Manual do usuário Sony SU-WL700

Resumo do conteúdo contido na página número 1

A-DNT-00-  12()
Additional Information for
Using Sony Wall-Mount Bracket (SU-WL700)
Compatible TV models for this Wall-Mount Bracket information:
KDL-52NX807/KDL-52NX800/KDL-46NX807/KDL-46NX800/KDL-46NX705/
KDL-40NX705/KDL-46NX700/KDL-40NX700
For product protection and safety reasons, Sony strongly recommends that you use the
Wall-Mount Bracket model designed for your TV and that the wall-mounting of your TV
is performed by Sony dealers or licensed contractors.
To Customers
Please provide

Resumo do conteúdo contido na página número 2

Installing the Wall-Mount Bracket Install the Base Bracket and Mounting Bracket. 1 Open the Wall-Mount Bracket package and check for all the required parts along with the Instructions. 2 Decide where you want to install your TV. Refer to the TV installation dimensions table. Dimension Table Screen center point Unit: inches (mm) Model Name Display Screen center Length for each mounting angle dimensions dimensions Angle (0°) Angle (20°)         3 17 5 3 3 1 KDL- 49 / 31 / 16 / 3 15 / 29

Resumo do conteúdo contido na página número 3

4 Detach the Table-Top Stand from the TV, if necessary. Remove the bottom cover and terminal cover first before detaching the Table-Top Stand. Terminal cover Bottom cover Remove the screws guided by the arrow marks of the TV. ✍ • D o not remove the Table-Top Stand for any reason other than to install corresponding accessories on the TV. • W hen removing the Table-Top Stand from the TV, lay the TV face down on a stable work surface that is larger than the TV. • To prevent damaging the surface

Resumo do conteúdo contido na página número 4

6 Place the Spacers. (KDL-52NX80 * only)  Remove the four screws, and be sure to store them in a safe place, keeping them away from children.  Plac e the four spacers (supplied). * In the actual model names, the “ ” indicates numbers and/or characters specific to each model. 7 Attach the Mounting Bracket to the rear of the TV temporarily. Temporarily tighten the top of the Mounting Bracket using two screws (+PSW M6 × 6). Screw Mounting Bracket Mounting Bracket Additional Information f

Resumo do conteúdo contido na página número 5

8 Attach the Lock Bracket to the bottom of the Mounting Bracket.  Temporarily move the bottom of the Mounting Bracket outwards. ✍ • If the bottom of the Mounting Bracket does not move, loosen the screws (return to step 7).  Insert the pins of the Mounting Bracket through the holes of the Lock Bracket. Return the Mounting Bracket to their original position to attach the Lock Bracket.    Lock Bracket 9 Secure the Mounting Bracket to the rear of the TV. When using an electric screwdriver,

Resumo do conteúdo contido na página número 6

10 Adjust the angle of the Mounting Bracket. Use the supplied hexagon wrench. When installing the Display parallel to the wall (0 degrees), adjustment of the Mounting Bracket angle (procedures  and  below) is not necessary.  Remove the two angle adjusting screws from the Mounting Bracket.  Secure the screws to the corresponding holes for the desired angle (“ ,” “,” “0,” “” o  r “0”).  Hexagon wrench  ✍ • B e sure that both the left and right sides are set to the same angle, and