Resumo do conteúdo contido na página número 1
INSTRUCTION MANUAL
DISHWASHER
Resumo do conteúdo contido na página número 2
Contents 1. Safety and operating instructions __________________________ 38 2. Installation and hook-up__________________________________41 3. Description of the controls ________________________________ 45 4. Operating instructions ___________________________________ 56 5. Cleaning and maintenance _______________________________ 64 6. Troubleshooting ________________________________________ 68 Thank you for choosing this product. We advise you to carefully read all the instructions contained i
Resumo do conteúdo contido na página número 3
Safety instructions 1. Safety and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLIANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULLY READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED BY A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC USE, AND COMPLIES WITH THE EEC DIRECTIVES 73/23, 89/336 (INCLUDING 92/31 AND 93/68) CURRE
Resumo do conteúdo contido na página número 4
Safety instructions THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT (WEEE). BY ENSURING THIS PRODUCT IS DISPOSED OF CORRECTLY, YOU WILL HELP PREVENT POTENTIAL NEGATIVE CONSEQUENCES FOR THE ENVIRONMENT AND HUMAN HEALTH, WHICH COULD OTHERWISE BE CAUSED BY INAPPROPRIATE WASTE HANDLING OF THIS PRODUCT. THE SYMBOL ON THE PRODUCT, OR ON THE DOCUMENTS ACCOMPANYING THE PRODUCT, INDICATES THAT THIS APPLIANCE MAY NOT BE TREATED
Resumo do conteúdo contido na página número 5
Safety instructions DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE. KNIVES AND OTHER SHARP-POINTED KITCHEN UTENSILS MUST BE PLACED IN THE CUTLERY BASKET WITH THEIR TIPS FACING DOWNWARD. AQUASTOP MODELS THE AQUASTOP DEVICE PREVENTS FLOODING IN THE EVENT OF A WATER LEAK. WHEN THE AQUASTOP DEVICE IS TRIPPED, CALL IN A QUALIFIED TECHNICIAN TO IDENTIFY AND REPAIR THE FAULT. IN MODELS EQUIPPE
Resumo do conteúdo contido na página número 6
Installation instructions 2. Installation and hook-up Remove the polystyrene basket retainers. Position the appliance in the desired place of installation. The back or sides of the dishwasher may be placed up against walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent overheating and malfunction of the appliance. To ensure stability, install integrated or built-under dishwashers only under continuous worktops, an
Resumo do conteúdo contido na página número 7
Installation instructions 2.1 Water supply connection Preventing the risk of clogging or damage: if the water pipe is new or has not been used for a long time, before connecting to the water supply check that the water is clear and free of impurities, to prevent damage to the appliance. The dishwasher must always be connected to the water system with new hoses; old or used hoses must never be reused. CONNECTING TO THE WATER SUPPLY Connect the intake hose to a cold water supply with ¾” gas
Resumo do conteúdo contido na página número 8
Installation instructions IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD: IT IS NECESSARY TO INSTALL IN THE FIXED WIRING AN ALL-POLE DISCONNECTION DEVICE HAVING A GAP BETWEEN CONTACTS OF AT LEAST 3.5MM. AFTER INSTALLATION THE DISCONNECTION DEVICE HAS TO BE EASY TO REACH. THE CONNECTION TO THE MAINS MUST BE CARRIED OUT BY A QUALIFIED TECHNICIAN IN ACCORDANCE TO THE SCHEME SHOWN BELOW AND THE REGULATIONS IN FORCE. L = brown N = blue = yellow-green In the event of damage to
Resumo do conteúdo contido na página número 9
Installation instructions FOR UK ONLY: THIS APPLIANCE MUST BE EARTHED. Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse cover A and fuse B. 2. Fit replacement 13A fuse into fuse cover. 3. Refit both into plug. The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be
Resumo do conteúdo contido na página número 10
User instructions 3. Description of the controls 3.1 Upper panel All the dishwasher controls are grouped on the upper panel. Switch-on, programming, switch-off etc. procedures are only possible when the door is open. 1 79 6 8 11 10 2 3 4 5 auto Extra BIO 60° Extra smeg 3/1 auto 50° Extra BIO Extra smeg 3/1 ON/OFF BUTTON 1 Pressing this button energises the appliance. SELECTED PROGRAM INDICATOR LIGHTS 2 Illumination of this light denotes the program selected and the occurrence of a fault
Resumo do conteúdo contido na página número 11
User instructions "3/1" OPTION BUTTON 8 Press this button to activate the option for use of 3/1 products. "3/1" OPTION LIGHT 9 Illuminates to indicate that the function is activated. PROGRAM DELAY BUTTON 10 Press this button to delay the start of the program by up to 9 hours. 11 INFORMATION DISPLAY SETTING THE WASHING PROGRAM AND SWITCHING ON To select the most suitable program for the dishes to be washed refer to the table below, which indicates the most appropriate program according
