Manual do usuário American Standard Town Square Two-Piece Toilets 2787

Resumo do conteúdo contido na página número 1

Town Square Two-Piece Toilets
INSTALLATION
Model 2797 Elongated w/Seat
INSTRUCTIONS
Model 2787 Round Front w/Seat
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product
is installed properly, please read these instructions carefully before you begin. (Certain installations may require
professional help.) Also be sure your installation conforms to local codes.
!
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJ

Resumo do conteúdo contido na página número 2

6 7 RUBBER TANK MTG. GASKET BOLTS PRE- INSTALLED BOLT CAP WASHER NUT CLOSET FLANGE INSTALL TANK CLOSET BOLT a. Install large rubber gasket over threaded WASHER NUT outlet on bottom of tank and lower tank onto bowl so that tapered end of gasket fits INSTALL TOILET evenly into bowl water inlet opening, and tank mounting bolts go through mounting a. Position toilet squarely to wall and, with a rocking motion, holes. Secure with metal washers and nuts. press bowl down fully on wax ring and fl

Resumo do conteúdo contido na página número 3

10 11 ARM TOP REFILL TUBE NIPPLE ADJUSTMENTS a. Adjust water level. Water level TANK should be adjusted to level CRITICAL LEVEL LEVER MARK ("C.L.") Fig. 10A indicated on tank by adjusting float MUST BE 1" ABOVE cup. OVERFLOW PIPE "S" FLOAT CLIP CUP See Step 11 for water level FILL adjustment method VALVE FLUSH VALVE WATER LEVEL b. If bowl fails to siphon, an adjustment ADJUSTMENT CLIP may be required with the lift chain. LINK Simply remove the bead chain from VALVE the retainm

Resumo do conteúdo contido na página número 4

TROUBLESHOOTING FILL VALVE 13 IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY, repeat Step 13. IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE, it is a signal you are wasting water because: • The end of the refill tube is inserted into overflow pipe, below LIFT ARM LIFT ARM water level in tank. Attach refill tube to overflow pipe using "S" FIRST FIRST clip provided. • The flush valve is leaking because it's worn, dirty or misaligned with tank ball or flapper (replace with a n