Resumo do conteúdo contido na página número 1
OWNER’S MANUAL
PLASMA TV
Please read this manual carefully before operating
your TV and retain it for future reference.
50PB560B 50PB5600
60PB5600
*MFL68040802*
P/NO : MFL68040802 (1312-REV00) www.lg.com
Resumo do conteúdo contido na página número 2
ENGLISH IMPORTANT SAFETY INSTRUCTIONS 2 IMPORTANT SAFETY INSTRUCTIONS Always comply with the following precautions to avoid dangerous situations and ensure peak performance of your product. Read these instructions. WARNING/CAUTION Keep these instructions. Heed all warnings. RISK OF ELECTRIC SHOCK DO NOT OPEN Follow all instructions. TO REDUCE THE RISK OF ELECTRIC Do not allow the television to become wet. y SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO
Resumo do conteúdo contido na página número 3
ENGLISH IMPORTANT SAFETY INSTRUCTIONS 3 Protect the power cord from being walked on CAUTION concerning the Power Cord y y or pinched particularly at plugs, convenience (Can differ by country): receptacles, and the point where they exit It is recommended that appliances be from the apparatus. placed upon a dedicated circuit; that is, a single outlet circuit which powers only that appliance and has no additional outlets or branch circuits. Check the specification page of this owner’s man
Resumo do conteúdo contido na página número 4
ENGLISH IMPORTANT SAFETY INSTRUCTIONS 4 Grounding Cleaning y y (Except for devices which are not grounded.) When cleaning, unplug the power cord and Ensure that you connect the earth ground wipe gently with a soft cloth to prevent wire to prevent possible electric shock scratching. Do not spray water or other (i.e. a TV with a three-prong grounded AC liquids directly on the TV as electric shock plug must be connected to a three-prong may occur. Do not clean with chemicals such grounded AC
Resumo do conteúdo contido na página número 5
ENGLISH IMPORTANT SAFETY INSTRUCTIONS 5 Dot Defect y For USA and Canada The panel is a high technology product with resolution of two million to six million pixels. FCC NOTICE In a very few cases, you could see fine dots on the screen while you’re viewing the TV. This equipment has been tested and found Those dots are deactivated pixels and do not to comply with the limits for a Class B affect the performance and reliability of the digital device, pursuant to Part 15 of the TV. FCC Rul
Resumo do conteúdo contido na página número 6
ENGLISH LICENSES / OPEN SOURCE SOFTWARE NOTICE 6 LICENSES Supported licenses may differ by model. For more information about licenses, visit www.lg.com. Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories. The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI logo are trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries. OPEN SOURCE SOFTWARE NOTICE To obtain
Resumo do conteúdo contido na página número 7
ENGLISH ASSEMBLING AND PREPARING 7 ASSEMBLING AND PREPARING Unpacking Check your product box for the following items. If there are any missing accessories, contact the local dealer where you purchased your product. The illustrations in this manual may differ from the actual product and item. CAUTION y Do not use any unapproved items to ensure the safety and product life span. y Any damages or injuries by using unapproved items are not covered by the warranty. y Some models appear to have a t
Resumo do conteúdo contido na página número 8
ENGLISH ASSEMBLING AND PREPARING 8 NOTE How to use the ferrite core (Depending upon model) y - If there are two ferrite cores, follow as shown in Figure 1. - If there are three ferrite cores, follow as shown in Figures 1 & 2-1 (or 2-2). 1. Use the ferrite core to reduce the electromagnetic interference in the power cable. Place the ferrite core close to the TV and a wall plug. Wind the power cable on the ferrite core once. [to a wall plug] [to the TV] (Black) [Cross Section of [Figure 1]
Resumo do conteúdo contido na página número 9
ENGLISH ASSEMBLING AND PREPARING 9 Lifting and moving the TV Parts and Buttons When moving or lifting the TV, read the Screen following to prevent the TV from being scratched or damaged and for safe transportation regardless of its type and size. CAUTION y Avoid touching the screen at all times, as this may result in damage to the screen. y Do not place the product on the floor with its front facing down. Failure to do so may result in damage to the screen. y It is recommended to move the
Resumo do conteúdo contido na página número 10
ENGLISH ASSEMBLING AND PREPARING 10 Using the joystick button You can operate the TV by pressing the button or moving the joystick left, right, up, or down. Basic Functions When the TV is turned off, place your finger on the joystick button, Power On press it once and release it. When the TV is turned on, place your finger on the joystick button, Power Off press it once for a few seconds and release it. If you place your finger over the joystick button and move it left or Volume Control right
Resumo do conteúdo contido na página número 11
ENGLISH ASSEMBLING AND PREPARING 11 Setting up the TV You can mount your TV to a wall or attach the stand if you wish to place the TV on an entertainment center or other furniture. Attaching the stand If you are not mounting the TV to a wall, use the following instructions to attach the stand. Before assembling, attach the Stand 1 3 Sticker under the Stand Body to reduce the electromagnetic interference as shown below. (Depending upon model) 4 EA M4 x L14 Stand Sticker Stand Body Front Stan
Resumo do conteúdo contido na página número 12
ENGLISH 10 cm 10 cm 10 cm (4 inches) ASSEMBLING AND PREPARING 12 Securing the TV to a wall (optional) Mounting on a table (Depending upon model) 1 Lift and tilt the TV into its upright position on a table. - Leave a 10 cm (4 inches) (minimum) space from the wall for proper ventilation. Insert and tighten the eye-bolts, or TV 1 brackets and bolts on the back of the TV. 2 Connect the power cord to a wall outlet. - If there are bolts inserted at the eye-bolts position, remove the bolts first.
