Resumo do conteúdo contido na página número 1
GPS Navigator
GP-33
W3D
www.furuno.co.jp
Resumo do conteúdo contido na página número 2
The paper used in this manual is elemental chlorine free. ・FURUNO Authorized Distributor/Dealer 9-52 Ashihara-cho, Nishinomiya, 662-8580, JAPAN Telephone : +81-(0)798-65-2111 Fax : +81-(0)798-65-4200 A : JAN. 2010 All rights reserved. Printed in Japan C1 : JAN. 31, 2011 Pub. No. OME-44580-C1 (YOTA ) GP-33 *00017317712* *00017317712* **00017317712 00017317712** * 0 0 0 1 7 3 1 7 7 1 2 *
Resumo do conteúdo contido na página número 3
IMPORTANT NOTICE General • The operator of this equipment must read and follow the descriptions in this manual. Wrong op- eration or maintenance can cancel the warranty or cause injury. • Do not copy any part of this manual without written permission from FURUNO. • If this manual is lost or worn, contact your dealer about replacement. • The contents of this manual and equipment specifications can change without notice. • The example screens (or illustrations) shown in this manual can be differen
Resumo do conteúdo contido na página número 4
SAFETY INSTRUCTIONS Indicates a condition that can cause death or serious WARNING injury if not avoided. Indicates a condition that can cause minor or moderate CAUTION injury if not avoided. Safety Instructions for the Operator Safety Instructions for the Installer WARNING WARNING Turn off the power at the Do not disassemble or modify the equipment. switchboard before you install the equipment. Fire, electrical shock or serious Fire or electrical shock can occur if injury can occur. the pow
Resumo do conteúdo contido na página número 5
TABLE OF CONTENTS FOREWORD.................................................................................................................... v SYSTEM CONFIGURATION .......................................................................................... vi 1. OPERATIONAL OVERVIEW.................................................................................1-1 1.1 Controls ......................................................................................................................1
Resumo do conteúdo contido na página número 6
TABLE OF CONTENTS 5.2.2 How to set a destination waypoint through the list......................................... 5-2 5.3 How to Set Route as Destination ............................................................................... 5-2 5.4 How to Cancel Destination......................................................................................... 5-3 5.4.1 How to cancel destination with the cursor...................................................... 5-3 5.4.2 How to cancel destination
Resumo do conteúdo contido na página número 7
FOREWORD A Word to the Owner of the GP-33 Congratulations on your choice of the GP-33 GPS Navigator. For over 60 years FURUNO Electric Company has enjoyed an enviable reputation for innovative and dependable marine electronics is furthered by our extensive global network of agents and dealers. Your navigator is designed and constructed to meet the rigorous demands of the marine environ- ment. However, no machine can perform its intended function unless installed, operated and maintained prope
Resumo do conteúdo contido na página número 8
SYSTEM CONFIGURATION Standalone system Antenna Unit GPA-017 Navigation PC MOB Switch External Alarm Receiver Unit 12-24VDC GP-33 Standard configuration is shown with solid line. CAN bus network When optional junction box FI-5002 is connected Antenna Unit Navigation GPA-017 PC MOB Switch External Alarm FI-504/507 Receiver Unit GP-33 Junction Box FI-5002 12 VDC vi
Resumo do conteúdo contido na página número 9
SYSTEM CONFIGURATION When no FI-5002 is connected Antenna Unit GPA-017 Navigation PC MOB Switch External Alarm Receiver Unit GP-33 Backbone cable Category of Units Units Category Antenna Unit GPA-017 Exposed to weather Receiver Unit GP-33 Protected from weather Junction Box FI-5002 (Option) vii
Resumo do conteúdo contido na página número 10
SYSTEM CONFIGURATION This page is intentionally left blank. viii
Resumo do conteúdo contido na página número 11
B R 1. OPERATIONAL OVERVIEW 1.1 Controls W3D Key Description Selects display mode. DISP Sets destination. GO TO -Opens the Menu. (plotter and highway displays: twice, others: once) -Shows the zoom window (plotter and highway displays only). MENU ZOOM -Shifts the cursor. -Selects item on menus. (Cursorpad) -Long press: Turns power off. -Momentary press: Turns power on./Shows Brill window. -Long press: Inscribes MOB mark. WPT -Momentary press: Registers own boat position as MOB position. MOB -Long
