Manual do usuário 321 Studios W-505

Resumo do conteúdo contido na página número 1

™
W-505
W-505™ Control includes all of the standard features, in a new design that is
compatible with a number of Casablanca fan Models . The W-505™ hand-held
remote provides three forward or reverse fan speeds, full spectrum light dimming
and has an optional wall bracket. The W-505™ may be used alone to control
several fans or with extra controls to operate a single fan from different locations.
W-505
(Transmitter)
W-505™ INSTALLATION
SCREW
WOOD SCREW
3
6-32 X /8” (2)
12V BATTERY 1” (2)
W-505

Resumo do conteúdo contido na página número 2

Wall Controls - CONTINUED ™ W-505 W-505™ CONTROL BRACKET INSTALLATION Wall Installation Step A. Locate a 2x4 wall stud Note: The wall anchors and 6-32 x 1” in a convenient location. screws may be used in situations where Step B. Orient the control mounting to a stud is not possible. Use the bracket as shown over the 2x4 inner mounting holes. After securing the stud. anchor, discard the anchor’s pointed Step C. Use the 1” wood screws and use the 6-32 decor ovalhead screws in either the inner or s

Resumo do conteúdo contido na página número 3

Wall Controls - CONTINUED ™ W-505 W-505™ PLACING CONTROL ON TO THE HOLDER Control Storage Angle control in top first until the unit can be gently pushed back and snapped into place. Removing Control Gently Pull the lower edge of the control out from the holder. W-505™ OPERATION Fan Control To start the fan. Press the selected speed but- ton to run the fan at the desired speed. •=Low speed ••=Medium speed •••=High speed To turn off the fan. Press the FAN OFF button. Airflow Direction To rev

Resumo do conteúdo contido na página número 4

CHECKING THE SWITCH SETTINGS Note: All fans leave the factory set to “0000.” You will only have to change the dip switch settings in the remote if you are using more than one fan in the same area and want to control them separately. Dip Switch Dip Switch Set to “0101” Set to “1000” Step 1. At the circuit breaker or fuse box, turn the power off for the fan you want to change. Step 2. Open the battery door of the Prime•Touch control and remove the batteries. Step 3. Change the dip switch settings,

Resumo do conteúdo contido na página número 5