Manual do usuário Metra Electronics 99-9100

Resumo do conteúdo contido na página número 1

INSTALLATION INSTRUCTIONS FOR PART 99-9100
APPLICATIONS
AUDI
A4/A6/A8 1996-1999
TT 2001-2006
99-9100
KIT FEATURES
• DIN Mount Radio Provision
KIT COMPONENTS
A) Trim Plate “A” • B) Trim Plate “B”
A
B
TOOLS REQUIRED:
Small Flat Blade Screwdriver • Panel Removal Tool
• 86-9001-Head Unit Removal Keys
www.metraonline.com
1-800-221-0932
© COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORATION

Resumo do conteúdo contido na página número 2

99-9100 TABLE OF CONTENTS Dash Disassembly - A4 1996-1999 . . . ............................................ 1 - A6 1996-1999 . . . ............................................ 1 - A8 1996-1999 . . . ............................................ 1 - TT 2001-2006. ..... ............................................ 1 Kit Assembly - DIN Mount Radio Provision . . ............................... ...... 2 Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Resumo do conteúdo contido na página número 3

99-9100 DASH DISASSEMBLY AUDI A4/A6/A8 1996-1999 TT 2001-2996 A 1 Disconnect the negative battery ter- minal to prevent an accidental short circuit. 2 Insert the long ends of Metra's 86-9001 into the slots in the factory head unit and pull the unit out. Disconnect the wiring. (Figure A) Continue to kit assembly. 1

Resumo do conteúdo contido na página número 4

99-9100 KIT ASSEMBLY DIN MOUNT RADIO PROVISION WITH POCKET *Note: Refer also to the instructions included with the aftermarket radio. A 1 Slide the DIN cage into the radio open- ing and secure by bending the metal locking tabs outward. (Figure A) 2 Make wire connections as described on the next page. 3 Slide the radio into the DIN cage until it snaps into place. (Figure B) 4 Attach the trim plate to the front of the radio. (Figure C) B C 2

Resumo do conteúdo contido na página número 5

99-9100 WIRING WIRING A (A) Strip wire ends back 1/2" B B) Twist ends together C) Solder D) Tape C D 1 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individ- ually tape off the ends of any unused wires to prevent electrical short circuit.) 2 Re-connect the negative battery terminal and test the unit for proper operation. FINAL WIRING CONNECTIONS Make wiring connections using the EIA color code chart

Resumo do conteúdo contido na página número 6

99-9100 NOTES 4

Resumo do conteúdo contido na página número 7

99-9100 NOTES 5

Resumo do conteúdo contido na página número 8

99-9100 INSTRUCTIONS 1-800-221-0932 www.metraonline.com REV. 12/11/07 © COPYRIGHT 2004-2007 METRA ELECTRONICS CORPORATION INST99-9100