Resumo do conteúdo contido na página número 12
1. OPERATIONAL OVERVIEW How to detach the hard cover from the unit Put your thumbs on the front and forefingers on the catches at the sides of the cover, and pull it toward you. Catches 1.2 How to Turn Power On/Off 1. Press the /BRILL key to turn on the power. The unit beeps and then starts up with the last-used display mode. Your equipment takes about 90 seconds to find its position. The equipment shows receiver status indication at the top left-hand corner in most display modes. The table
Resumo do conteúdo contido na página número 13
1. OPERATIONAL OVERVIEW 1.3 How to Adjust LCD and Key Panel Brilliance 1. Press the /BRILL key to show the following window. 2. To adjust the LCD brilliance, press /BRILL key. The setting changes “0 →1 →…→7 →6…0 →1…” continuously. Maximum setting is 7. You can use also the cursorpad ( , ) to adjust the brilliance. 3. To adjust the panel brilliance, press the cursorpad ( , , max: 7). 4. Press ENT or MENU/ZOOM key. 1.4 Display Modes Your unit has seven display modes: Plotter Display, Highway
Resumo do conteúdo contido na página número 14
1. OPERATIONAL OVERVIEW Plotter Display The plotter display traces own boat’s track. Cursor (displayed for approx. Waypoint mark seven seconds) (Shape selectable) Receiver status Own boat mark Course bar N 34 08.375 Horizontal display range scale Lat/Lon grids Range to cursor* N 34 08.250 Boat’s track Bearing to cursor* 92 E 135 09.500 E 135 09.750 Cursor position (Own boat position when cursor is not displayed.) *:COG and SOG replace bearing to cursor and range to cursor when the cursor is n
Resumo do conteúdo contido na página número 15
1. OPERATIONAL OVERVIEW Highway Display The highway display provides a 3-D view of own boat’s progress toward destination. XTE (Cross-track error) scale and arrow mark Arrow shifts with boat’s XTE. When the arrow is aligned with the center line the boat is on course. The arrow blinks if boat’s XTE is greater than XTE scale range. “N (North)” is displayed, instead of the arrow, at the center of the scale when no destination is set. Direction to steer (to return to course) Bearing from : St
Resumo do conteúdo contido na página número 16
1. OPERATIONAL OVERVIEW Steering Display The steering display provides steering information. Speed over ground Bearing reference; Time MAG(netic) or TRUE Receiver status Bearing destination Bearing scale Own boat mark Course over ground 14.6 300 Bearing to 0.46 299 the destination 12/11/09 00 15 17:57:40 Time-To-Go to destination Estimated Time of Range from Arrival at destination own boat to destination Nav Data Display Receiver status Date and time 34 44.589 N Position in latitude and lo
Resumo do conteúdo contido na página número 17
1. OPERATIONAL OVERVIEW Satellite Monitor Display The satellite monitor display shows the condition of GPS and GEO (WAAS) satellites. Number, bearing and elevation angle of all GPS and GEO satellites (if applicable) in view of your receiver appear. Elevation 45 Receiver status DOP value 11 02 05 1.60 08 Receiver 11 signal level 13 GEO satellite 05 05 Bars show 15 08 02 02 22 signal level. 17 13 Satellites 22 17 whose signal 25 32 level are high 28 25 30 are used in 30 fixing position. 32 1
Resumo do conteúdo contido na página número 18
1. OPERATIONAL OVERVIEW 1.5 Menu Overview Most operations of your unit are done through the menu. Below is a quick introduction to how to select a menu and change menu settings. If you get lost in operation, press the MENU/ZOOM key to return to the main menu. 1. Press the MENU/ZOOM key once or twice to display the main menu. Press once: Steering display, nav data display, satellite monitor display, user dis- play 1/2. Press twice: Plotter display, highway display Note: Following explanation
Resumo do conteúdo contido na página número 19
1. OPERATIONAL OVERVIEW How to enter alphanumeric data Some menu operations require you to enter alphanumeric data (A to Z, 0 to 9) and symbols (&, _, #,’ , -, > and space). The procedure which follows shows how to enter alphanumeric data. For example, to change the waypoint name “WP0006” to “KOBE”, do the follows: Cursor 1) Press or to select “K”. 2) Press , and press or to select “O”. 3) Press , and press or to select “B”. 4) Press , and press or to select “E”. 5) Press , and p
Resumo do conteúdo contido na página número 20
1. OPERATIONAL OVERVIEW Shortest course from own MOB mark boat to MOB position (blue) (red) N 34 08.500 N 34 08.375 0.20 95 E 135 09.750 E 135 10.000 Bearing from own boat to MOB position Range from own boat to MOB position 1-10
