Manual do usuário PYLE Audio PSWLE81

Resumo do conteúdo contido na página número 1

Pa Parrt t 5-Adjusting 5-Adjusting display display a and nd using using cor cord d management management
Route cords along articulating arms using cord management clips.
Articulating arms can be adjusted to position display into desired location.
Use wrench(8) to tighten and loosen the tension screw. Do not overtighten
or overloosen to make the screws come out.
INSTALLATION GUIDE
Item Item No.: No.:PSWLE81 PSWLE81
±180°
±180°
±180°
-5°~15°
±5°
Wrench 4x4
Thank Thank y you ou for for choosing cho

Resumo do conteúdo contido na página número 2

Har Hard dwar ware e Kit: Kit: P Pa art rt 4-Mounting 4-Mounting the the flat flat panel panel scr screen een 1 5 Hook the top of brackets(2) onto the top flange of wall plate(1). Then swing the screen down. Fixed slide block into wall plate by screw. 6 7 NOTE: NOTE: Always use an assistant or mechanical lifting equipment to safely lift and position heavy equipment. 4 8 2 7 6 Magnetic removable 3 bubble level A-D E F G H ID Qty Description ID Description Qty Wall plate A 4 M4×16mm bolt 1 1 2 2 B

Resumo do conteúdo contido na página número 3

Pa Parrt t 3-Attaching 3-Attaching brack brackets ets t to o s scr creen een Pa Part rt 1a- 1a-W Wood ood Stud Stud Mounting Mounting Center brackets vertically on back of screen. Select the small(A),medium Usewall plate(1)asatemplate,makesureitislevel,and mark three (B or C) or large(D) screws. Attach brackets to screen using four selected mounting holes on the wood studs. Drill three 3/16”(4.5mm)dia.holes 50 screws and four square washers(E) at the top and bottom of each bracket. mm deep. Leve

Resumo do conteúdo contido na página número 4

P Pa arrt t 1b- 1b-C Concr oncrete ete Wa Wall ll Mounting Mounting P Pa arrt t 2-Attaching 2-Attaching plastic plastic covers covers t to o wall wall plate plate Level wall plate and use wall as a template to mark three holes. Drill three Secure plastic covers over wall plate by pushing them toward each other 7/16”(10.5mm) dia. holes 58mm deep. Insert three anchors(H) into holes until they lock in place. and secure wall plate with three long bolts(G) and three washers(F).Tighten 5 screws firmly