Manual do usuário Havis-Shields Computer Laptop Mount and Accessories C-3089's

Resumo do conteúdo contido na página número 1

INSTALLATION INSTRUCTIONS C-3090’s & C-3089’s
COMPUTER LAPTOP MOUNT AND ACCESSORIES

TOOLS NEEDED:
Ratcheting wrench Allen wrench set
Standard socket set Screwdriver set
Open-end wrench set
Always!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
For product support, visit the Install Instructions Section of our website at

Resumo do conteúdo contido na página número 2

Photo #3 3. ADJUST C-3090 PLATFORM FOR SPECIFIC LAPTOP: • The C-3090 will need to be adjusted to properly hold your particular laptop. Note: Do not adjust the latch on the underside of the laptop. • Loosen the “L” clamps on the sides of the C-3090. (Photo #4) • Release the latch on the underside of the laptop. • Place laptop on top of C-3090 platform and close the latch. • Open laptop and adjust “L” clamps so they are firm against inside lip of computer on the latch side.

Resumo do conteúdo contido na página número 3

• Loosen ¼-20 nylock nuts on the plate on underside of laptop assembly and adjust to width of laptop. • Adjust “L” brackets to clamp the laptop firm. • Release latch and test for strength. Adjust if necessary. Photo #4 #2 #1 Photo #5 4. PLATFORM WIDENING INSTRUCTIONS: (Photo #5) • On larger laptops, it may be necessary to use a different hole pattern on the plate. • Remove (#1 in photo #5) ¼” nylock nuts and washers • Remove (#2 in photo #5) bracket and use alternate mounting holes

Resumo do conteúdo contido na página número 4

6. MOUNTING C-TMLOCK • Photo #7 shows the C-TMLOCK option, which comes assembled from the factory if ordered with the C-3090. • Remove 8-32 keps nuts that hold down OEM latch on laptop computer mount. • Remove Pem studs from laptop computer mount and replace with Pem studs included with C-TMLOCK assembly. • Move latch out of way and place C-TMLOCK over Pem studs. Place latch over top of C-TMLOCK. • Install keps nuts and tighten. Photo #7 7. MOUNTING C-ML-MLB TO C-3090 (Photo #8