Manual do usuário Ives Heavy Duty Offset Top Pivot 7237F

Resumo do conteúdo contido na página número 1

Installation Instructions
7230F and 7237F
3/4” Heavy Duty Offset Top Pivot
Bearing leaf
Pin leaf
3/32” Allen wrench
Bearing Set screw
leaf
Pin leaf
1/4-20 tapped hole for
Left hand Right hand
pin removal (both ends)
installation Pivot installation
pin
Pivot cap
5/32” Allen wrench
1. Prepare and mortise top of door and head jamb to receive pivot set. Determine pivot location
using dimensions on reverse side. The pivots are non-handed. To determine hand of door
and proper pivot position, see diagr

Resumo do conteúdo contido na página número 2

NOTE ! It is very important for installer to verify that center line of top pivot point lines up with center line of bottom pivot point before final installation. Heel edge of door must be beveled 1/8” in 2” as shown below. NOTE ! Mortise depth for pivot leafs is 3/8”. Right hand installation shown; left hand opposite 13/16” 1-1/4” 1/8” 21 mm * 32 mm* 3 mm typ Frame Leaf 1/16” These dimensions apply to industry standard 2 mm *1-3/4” door in a 1-15/16” rabbeted frame. For typ other frame conditi