Resumo do conteúdo contido na página número 1
Instruction
Manual
R C W L 3 0 0 A
Premium Portable Wireless Chime & Push
69-2109EFS-05
Resumo do conteúdo contido na página número 2
Installation Instructions Contents Checking pack contents ............................1 Safety ..........................................................2 Quick start ..................................................2 Open bell push ...........................................3 Fit the push battery ...................................3 Fit the chime battery ..................................4 Sliding window ...........................................4 Volume control .............................
Resumo do conteúdo contido na página número 3
RCWL300A Premium Portable Wirefree Chime with Push Thank you for choosing this Honeywell product. Please use the following instructions to ensure correct installation and use. Keep these notes in a safe place for future ref- erence. Checking Pack Contents Unpack your chime kit and identify the You will need: following parts: • 3 X LR6 ‘AA’ Alkaline batteries • Chime • A Phillips screwdriver • Wall mounting bracket • A small flat bladed screwdriver • Bell push • A 1/4-in. (6 mm) masonry drill •
Resumo do conteúdo contido na página número 4
Installation Instructions Safety Before proceeding with the installation, please note the following safety warnings: • Always follow the manufacturer’s advice when using power tools and wear suitable protective equipment (e.g. safety goggles) when drilling holes, etc. • Before drilling holes in walls, check for hidden electricity cables and water pipes. The use of a cable/pipe locator is advisable if in doubt. Quick Start The bell push supplied with this kit is pre-programmed to operate with t
Resumo do conteúdo contido na página número 5
CR2032 + RCWL300A Fit the Push Battery Open the Bell Push Insert a flat bladed screwdriver into the Insert the CR2032 coin cell. Ensure the slot A at the base of the push. Carefully face marked ‘+’ is uppermost (Fig. 2). lever the cover and base apart (Fig. 1). CR2032 + M27153 Fig. 2 A M27199 Fig. 1 3 69-2109EFS—05
Resumo do conteúdo contido na página número 6
Installation Instructions Fit the Chime Batteries Sliding Window To remove the chime battery cover, Release the catch (B) and slide open press at point B and slide the cover the window. back 1/4 in. (5 mm), then lift off. Insert 3 x LR6 ‘AA’ alkaline batteries (not supplied). Observe polarity as marked inside the battery compartment. M27201 B B M27200 Fig. 3 69-2109EFS—05
Resumo do conteúdo contido na página número 7
RCWL300A Volume Control The volume control is behind the slid- ing window on the front of the chime. Initially, set the control to mid-point. After you have tested your system, adjust to the desired volume. VOLUME CONTROL M27202 5 69-2109EFS—05
Resumo do conteúdo contido na página número 8
Installation Instructions Use of Icons In addition to the chime sounds, your chime has a visual indication to show which device has activated it. An icon will illuminate when the chime is activated by a bell push or another compatible device. The chime supports 3 icons. The ‘Main door’ and ‘Back door’ icons are usually used for bell pushes. The other icon is intended for use with other compat- ible devices, such as PIR movement detectors and Telephone ring detector. Icons numbered 1 to 3 are
Resumo do conteúdo contido na página número 9
RCWL300A Programming Procedure Learn Procedure Unlearn Procedure To enable your chime to learn the identity If you want to remove a push from the of your bell push: chime’s memory: • Press the l button and keep it • Press the l button and keep it pressed. Each Icon will light in pressed. turn. When the Icon you want is lit, • Each Icon will light in turn. When the release the button. Icon associated with the push to be • While the Icon you have selected is unlearned is lit, release the but
Resumo do conteúdo contido na página número 10
Installation Instructions Changing the Tune Mount the Push Operate the push. While the Icon is flash- Mount using either the double-sided ing, press the button. Press the adhesive pad or the screws provided. button again and the tune will change. (See Fig. 6 ) Repeat until the tune you want plays. Test your push before mounting. Avoid Recall Function mounting to metal structures. A short push of the l button will flash TOP the Icon that was last in use. Chime Sounds To hear the chime soun
