Manual do usuário Ives Offset Top Pivot 7227/27F

Resumo do conteúdo contido na página número 1

Installation Instructions
7212, 7215/15F, 7222, 7226/26F, and 7227/27F
3/4” Offset Top Pivot
Bearing leaf
Pin leaf
3/32” Allen wrench
Set screw
Bearing
leaf
Pin leaf
1/4-20 tapped hole for
pin removal (both ends)
Left hand Right hand
installation installation
Pivot
Pivot cap
pin
5/32” Allen wrench
1. Prepare and mortise top of door and head jamb to receive pivot set. Determine pivot location
using dimensions on reverse side. The pivots are non-handed. To determine hand of door
and proper pivot p

Resumo do conteúdo contido na página número 2

NOTE ! It is very important for installer to verify that center line of top pivot point lines up with center line of bottom pivot point before final installation. Heel edge of door must be beveled 1/8” in 2” as shown below. The bottom pivot set should be mounted first in most installations. NOTE ! Mortise depth for pivot leafs is 1/4”. 3/4” 15/16” 1/8” * 24 mm* 3 mm 19 mm typ Frame Leaf 1/16” These dimensions apply to industry standard 2 mm * 1-3/4” door in a 1-15/16” rabbeted frame. For typ o