Manual do usuário BEA FALCON

Resumo do conteúdo contido na página número 1

FALCON & FALCON XL
USER'S GUIDE
MOTION SENSORS FOR INDUSTRIAL DOORS

• FALCON: for high mounting • FALCON XL: for low mounting


Technology: Microwave and microprocessor Hold time: 0.5s to 9s (adjustable)
TECHNICAL
Transmitter frequency: 24.125 GHz Manual adjustment:
SPECIFICATIONS
Transmitter radiated power: <20 dBm EIRP • orientation of sensing field (mechanically)
Transmitter power density: < 5 mW/cm²
• multiple functions (by push buttons).
Mounting height
Remot

Resumo do conteúdo contido na página número 2

WIRING To remove or to insert the cable: • Unscrew the retaining nut; • Pass the cable through the grommet and the retaining nut. US Wire Color: Red Black White Green Yellow • Tighten the retaining nut. 12-24 VAC/DC COM NO NC European Wire Color: Brown Green White Yellow Gray Opening the sensor Closing the sensor OPENING AND CLOSING THE SENSOR

Resumo do conteúdo contido na página número 3

FALCON (Mounting height: 16.5 feet) SETTING THE SENSING 6 3 0 3 6 6 3 0 3 6 FIELD DIMENSIONS 3 3 3 3 6 6 6 6 9 9 9 9 12 12 12 12 15 15 15 15 The sensing fields here on the The sensing fields here on the right correspond to the right correspond to the following 18 18 18 18 following adjustments: adjus

Resumo do conteúdo contido na página número 4

1. DESCRIPTION OF THE INFRARED REMOTE CONTROL FUNCTIONS FUNCTIONS CONFIGURATION CONFIGURATION WITH REMOTE WITH REMOTE CONTROL CONTROL • Open the battery compartment at the back of the remote control; • Insert two AAA batteries supplied with the remote control as shown beside; • Close the batteries compartment. Remark: For optimum results point the remote control at the sensor before pressing its buttons. 2. CONFIGURATION OF THE SEN

Resumo do conteúdo contido na página número 5

During an adjustment session each parameter may be checked or changed at any time in the following way: PARAMETER USER'S ACTIONS KEY CHECK Press the Key (5,6,7,8,11) corresponding to the parameter to be checked and then press the CHECK VALUES Key VALUES (9). Count the number of times the green LED flashes, which correspond to the value of the checked parameter. No green LED flash corresponds to the value 0. Repeat this operation to check the value of the other parameters if requ

Resumo do conteúdo contido na página número 6

DETECTION 2 The red LED flashes quickly Press the DETECTION MODE key (7). MODE (Unidirectional waiting for the value. Use the NUMBER Keys 1-3 (1) to select the required mode: Approach) Once this has been entered, it Key 1: bi-directional flashes slowly again. Key 2: unidirectional approach Key 3: unidirectional depart Detection mode: 1-3 REJECTION Press the REJECTION MODE key (8). 1 The red LED flashes quickly MODE

Resumo do conteúdo contido na página número 7

During the manual adjustment session: • Each press on the right button increases the number of the displayed parameter by one unit; • Each press on the left button increases the value of the displayed parameter by one unit. NOTE: When the maximum value or the highest number of the parameter is reached, this will return to their minimum values. Parameter Parameter Values Factory setting Number 1 Sensitivity 0 - 9 7 2 Hold time 0 - 9 0 3 Relay configuration 1 - 4 1 4 Detection