Resumo do conteúdo contido na página número 1
DVD DIGITAL THEATER SYSTEM
TH-M606/TH-M603
Consists of XV-THM606, SP-PWM606, SP-THM606F,
SP-THM606C and SP-THM606S/
Consists of XV-THM603, SP-PWM603, SP-THM606F,
SP-THM606C and SP-THM606S
The figure is for the TH-M606.
TH-M505/TH-M501
Consists of XV-THM505, SP-PWM505, SP-THM505F,
SP-THM505C and SP-THM505S/
Consists of XV-THM501, SP-PWM501, SP-THM303F,
SP-THM303C and SP-THM303S
The figure is for the TH-M505.
TH-M303/TH-M301
Consists of XV-THM303, SP-PWM303, SP-THM303F,
SP-THM303C and SP-THM3
Resumo do conteúdo contido na página número 2
Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS 1. CLASS 1 LASER PRODUCT 2. CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel. 3. CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure to beam. 4. REPRODUCTION OF LABEL: CAUTION LABEL, PLACED INSIDE THE UNIT. CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove
Resumo do conteúdo contido na página número 3
Warnings, Cautions and Others For Canada CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. For Canada THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE INTERFERENCE-CAUSING EQUIPMENT STANDARD ENTITLED “DIGITAL APPARATUS,” ICES-003 OF THE DEPARTMENT OF COMMUNICATIONS. Note to CATV system installer: This reminder is provided to call the CATV system installer’s attention to Secti
Resumo do conteúdo contido na página número 4
Table of contents Introduction .....................................2 Playback ........................................22 Notes on handling .................................................................2 Basic playback ....................................................................22 Supplied accessories ............................................................2 One Touch Replay ...............................................................24 Fast-forward/fast-reverse search ........
Resumo do conteúdo contido na página número 5
Introduction 7 Safety precautions Notes on handling Avoid moisture, water and dust Do not place the system in moist or dusty places. 7 Important cautions Avoid high temperatures Installation of the system Do not expose the system to direct sunlight and do not place it near • Select a place which is level, dry and neither too hot nor too cold; a heating device. between 5°C and 35°C (41°F and 95°F). • Leave sufficient distance between the system and the TV. When you are away • Do not use the sys
Resumo do conteúdo contido na página número 6
About discs • The following discs cannot be played back: DVD-ROM, DVD-RAM, SACD, CD-ROM, CD-I (CD-I Ready), Playable disc types Photo CD, etc. Playing back these discs will generate noise and damage the This system has been designed to play back the following discs: speakers. DVD VIDEO, DVD AUDIO, Video CD (VCD), Super Video CD • On some DVD VIDEOs, DVD AUDIOs, VCDs or SVCDs, (SVCD), Audio CD (CD), CD-R and CD-RW. their actual operation may be different from what is • This system accommodat
Resumo do conteúdo contido na página número 7
About discs Notes on MP3/WMA/JPEG/MPEG4 discs Notes on JPEG discs only • MP3/WMA/JPEG/MPEG4 discs (either CD-R or CD-RW) • We recommend to record a file at 640 x 480 resolution. (If a file require a longer readout time. (It differs due to the complexity of has been recorded at a resolution of more than 640 x 480, it will the directory/file configuration.) take a longer time to be displayed.) • When making an MP3/WMA/JPEG/MPEG4 disc, select ISO • This system can only play baseline JPEG files. 9
Resumo do conteúdo contido na página número 8
Description of parts and controls The illustrations of the center unit and the subwoofer used in this manual are of TH-M606 unless otherwise noted. Front panel (center unit) Display window pg. 24 pg. 26 pg. 43 pg. 23 pg. 27 pg. 33 pg. 23 pg. 23 pg. 23 pg. 42 pg. 43 pg. 35 pg. 20 pg. 23 pg. 23 pg. 25 pg. 42 pg. 22 pg. 22 pg. 22 pg. 24, 42 pg. 19 Disc tray (inside): pg. 22 pg. 19 pg. 18 Remote sensor: pg. 18 pg. 24 pg. 18 pg. 19 pg. 7 Rear panel (center unit) pg. 15 pg. 15 pg. 15 pg. 8 pg. 14 pg.
