Manual do usuário Ives Heavy Duty Top Center Pivot 7259

Resumo do conteúdo contido na página número 1

Installation Instructions
7259
Bottom Center Pivot
Clamp
Door NOTE
screws !
leaf
Pivot clamp
2” minimum door thickness.
Finish
screws
Pivot
Finish plate
pin
Mounting
screws
Base
Concrete
plate
channel base
Concrete
anchor pins
Figure 1 Figure 2 Figure 3
1. Prepare and mortise bottom of door and floor to receive pivot set. Determine pivot location using
dimensions on reverse side. Be sure to properly locate base plate. The finish plate of pivot base
assembly should be removed until installation

Resumo do conteúdo contido na página número 2

NOTE ! It is very important for installer to verify that center line of top pivot point lines up with center line of bottom pivot point before final installation. 1-5/8” 1-7/8” 2-5/16” to 2-3/4” 41 mm 48 mm 59 mm * 70 mm Pivot center may *be varied as needed; standard C pivot L distance is 2-3/4” as shown. Removable door 1/16” 3/8” section to allow 2 mm 10 mm access to pivot leaf bracket screws C pivot L and door Radius of heel edge of door must 2-1/2” 64 mm not exceed pivot point to jamb Dimens