Resumo do conteúdo contido na página número 12
User instructions After using the table to identify the most appropriate washing program: press the ON/OFF button (1) and wait for the PROGRAM INDICATOR LIGHT (2) to illuminate; keep pressing the PROGRAM SELECTION button (3) until the indicator light corresponding to the desired program illuminates; close the door; after about 2" the program will start. While it is in progress, the relative LIGHT will flash (indicating that the program is being executed). MODELS WITH "AUTO" PROGRAM P
Resumo do conteúdo contido na página número 13
User instructions MODELS WITH "AUTO" PROGRAM PROGRAMME CONSUMPTION (3) DURATION TYPE OF PROGRAM DETERGENT MINUTES WATER POWER DISHES DESCRIPTION GRAMS NR SYMBOL NAME (2) (LITRES) (KWh) AND DIRT (1) (2) Clean mixed dishes requiring Cold rinse DISH rinsing and Rinse at 68°C 20' 3 0,40 - 6 WARMER warming before Dry taking to table Wash at 45°C Crystal, porcelain Cold rinse CRYSTAL 7 and mixed dishes, 55' 7 0,60 15 Rinse at 68°C light dirt Dry Cold prewash Extended w
Resumo do conteúdo contido na página número 14
User instructions After using the table to identify the most appropriate washing program: press the ON/OFF button (1) and wait for the PROGRAM INDICATOR LIGHT (2) to illuminate; keep pressing the PROGRAM SELECTION button (3) until the indicator light corresponding to the desired program illuminates; close the door; after about 2" the program will start. While it is in progress, the relative LIGHT will flash (indicating that the program is being executed). MODELS WITHOUT "AUTO" PROGRAMM PROGRA
Resumo do conteúdo contido na página número 15
User instructions MODELS WITHOUT "AUTO" PROGRAMM PROGRAMME CONSUMPTION (3) DURATION TYPE OF PROGRAM DETERGENT MINUTES WATER POWER DISHES DESCRIPTION GRAMS NR SYMBOL NAME (2) (LITRES) (KWh) AND DIRT (1) (2) Clean mixed dishes requiring Rinse at 68°C DISH rinsing and 20' 3 0,40 - 6 WARMER Dry warming before taking to table Wash at 45°C Crystal, porcelain Cold rinse 7 CRYSTAL and mixed dishes, 55' 7 0,60 15 Rinse at 68°C light dirt Dry Cold prewash Extended wash at BIO (*) Mixed dishes, 52°
Resumo do conteúdo contido na página número 16
User instructions The washing cycle will not take place if the dishwasher door is left open or not properly closed. TABLE FOR CERTIFICATION BODIES Reference standard EN 50242 Reference program BIO Load 7 place-settings Type of detergent B Amount of detergent 21 g Rinse aid setting 5/6 3.2 Washing programs Before starting a washing program make sure that: The water supply tap is open. The correct amount of detergent has been added to the dispenser. The baskets have been correctly lo
Resumo do conteúdo contido na página número 17
User instructions CHANGING THE PROGRAM To change the program in progress, simply open the door and select a new program. When the door is closed the dishwasher will automatically select the new program. EXTRA PROGRAMS Button (6) gives access to five extra programs in addition to the ones which can be selected directly using the program selector button. This button must be pressed (the light comes on) after selection of the "main" program (1, 2, 3, 4 or 5). This function is retained in t
Resumo do conteúdo contido na página número 18
User instructions DELAYING THE PROGRAM (available in all programs except the soak program) The PROGRAM DELAY button (10) can be pressed to delay the start of the program by up to 9 hours. This means that the dishwasher can be operated at the time of day of your choice. Press the button several times in succession and the display will show the delay with which the appliance will start, beginning from 9 hours. The dishwasher will perform a dish pre-washing, and when finish, the “delay prog
Resumo do conteúdo contido na página número 19
User instructions 1 79 6 8 11 10 2 3 4 5 auto Extra BIO 60° Extra smeg 3/1 auto 50° Extra BIO Extra smeg 3/1 ADJUSTING THE WATER SOFTENING SYSTEM N.B.: for the setting below to be possible, a washing program other than the soak program must be set. Press the PROGRAM DELAY button (10) and keep it pressed until the preset value appears followed by a full stop (normally 3.). Release the button then press it again in succession to display the value required, referring to the table. The 6 setti
Resumo do conteúdo contido na página número 20
User instructions If the door has to be opened while washing is in progress, the program will be interrupted. The relative light will keep flashing and a beeper will signal that the cycle has not been completed. When the door is closed the program will continue from where it was interrupted. This operation should only be carried out if strictly necessary, because it might cause problems in execution of the program. END OF CYCLE At the end of the program the beeper sounds briefly and the
