Manual do usuário Fireboy- Xintex, LTD Tach Tape TT-100

Resumo do conteúdo contido na página número 1

TT-100
TachTape
'-.-/
INSTRUCTIONS
SPECIFICATIONS
-30 F to +160 F. (-35 C to +70 C)
Temperature range:
Gear pitch equivalent: approximately 7 dlametral pitch.
100 feet
(30 meters)
Maximumcontinuous len2th:
Caution: Do not expose tape to strong AC or DCmagnetic fields and use only with Dynalco
magnetic pickups.
FUNCTION:
Provides a convenient, simple and low-cost means to activate Dynalco magnetic pickups in
speed and frequency measurements.
USE:
An inexpensive substitute for large split gears, s

Resumo do conteúdo contido na página número 2

200V PfAK 500 INCHE~!5ECOND ro ~ ~ PfOK (1270 CM/SECOND) '-"" 100K LOAD I50V 100V GEAR PITCH IS THE NUMBER OF TEETH PER INCH OF DIAMETER, AND IS A MEASURE OF TOOTH SIZE. " " '" .. 2 " " ~ 5OV , '" ~ 0 ~ m 10 ~.5 '"r .., 0 100 IN 0.120 INCHES 0.060 IN 0060 IN 0 0.020 IN 0040 IN AIR GAP "-" Fi gl.}re 1 amv TO APPLY AND USE TACH TAPE The following procedure should be used: 1. Clean the surface area of the shaft, approximately 2 inches wide, to remove dust, dirt, oil, rust, etc. Use a cleaner such a

Resumo do conteúdo contido na página número 3

AVAILABLE FROM AETNA ENGINEERING 800-776-7962 INCORRECT JOINT JOINT CQRRECT I :--'A> REINFORCING TAPE IMPORTANT. " " .. DIMENSION c TO BE: A MINIMUM OF 3/16 (4.8mm. ) Figure 2 Model TT-100i Tach Tape REINFORCING TAPE END .2 INCHES 1/16 INCH (5.0 mmJ (1.6 mm) l7 r---'-- I INCH (254 mm) L_- TAPE :..--- I .25 INCHES-,o SHAFT ROTATION (6.4 mm) .45 INCHES 111.4mm) Figure 4 Figure 3