Resumo do conteúdo contido na página número 1
User’s manual
EP5632/EP5632-2
5.8 GHz digital cordless
answering system
with BLUETOOTH®
wireless technology
Resumo do conteúdo contido na página número 2
Congratulations on your purchase of this AT&T product. Before using this AT&T product, please read the Important safety information on pages 100-102 of this manual. Please thoroughly read this user’s manual for all the feature operations and troubleshooting information necessary to install and operate your new AT&T product. You can also visit our website at www.telephones.att.com or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268. Model #: EP5632/EP5632-2 Type: 5.8GHz cordless
Resumo do conteúdo contido na página número 3
Before you begin you must install and charge the battery, see page 14 for Battery installation instructions. Please read and follow these instructions carefully: • Use only the supplied rechargeable battery or replacement battery. • Observe the proper polarity orientation between the battery and handset during the battery installation. • Do not dispose the battery in a fire. Check with local codes for special disposal instructions. • Do not open or mutilate the battery. Released electrolyte
Resumo do conteúdo contido na página número 4
Parts checklist Your new AT&T EP5632/EP5632-2 telephone system includes: Telephone base Mounting bracket Power adapter Telephone (attached to the line cord bottom of the telephone base) Cordless Handset battery Handset battery Belt clip telephone compartment (1 for EP5632) (1 for EP5632) handset cover (2 for EP5632-2) (2 for EP5632-2) (1 for EP5632) (1 for EP5632) (2 for EP5632-2) (2 for EP5632-2) User’s manual Quick start guide EP5632/EP5632-2 EP5632/EP5632-2 5.8 GHz digital cordless 5.
Resumo do conteúdo contido na página número 5
Table of contents Conferencing .....................................64 Getting started Quick reference guide .....................2 Intercom calls ...................................66 Handset status icons .......................4 Directory Telephone base status icons .......5 Directory introduction ..................67 Handset main menu .........................6 Create new directory Telephone base main menu..........7 entry .....................................................68 I
Resumo do conteúdo contido na página número 6
Getting started Quick reference guide Handset VOLUME Status light Press to increase or Flashes rapidly during an decrease handset listening incoming call. volume while on a call. Flashes slowly when there is a new voice mail message OFF/CANCEL (page 33) or new message in 12:00AM During a HOME or the answering system CELLULAR line call, press (page 86). HANDSET 1 to end the call. Softkeys (2) While in a menu, press to Press to select a menu item cancel an operation, back REDIAL CAL
Resumo do conteúdo contido na página número 7
Get Getting st ting start arted ed Quick reference guide Telephone Base Answering system keys and NavKeys (in brackets) When in idle mode, press the answering system keys to operate the answering system. When in a menu, press the UP, DOWN, LEFT or RIGHT NavKeys to navigate through the menus, highlight items, and change settings. (DOWN) Press to play or stop playing messages. PLAY/STOP Flashes when there are new answering system messages. Press to skip to the next message. SKIP(RIGHT) Pre
Resumo do conteúdo contido na página número 8
Getting started Handset status icons 1 2 12:00AM 12:00AM HANDSET 1 REDIAL CALLER ID 12:00AM Time - indicates the handset time. New answering system message - alternates with the time when you have a new answering system message. New voice mail message - alternates with the time when you have a new voice mail message. HOME line - on steady when the HOME line is in use. Flashes slowly when a HOME call is on hold. Flashes rapidly when there is an incoming HOME call. CELLULAR (cell phones 1 or
Resumo do conteúdo contido na página número 9
Get Getting st ting start arted ed Telephone base status icons ANS. OFF 1 2 12:00 AM REDIAL MENU CID Answering system off - indicates that the answering system will not ANS. OFF answer incoming calls (page 50). HOME line - on steady when the HOME line is in use. Flashes slowly when a HOME call is on hold. Flashes rapidly when there is an incoming HOME call. CELLULAR (cell phones 1 or 2) - depending on which cell phone is active, 1 on steady when the CELLULAR line is in use. Flashes slowly w
Resumo do conteúdo contido na página número 10
Getting started Handset main menu To enter the main menu: 1. Press MENU/SELECT when the handset is in idle mode. 2. Press the UP and DOWN Navkeys to select a handset feature menu, then press MENU/SELECT to enter that menu. To return to the idle mode, press and hold OFF/CANCEL. Directory allows you to store and Settings allows you to change search for names and numbers. your handset settings. Settings Directory 1 Directory SS ee ttt intgin s gs Set Time Alice Amy Edit Handset Name Ch
Resumo do conteúdo contido na página número 11