Resumo do conteúdo contido na página número 13
ENGLISH 10 cm 10 cm 10 cm 10 cm (4 inches) ASSEMBLING AND PREPARING 13 Mounting on a wall CAUTION y Disconnect the power before moving or An optional wall mount can be used with your installing the TV. Otherwise electric shock LG Television. Consult with your local dealer for may occur. a wall mount that supports the VESA standard y If you install the TV on a ceiling or slanted used by your TV model. Carefully attach the wall, it may fall and result in severe wall mount bracket at the r
Resumo do conteúdo contido na página número 14
ENGLISH MAKING CONNECTIONS 14 MAKING CONNECTIONS You can connect various external devices to the TV. Supported external devices are: HD receivers, DVD players, VCRs, audio systems, USB storage devices, PC, gaming devices, and other external devices. For more information on external device’s connection, refer to the manual provided with each device. NOTE y If you record a TV program on a DVD recorder or VCR, make sure to connect the TV signal input cable to the TV through a DVD recorder or VC
Resumo do conteúdo contido na página número 15
ENGLISH RED RED WHITE WHITE YELLOW YELLOW RED RED WHITE WHITE RED RED BLUE BLUE GREEN GREEN MAKING CONNECTIONS 15 Other connections Connect your TV to external devices. For the best picture and audio quality, connect the external device and the TV with the HDMI cable as shown. Depending upon the model, a cable may be provided. USB HDMI DVD / Blu-Ray / HD Cable Box / HD STB / PC AUDIO OUT ANTENNA/ DVI OUT CABLE IN OPTICAL DIGITAL AUDIO OUT VIDEO L/MONO-AUDIO-R OPTICAL AUDIO IN Y PB PR PC-AUD
Resumo do conteúdo contido na página número 16
ENGLISH REMOTE CONTROL 16 REMOTE CONTROL The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully and use the TV correctly. To install batteries, open the battery cover, replace batteries (1.5 V AAA) matching the and ends to the label inside the compartment, and close the battery cover. Failure to match the correct polarities of the battery may cause the battery to burst or leak, resulting in fire, personal injury, or ambient pollut
Resumo do conteúdo contido na página número 17
ENGLISH SETTINGS 17 To set advanced control SETTINGS ➾ ➙ ➙ SETTINGS PICTURE Picture Mode Advanced Control / Expert Control For each picture mode, screen can be To set up the channels automatically calibrated; or for a special screen, picture ➾ ➙ SETTINGS CHANNEL Auto Tuning settings can be adjusted. Memorizes automatically the channels being Select the desired Picture Mode. broadcast. y Dynamic Contrast : Adjusts the contrast to y The channels will not be memorized properly the optimal
Resumo do conteúdo contido na página número 18
ENGLISH SETTINGS 18 To set additional picture options To set the caption ➾ ➙ ➙ ➾ ➙ SETTINGS PICTURE Picture Mode SETTINGS OPTION Caption Picture Option View captions when the TV station provides Adjusts detailed setting for images. captioned programming. Program captions work only on digital/analog broadcasts or external y Noise Reduction : Eliminates noise in the input. picture. y MPEG Noise Reduction : Eliminates noise Change Caption to On and select caption generated while creating
Resumo do conteúdo contido na página número 19
ENGLISH SETTINGS / TO SEE WEB MANUAL 19 To remove the USB device Supported Photo Formats ➾ y Category : 2D (jpeg, jpg) Q.MENU Eject USB [Available file type] Select a USB storage device and remove it. SOF0: baseline, Once the message that the USB device was SOF1: Sequential, removed is displayed, remove the device from SOF2: Progressive the TV. [Photo size] y After selecting to remove USB device, the Minimum: 64 x 64 USB storage Device cannot be read. Remove Maximum: Normal Type:
Resumo do conteúdo contido na página número 20
ENGLISH SPECIFICATIONS 20 SPECIFICATIONS Product specifications may be changed without prior notice due to upgrade of product functions. Power requirement AC 110 - 240 V ~ 50 / 60 Hz Television System NTSC-M, ATSC, 64 & 256 QAM Program Coverage VHF 2-13, UHF 14-69, CATV 1-135, DTV 2-69, CADTV 1-135 External Antenna Impedance 75 Ω Environment Operating Temperature 0°C ~ 40 °C (32 °F ~ 104 °F) condition Operating Humidity Less than 80 % Storage Temperature -20°C ~ 60 °C (-4 °F ~ 140 °F) Storage Hu