Resumo do conteúdo contido na página número 9
Description of parts and controls Powered subwoofer SP-PWM606/SP-PWM505/SP-PWM501 pg. 10, 12 POWER ON lamp: pg. 18 pg. 15 Power cord: pg. 15 Rear Front SP-PWM603/SP-PWM303/SP-PWM301 pg. 15 POWER ON lamp: pg. 18 pg. 11, 13 Power cord: pg. 15 Rear Front * Do not block the ventilation openings. NOTE • For safety reasons, always ensure that there is sufficient space behind the powered subwoofer. 6
Resumo do conteúdo contido na página número 10
Description of parts and controls Remote control Putting batteries in the remote control pg. 16 pg. 16 pg. 18 pg. 16, 17 pg. 22 R6P (SUM-3)/AA (15F) pg. 19 type dry-cell batteries (supplied) pg. 19 pg. 19 pg. 16 – 43 pg. 16 pg. 16 pg. 22 pg. 24, 42 pg. 22, pg. 22, 43 pg. 24 43 pg. 29 pg. 29 If the range or effectiveness of the remote control decreases, replace both batteries. pg. 20, 38 CAUTION • Do not expose batteries to heat or flame. pg. 27 pg. 17, 24 pg. 25 Operating the system from the re
Resumo do conteúdo contido na página número 11
Do not connect the power cord until all other connections have been made. Connections If reception is poor Connecting the FM and Center unit AM antennas AM loop antenna 7 AM loop antenna Setting up supplied AM loop antenna Outdoor single vinyl-covered wire antenna (not supplied) 7 FM antenna If the antenna cord is covered with the insulation coat, twist and pull the insulation coat off and FM antenna (supplied) remove. Center unit Extend the supplied FM antenna horizontally. Connecting AM l
Resumo do conteúdo contido na página número 12
Connections This page is for 2 Assembling the front and surround speakers The following procedure explains the front speaker assembly. The assembly of both the front and surround speakers are done in the Black same manner. Red Copper Silver Front speaker Surround speaker Stand ( 4) u ( 2) ( 2) u u Screw M5 x 20 mm (13/16 inch) (supplied) 3 Base plate ( 4) u Speaker Black NOTE • The stands and the base plates are commonly used for both front and White surround speakers assembly. Before assemb
Resumo do conteúdo contido na página número 13
Connections This page is for Connecting the satellite (front, center, surround) speakers Before connecting the speaker cords; Twist and pull the insulation coat off and remove. Powered subwoofer SP-PWM606 Speaker cord (supplied) • Connect the silver cords to the black (r) terminals. • Connect the copper cords to the (q) terminals referring to the table below: FRONT SPEAKERS (RIGHT) Red FRONT SPEAKERS (LEFT) White CENTER SPEAKER Green SURROUND SPEAKERS (RIGHT) Gray SURROUND SPEAKERS (LEFT) Blue
Resumo do conteúdo contido na página número 14
Connections This page is for Before connecting the speaker cords; Twist and pull the insulation coat off and remove. Speaker cord (supplied) • Connect the silver cords to the black (r) terminals. • Connect the copper cords to the (q) terminals referring to the table below: Powered subwoofer SP-PWM603 FRONT SPEAKERS (LEFT) White FRONT SPEAKERS (RIGHT) Red CENTER SPEAKER Green SURROUND SPEAKERS (LEFT) Blue SURROUND SPEAKERS (RIGHT) Gray Center speaker SP-THM606C Red Black Silver 4m (13feet) Copp
Resumo do conteúdo contido na página número 15
Connections This page is for Note that the illustration below is for TH-M505. Before connecting the speaker cords; Twist and pull the insulation coat off and remove. Powered subwoofer TH-M505: SP-PWM505 ( ) TH-M501: SP-PWM501 Speaker cord (supplied) • Connect the silver cords to the black (r) terminals. • Connect the copper cords to the (q) terminals referring to the table below: FRONT SPEAKERS (RIGHT) Red FRONT SPEAKERS (LEFT) White CENTER SPEAKER Green SURROUND SPEAKERS (RIGHT) Gray Front spe
Resumo do conteúdo contido na página número 16
Connections This page is for Before connecting the speaker cords; Twist and pull the insulation coat off and remove. Speaker cord (supplied) • Connect the silver cords to the black (r) terminals. • Connect the copper cords to the (q) terminals referring to the table below: FRONT SPEAKERS (LEFT) White FRONT SPEAKERS (RIGHT) Red CENTER SPEAKER Green SURROUND SPEAKERS (LEFT) Blue SURROUND SPEAKERS (RIGHT) Gray Front speakers SP-THM303F 4 m (13 feet) Powered subwoofer TH-M303: SP-PWM303 (TH-M301:
Resumo do conteúdo contido na página número 17
Connections Speaker layout Connecting a TV • You can get better picture quality in the order — Component Center speaker video > S-video > Composite video. Front left Front right • Distortion of picture may occur when connecting to the TV via a speaker speaker VCR, or to a TV with a built-in VCR. • You need to set “MONITOR TYPE” in the PICTURE menu Powered correctly according to the aspect ratio of your TV. (A pg. 39) subwoofer 7 To connect a TV equipped with the component video input jacks
Resumo do conteúdo contido na página número 18
Connections Connecting the powered Connecting to a digital subwoofer component You can enjoy the sound of a digital component. Powered Center unit Center unit subwoofer System cord (supplied) Align the 5 marks. or To digital optical output DBS* tuner MD recorder Digital optical cord (not supplied) Align the 5 marks. NOTE * DBS = Direct Broadcasting Satellite • The way of connecting the system cord varies depending on the type of the powered subwoofer. NOTE • Only digital audio signals can b
Resumo do conteúdo contido na página número 19
Operating external components with the remote control 4 Press number buttons (1-9, 0) to enter The buttons described below are used on pages 16 and the manufacturer’s code (2 digits). 17. Examples: For a Hitachi TV: Press 1, then 0. For a Toshiba TV: Press 0, then 8. Manufacturer Code Manufacturer Code JVC 01 Samsung 12 Hitachi 10 Sharp 06 Magnavox 02 Sony 07 Remote control Mitsubishi 03 Toshiba 08 mode selector Panasonic 04, 11 Zenith 09 RCA 05 (play button) 5 ReleaseF TV. If there is more t
Resumo do conteúdo contido na página número 20
See page 16 for button locations. Operating external components with the remote control 5 Press number buttons (1-9, 0) to enter 5 Press number buttons (1-9, 0) to enter the manufacturer’s code (2 digits). the manufacturer’s code (2 digits). Examples: Examples: For a GI Jerrold product: For a Philips VCR: Press 0, then 1. Press 0, then 9. For a Sony product: For an NEC VCR: Press 2, then 0. Press 2, then 5. Manufacturer Code Manufacturer Code Manufacturer Code Echostar 21 JVC 01, 02, 03 Philips
