Manual do usuário Telex PW24

Resumo do conteúdo contido na página número 1

PW24


2.4GHZ WIRELESS SYSTEM FOR
POLICE VIDEO RECORDING

USER GUIDE

Revision B Page 1 of 8 3/29/06

Resumo do conteúdo contido na página número 2

TABLE OF CONTENTS 1. Quick Set Up and Operation....................................................... 3 2. Installation.................................................................................... 4 3. Guidelines For Best Performance................................................ 5 4. Troubleshooting Guide................................................................. 6 5. Technical Specifications .............................................................. 7 6. Service and

Resumo do conteúdo contido na página número 3

QUICK SET UP AND OPERATION Synching Up The Transmitter and Base 1) Turn the transmitter power switch to on and place the transmitter in the recharge cradle of the base. The transmitter goes in the base with the beltclip facing out. 2) The recharge LED will light (Green if fully charged, Red if charging) and the In-Use Green LED on the base and transmitter will flash 3 times. 3) The transmitter and base are now synched and will continue to be until another transmitter is linked to that b

Resumo do conteúdo contido na página número 4

INSTALLATION 1. Wire the un-terminated signal wires to the control unit according to the signal chart. A 5 Amp fast blow fuse is recommend in the 12VDC power supply line to protect the equipment. Audio In 12 FT Description Color Power +12V DC Red Microphone Trigger Black (Ground = Transmitter On) Un-terminated wires Left Channel (Ground to Yellow enable Inside Microphone) Power Ground Orange AUX (Panic) Trigger 12V+ DC Output when EMG White but

Resumo do conteúdo contido na página número 5

4) Guidelines and recommendations for best performance. Compatibility The transmitter and receiver must synchronize to work together by placing the transmitter into the charging cradle while on. The In-Use LEDs will flash three times and the two are synchronized. Any PR24 can be synchronized with any PB24 base. Using Multiple Wireless Systems The PW24 system has 40 possible “channels” that are really different frequency hopping schemes. Each synchronized base and transmitter will

Resumo do conteúdo contido na página número 6

5) Trouble Shooting Guide Problem Possible Causes Solutions No audio and no In-Use LED Receiver is not powered Make sure that the power light on the receiver when supply is properly connected transmitter is on and In-Use Transmitter and receiver not Turn on transmitter and place synchronized in recharge cradle. In-Use LEDs should flash 3 times and the pair will be synched No (or low) Audio with all In- Lapel Microphone not connected Check the mic connection and Use LEDs solid gr

Resumo do conteúdo contido na página número 7

PR24 RECEIVER BASE STATION Indicators INUSE LED: GREEN CHARGE LED : CHARGING -> RED FULL CHARGED -> GREEN Connections In Car Mic 2.5mm Mono Plug Un-terminated Cord RED +12V DC Power BLACK Microphone Trigger (Ground = Transmitter On) WHITE AUX (Panic) Trigger (+12V when EMG is pushed) YELLOW Left Channel (Inside Mic) ORANGE Power Ground Audio Connector Tip Inside Car Mic Ring Transmitter Audio Sleeve Audio Groun

Resumo do conteúdo contido na página número 8

Factory Service (North America) If factory service is required, ship the unit prepaid in its original carton to: Telex Audio Service c/o Telex Communications 8601 East Cornhusker Highway Lincoln, NE 68507-9702 U.S.A. Tel: 402/467-5321 or 800-553-5992 Fax: 402/467-3279 Enclose a note describing the problem along with any other pertinent information and how to contact you. Warranty (Limited) Telex products are guaranteed against malfunction due to defects in materials or workmanship fo