Resumo do conteúdo contido na página número 11
RCWL300A Chime Position The Chime can be free standing or wall mounted using the wall mounting bracket provided. If wall mounting is preferred, screw the bracket to the wall (see Fig 7). The Chime hooks onto the wall bracket as illustrated. M27203 Fig. 7 9 69-2109EFS—05
Resumo do conteúdo contido na página número 12
Installation Instructions Troubleshooting A ‘beep’ sound is heard in learn mode… • The push you are programming has already been learned by the chime. • If you want to change the Icon associated with the push, use the un-learn procedure, then program the push again. Two ‘beep’ sounds are heard after the normal chime sound… • This indicates a low battery in the bell push that activated the chime. Fit a new battery, type CR2032. When the bell push is operated, the amber confidence light does no
Resumo do conteúdo contido na página número 13
RCWL300A Troubleshooting The chime does not sound… • Check that the volume control is not at the minimum setting. Range is reduced… • Metal structures, including uPVC door frames can reduce the range of the product. Avoid mounting the push or chime on or near metal structures. • Other equipment can cause radio interference that affects your chime. • Walls and ceilings will reduce the range. • Weak batteries will reduce range. Replace every 12–18 months. In cold conditions (below 41ºF [5ºC]
Resumo do conteúdo contido na página número 14
Installation Instructions Specifications Specification Chime Bell push Operating Temperature 32°F to 104°F 14°F to 104°F 0ºC to 40ºC -10ºC to 40ºC RF Frequency US/Canada 916.8 MHz 916.8 MHz Range (open field) 225 ft. (69 m) See Chime Sound Level (typical) 80dBA @ 3 ft. (1m) - RF Power - <1mW Battery Type LR6 CR2032 Battery Life (5 activations/day) 12 months 18 months Rain proof N/A Pass UL1598 rain test. Disposal & Recycling Batteries and waste electrical products should not be disposed of with
Resumo do conteúdo contido na página número 15
RCWL300A Declaration Honeywell hereby declares that this product complies with Part 15 of the FCC rules and Industrial Canada standards. This device operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Caution: Changes or modification not expressly approved by the party responsible for regula- tory compliance could void the
Resumo do conteúdo contido na página número 16
Honeywell International Inc. ACS, Environmental and Combustion Controls 1985 Douglas Drive, Golden Valley, MN 55422 www.honeywell.com Printed in U.S.A. on recycled paper containing at least 10% post-consumer paper fibers. ® U.S. Registered Trademark. © 2007 Honeywell International Inc. 69-2109EFS—05 M.S. Rev. 12-07
Resumo do conteúdo contido na página número 17
Mode d’emploi R C W L 3 0 0 A Carillon portatif sans fil avec sonnette de qualité supérieure
Resumo do conteúdo contido na página número 18
Directives d’installation Table des matières Vérification du contenu de l’emballage ..17 Sécurité ....................................................18 Mise en service rapide ............................18 Ouvrir la sonnette ....................................19 Installation de la pile de la sonnette .......19 Installation des piles du carillon .............20 Fenêtre coulissante..................................20 Réglage du volume ..................................21 Utilisation des icônes .
Resumo do conteúdo contido na página número 19
RCWL300A Carillon portatif sans fil avec sonnette de qualité supérieure Nous vous remercions d’avoir choisi un produit Honeywell. Veuillez suivre les instruc- tions suivantes pour installer et utiliser correctement ce produit. Conservez ces instructions dans un endroit sûr de façon à pouvoir vous y référer plus tard. Vérification du contenu de l’emballage Sortir l’ensemble à carillon de son Outils requis : emballage et repérer les pièces suivantes : • 3 piles alcalines AA LR6 • Carillon • Un t
Resumo do conteúdo contido na página número 20
Directives d’installation Sécurité Avant de commencer l’installation, veuillez respecter les consignes de sécurité suivantes : • Toujours suivre les recommandations du fabricant lorsqu’on utilise des appareils électriques et toujours se servir d’un équipement protecteur (par ex. des lunettes de protection) lorsqu’on perce des trous, etc. • Avant de percer un trou dans un mur, vérifier qu’il n’y a pas de canalisations ou de câbles électriques encastrés. En cas de doute, il est conseillé d’u
