Manual do usuário Cornelius Latch

Resumo do conteúdo contido na página número 1

Door Latch Assembly Installation Instructions
INSTALLATION INSTRUCTIONS
REMOVAL AND INSTALLATION OF DOOR LATCH ASSEMBLY QUEST
NOTE: Removing the existing door catch/switch with the replacement catch will remove the auto-
matic sold out reset function of the machine. This feature can still be used or totally defeated
depending on users preference.
OPTION 1: By removing the existing switch and not jumping the board the sold out will work, but not
reset unless the pump door switch is manually re

Resumo do conteúdo contido na página número 2

Door Latch Assembly Installation Instructions INSTALLATION IMPORTANT: Disconnect power from machine before starting this procedure! 1. Remove the top cover of the machine. A. Remove two screws from rear of top. B. To remove cover open door and pull cover forward. FIGURE 2 FIGURE 3 2. Remove the side panel of the machine. A. Remove latch cover plate. B. Remove 2 screws holding splash guard. NOTE: When reassembling latch guard use the #8 PLASTIC screws supplied. FIGURE 5 FIGURE 4 C. Remo

Resumo do conteúdo contido na página número 3

Door Latch Assembly Installation Instructions 3. Remove and replace door catch. A. Remove (2) 8-32 screws holding existing B. Replace catch with new catch assembly. door catch. Fasten to door with 8-32 x 5/8” screws. FIGURE 9 FIGURE 8 4. Remove and replace cabinet catch. A. Pull back tape back exposing catch/switch. B. Remove and save insulation putty to be rein- stalled later. FIGURE 10 FIGURE 11 C. Remove (2) 6-32 screws holding existing D. Remove latch/switch from wire harness. latch/s

Resumo do conteúdo contido na página número 4

Door Latch Assembly Installation Instructions E. Insert slotted holes into new latch. F. Attach bracket and latch to cabinet frame using (2) 6-32 x 3/8” screws and washers. FIGURE 15 FIGURE 14 G. Close door and adjust cabinet bracket using H. Check lower and upper door to assure seal. the 6-32 screws. Door should slightly com- If not adjust bracket until it properly seals. press the door seal. FIGURE 17 FIGURE 16 5. Connect cabinet interrupt switch jumper wire. A. Plug one end of black sp

Resumo do conteúdo contido na página número 5

Door Latch Assembly Installation Instructions C. Route wires in existing cavity and reinstall insulation putty and replace tape. FIGURE 21 FIGURE 20 D. Replace side panels by sliding panels for- E. Replace latch cover plate. ward to engage panel tabs. Make sure plas- NOTE: When reassembling latch guard use tic spacers are located on panel clips before the #8 PLASTIC screws supplied if holes are assembling. Replace all screws that were stripped. previously dissembled. FIGURE 23 FIGURE 2

Resumo do conteúdo contido na página número 6

Door Latch Assembly Installation Instructions C. Remove cover from box. D. Locate the 2 pin plug that says “SOLD OUT” on the control board. There will be one for each pump. Disconnect these connectors. There will be (4) total in a four flavor machine. FIGURE 26 FIGURE 27 E. Replace the connectors with the “SOLD OUT” jumpers. FIGURE 28 THIS COMPLETES THE LATCH ASSEMBLY PROCEDURE for OPTION 2 “SOLD OUT DISABLED OPTION” disabling the sold out function. Complete the procedure by replacing al