Manual do usuário American Standard Standard Washstand 9440.000

Resumo do conteúdo contido na página número 1

THE
“”
™
COLLECTION
by
ASSEMBLY & INSTALLATION
INSTRUCTIONS
WASHSTAND
9440.000
Thank you for selecting our products...products which have been the benchmarks of fine quality for over 100 years.
To help insure that the installation process will proceed smoothly, please read these instructions carefully before you
begin. Also, review the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.
0283.008 STANDARD WASHSTAND TOP
Recommended Tools & Materials

Resumo do conteúdo contido na página número 2

1 Back Front WASHSTAND ASSEMBLY Thread the two legs with tapered upper ends into the threaded holes at the front of the cabinet. Thread the remaining legs into the two holes at the rear of the cabinet. Hand-tighten each of the four legs. Thread knobs onto drawer with screws provided. 2 C/L of 2 x 8 Support SINK AND WASHSTAND INSTALLATION and Bracket Note: If replacing an existing sink be certain to shut off water supply before removing old sink. If installing 30-3/4 " in a new bathroom

Resumo do conteúdo contido na página número 3

5 Connect the trap to drain assembly hand tight to check alignment. It may be necessary to cut off part of the tailpiece (area "B") or part of the horizontal leg of the trap (area "C"). C Connect hot and cold supply lines between the fitting valve and the supply B shut-off valves. Tighten trap joints for watertight assembly. Apply a bead of caulk around the back edge of the sink where it contacts the wall. CARE INSTRUCTIONS: Rinse the product clean with clear water. Dry with a soft cotto