yre Pressure Parts needed for this procedure: No Parts Required 2 Front wheels Procedure 2 Shim washers (as required) Ensure that the air pressure in the front and rear tyres 2 Flat washers are 20 psi (138 kP a). Chec k the pressure at the v alv e 2 Cotter pins stem ( Figure 4 ). 2 Hub caps Procedure 1. Install the shim w ashers onto the axle . 2. Install the wheel onto the axle with the v alv e stem facing out. Figure 4 1. V alve stem 3. Slide the
Resumo do conteúdo contido na página número 12
Figure 6 Figure 5 1. Seat 4. Seat switch 1. Steering wheel 2. Spirol pin 2. Shoulder bolts 5. Seat base 3. Knobs and flat washers 3. Align the holes b y inser ting a punc h or a long nail 2. T hread the knobs and flat w ashers through the slots par tially through the holes in the steering wheel and and into the rear center holes in the seat ( Figure 6 ). shaft. 4. Inser t the spirol pin into the hole on the opposite 3. Adjust the seat and tighten the knobs . side ( Figure 5 ). 4. Connect the sea
Resumo do conteúdo contido na página número 13
Batter y electr ol yte contains sulfuric acid, a deadl y poison that can sev er el y bur n y ou and other s. • Do not drink electr ol yte and a v oid contact with skin, ey es, or clothing . W ear safety g lasses to shield y our ey es and r ub ber g lo v es to pr otect y our hands. Figure 8 • Fill the batter y wher e clean w ater is al w ays a v aila ble f or flushing the skin. 1. Positive post 3. Charger red (+) wire 2. Negative post 4. Charger black (–) wire • F ollo w all instr uctions and com
Resumo do conteúdo contido na página número 14
7 9 Installing the Anti-Scalp Lubricating the T ractor Wheels No Parts Required Parts needed for this procedure: Procedure 2 Anti-scalp wheels Ensure that all of the necessar y points on the tractor are 2 Wheel bolt lubricated; refer to Greasing and Lubricating the T ractor 2 Locknut in Maintenance . Procedure Mount the anti-scalp wheels onto the wheel brac k ets 10 with the wheel bolts and loc kn ut ( Figure 9 ). Checking the Safety Interlock System No Parts Required Procedure Chec k the safety
Resumo do conteúdo contido na página número 15
4. Stop the engine and w ait for all mo ving par ts to stop . 5. R emo v e the ignition k ey . 6. Raise the right rear wheel off the g round and suppor t it with a jac k stand. Note: Ensure that the left rear wheel sta ys on the g round. Mechanical or h y draulic jacks may f ail to suppor t the tractor and cause a serious injur y . • Use jack stands when suppor ting the tractor . Figure 10 2. Push position 1. Operate position • Do not use h y draulic jacks. Note: T o g ain access to the adjustin
Resumo do conteúdo contido na página número 16
Product Overview 13 Controls Checking the T raction Control Become familiar with the controls ( Figure 13 ) before y ou star t the engine and operate the tractor . Pedal No Parts Required Procedure If the tractor dri v es too fast or slo w with the traction control pedal fully pressed in either direction, y ou can adjust it to set the optim um forw ard and rev erse speeds , as follo ws: 1. Loosen the screws belo w the right footrest. 2. Slide the pedal forw ard for a faster rev erse speed or bac
Resumo do conteúdo contido na página número 17
Operation In cer tain conditions, petr ol is extr emel y Note: Deter mine the left and right sides of the flamma ble and highl y explosi v e. A fir e or mac hine from the nor mal operating position. explosion fr om petr ol can bur n y ou and other s and can dama ge pr oper ty . Petrol and Oil • Fill the fuel tank outdoor s in an open ar ea Use unleaded petrol suitable for automoti v e use (85 when the engine is cold. W ipe up an y petr ol pump octane minim um). that spills. • Do not fill the fue
Resumo do conteúdo contido na página número 18
• It cleans the engine while it r uns . • It eliminates gum-lik e v ar nish buildup in the fuel system, whic h causes hard star ting . Important: Do not use fuel additi v es containing methanol or ethanol. Add the cor rect amount of fuel stabilizer/conditioner to the petrol. Note: A fuel stabilizer/conditioner is most effecti v e Figure 14 when it is mix ed with fresh petrol. T o minimize the 1. Brake pedal 2. Parking brake lever c hance of v ar nish de posits in the fuel system, use a fuel stab
Resumo do conteúdo contido na página número 19
Operating the Blade Control Starting the Engine (PT O) 1. Sit do wn on the seat. 2. Set the parking brak e; refer to Setting the P arking T he blade control (PTO) eng ag es and diseng ag es Brak e . po w er to the electric clutc h. Note: T he engine does not star t unless y ou set the Engaging the Power T ake Off (PT O) parking brak e or fully de press the brak e pedal. 1. Press the clutc h/brak e pedal to stop the tractor . 3. Push the blade control (PTO) to off ( Figure 16 ). 2. Pull the blade
Resumo do conteúdo contido na página número 20
r unning), the engine will stop . Do not mo w in r ev er se Stopping the Engine unless it is a bsolutel y necessar y . 1. Shift the throttle lev er to F ast ( Figure 18 ). If y ou need to use the blade control (PTO) while 2. T ur n the ignition k ey to Off , w ait for all mo ving bac king up , tur n off the interloc k feature using the par ts to stop , and remo v e the k ey before lea ving the rev erse interloc k switc h located near the seat brac k et operating position. ( Figure 19 ). ( Figure
