Manual do usuário American Standard Williamsburg One-Piece Elongated Toilet 2038.700

Resumo do conteúdo contido na página número 1

T
H
I
S
S
WILLIAMSBURG 1.6 GPF ONE-PIECE TOILET
INSTALLATION
2038.700
INSTRUCTIONS
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product
is installed properly, please read these instructions carefully before you begin. (Certain installations may require
professional help.) Also be sure your installation conforms to local codes.
!
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pi

Resumo do conteúdo contido na página número 2

6 BOLT CAP BOLTS CLOSET FLANGE INSTALL TOILET a. Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Alternately tighten nuts until toilet is firmly seated on floor. ! CAUTION: DO NOT OVERTIGHTEN NUTS OR BASE MAY BE DAMAGED! b. Install caps on washers. (If necessary, cut bolt height to size before installing caps.) c. Smooth off the bead of sealant around base. Remove excess sealant. 7 INSTALL TOILET SEAT Install toilet seat in acc

Resumo do conteúdo contido na página número 3

ARM TOP 9 10 REFILL NIPPLE TUBE ADJUSTMENTS a. Adjust water level. Water level TANK CRITICAL LEVEL LEVER should be adjusted to level MARK ("C.L.") Fig. 10A MUST BE "S" indicated on tank by adjusting float 1" ABOVE CLIP OVERFLOW PIPE cup. FLOAT CUP See Step 10 for water level FILL VALVE adjustment method FLUSH VALVE WATER LEVEL ADJUSTMENT b. If bowl fails to siphon, an adjustment CLIP LINK may be required with the lift chain. Simply remove the bead chain from VALVE ADJUSTABLE

Resumo do conteúdo contido na página número 4

TROUBLESHOOTING 12 IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY, repeat Step 12. IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE, it is a signal you are wasting water because: • The end of the refill tube is inserted into overflow pipe, below LIFT ARM LIFT ARM water level in tank. Attach refill tube to overflow pipe using "S" FIRST FIRST clip provided. • The flush valve is leaking because it's worn, dirty or misaligned with tank ball or flapper (replace with a new flapper)