Manual do usuário Campbell Hausfeld TL1017

Resumo do conteúdo contido na página número 1

OPERATING INSTRUCTIONS
CAMPBELL
IMPACT WRENCH
HAUSFELD
MODELS TL1002, TL1017 AND TL1049
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE
PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMA-
TION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR
PROPERTY DAMAGE. RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
Description
General Safety (Continued)
Do-It-Yourself (DIY) impact wrenches are air tools
9. Always use attachme

Resumo do conteúdo contido na página número 2

IN230000AV MODELS TL1002, TL1017 AND TL1049 Operation (Continued) OIL PORT OIL PORT ANVIL HOLE ON REMOVE HOLE EXHAUST ANVIL BACK SIDE SCREW FOR PORT OIL PORT UNDER- HOLE FORWARD NEATH LEVER EXHAUST ANVIL FORWARD/ EXHAUST PORT PORT REVERSE FORWARD/ SWITCH REVERSE TRIGGER BUTTON TRIGGER REVERSE 1/4" NPT REGULATOR REGULATOR LEVER FEMALE 1/4" NPT FEMALE 1/4" NPT FEMALE REGULATOR AIR INLET AIR INLET AIR INLET MODEL MODEL MODEL TL1002 TL1049 TL1017 Figure 1 Impact Wrench Features the air motor and

Resumo do conteúdo contido na página número 3

IN230000AV MODELS TL1002, TL1017 AND TL1049 Operation (Continued) FILTER QUICK QUICK OILER AIR SUPPLY QUICK COUPLER COUPLER CONNECTOR (OPTIONAL) LEADER QUICK REGULATOR REGULATOR (WHIP) CONNECTOR HOSE (OPTIONAL) AIR DRAIN (WATER TRAP) HOSE AIR INLET (OIL HERE DO NOT INSTALL A DAILY IF NOT USING QUICK COUPLER HERE AIR TOOL MANUFACTURERS RECOMMEND THAT AN AIR FIL- AN AIR TOOL OILER) TER AND OILER BE USED TO INCREASE THE LIFE OF THE TOOL. Figure 2 - Air Hose Hook-up SPEED ADJUSTMENT ! WARNING ! The

Resumo do conteúdo contido na página número 4

IN230000AV MODELS TL1002, TL1017 AND TL1049 General Troubleshooting Guide SYMPTOM POSSIBLE CAUSE (S) CORRECTIVE ACTION Tool runs slowly or will 1. Grit or gum in tool. 1. Flush the tool with Campbell Hausfeld air tool oil, gum not operate. solvent, or an equal mixture of SAE 10 motor oil and kerosene. If Campbell Hausfeld oil is not used, lubricate the tool after cleaning. 2. No oil in tool. 2. Lubricate the tool according to the lubrication instructions in this manual. 3. Low air pressure. 3.a.