Manual do usuário Edelbrock Honda XR400

Resumo do conteúdo contido na página número 1

INSTRUCTION SUPPLEMENT FOR
1996 and Later Honda XR400 &
1988 and Later Honda XR600



Removing stock carburetor and cables.



1. Remove seat and gas tank. Make sure fuel
petcock is in “off” position.

Figure 1.
2. Remove throttle cables paying close

attention to routing, as the new cables will
11. Align carburetor as close to vertical as
need too be routed the same.
possible and tighten manifold clamp.
3. Remove stock carburetor and stock throttle

housing.
12.

Resumo do conteúdo contido na página número 2

Motor will not fire with a few kicks, open idle cable ½ turn and repeat starting process. NOTE: If flooding occurs, slowly open throttle to wide open and hold. With throttle still open, hold decompression lever and kick motor through 5-10 times. Release throttle and decompression lever and proceed with normal starting procedure. For any questions regarding tuning or installation of Edelbrock products, please call our toll free tech line M-F 8:00am-12: 30pm, 1:30pm-5:00pm PS