Get Getting st ting start arted ed Telephone base main menu To enter the main menu: 1. Press the MENU softkey when the telephone base is in idle mode. 2. Press the UP and DOWN Navkeys to highlight a menu item, then press the SELECT softkey to enter that menu. To return to the idle mode, press and hold CANCEL. Main Menu allows you to review Bluetooth allows you to set up and and setup features and settings. manage your Bluetooth device(s). Main Menu Bluetooth Directory Set up Cellular Ca
Resumo do conteúdo contido na página número 12
® Intercom Intercom Intercom Intercom ® Getting started Installation setup Install the telephone base close to a telephone jack and a power outlet not controlled by a wall switch. The telephone base can be placed on a flat surface or vertically mounted on the wall (see page 10). For optimum range and better reception, place the telephone base in a central and open location. Depending on the environmental conditions, make sure that your Bluetooth enab
Resumo do conteúdo contido na página número 13
Get Getting st ting start arted ed Telephone base installation Install the telephone base as shown below. Make sure that the electrical outlet is not controlled by a wall switch. Also, if you receive high speed internet through your telephone line (commonly referred to as DSL), install a DSL filter to the telephone line between the telephone base and the telephone wall jack. Contact your DSL service provider for more information about DSL filters. Telephone wall jack Electrical outlet not
Resumo do conteúdo contido na página número 14
Getting started Installation options The telephone base comes with the mounting bracket already installed for desktop use. If wall mounting is desired, a telephone outlet wall mounting plate with mounting studs is required. This mounting plate with studs may be available for purchase from any hardware or consumer electronics retailers and may require professional installation. Desktop to wall mount installation To install the telephone base in the wall mount position, make sure that you fir
Resumo do conteúdo contido na página número 15
Get Getting st ting start arted ed Installation options Desktop to wall mount installation (continued) 4. Plug the telephone line cord and power adapter plug into the telephone base and place the cords in the bracket grooves. DSL filter Bracket grooves (for DSL users, see page 9) Mounting studs 5. Plug the power adapter and telephone line cord into the wall outlets, then align the mounting studs on the telephone outlet plate with the mounting holes on the bracket. Mounting holes 2
Resumo do conteúdo contido na página número 16
Getting started Installation options Wall mount to desktop installation To change the telephone base from the wall mount position to desktop position, make sure that you first unplug the power adapter and telephone line cord from the wall outlets before you begin. 1 1. Slide the telephone base upwards, then pull the 2 Mounting telephone base away studs from the wall off of the mounting studs. 2. Remove the telephone line cord and power adapter plug from the telephone base. Wall moun
Resumo do conteúdo contido na página número 17
Get Getting st ting start arted ed Installation options Wall mount to desktop installation (continued) 4. Rotate the bracket to the desktop position. Desktop position 5. First insert the center bracket tabs, then press the bracket downwards until the bracket clicks into place. Center tabs Electrical Telephone 6. Plug the telephone line outlet not wall jack cord into the telephone controlled by base and telephone wall a wall switch DSL filter jack, then plug the power For DSL use
Resumo do conteúdo contido na página número 18
Getting started Battery installation & charging Install the battery as shown below. After installing the battery, you can make and receive short calls, but replace the handset in the telephone base or additional charger when not in use. For optimal performance, charge the handset battery for at least 16 hours before use. When fully charged, the handset battery provides approximately five hours of talk time and three days of standby time. Step 2 Step 1 Step 3 Insert the supplied battery a
Resumo do conteúdo contido na página número 19
Get Getting st ting start arted ed Belt clip & optional headset Install belt clip as shown below, if desired. Snap the belt To release the belt clip from clip into the the handset, press on both notches on flaps of the belt clip (as both sides of shown). the handset. Pull and unlock one flap from the notch first before detaching the whole belt clip from handset. For handsfree headset conversations, use any industry standard 2.5 mm headset (purchased separately). For best results, use an
Resumo do conteúdo contido na página número 20
Getting started Expanding your telephone system Your new AT&T EP5632/EP5632-2 telephone system can accommodate up to 12 cordless handsets. You can add new handsets to your telephone system (EP562 purchased separately), but each handset must be registered with the telephone base before use. To register new handsets to your telephone system, see page 17. The EP5632 telephone system comes The EP5632-2 telephone Up to 12 handsets with one registered handset. (EP562 purchased system comes with
