Resumo do conteúdo contido na página número 1
UIP 160P
SERIES
OWNER'S
MANUAL
Resumo do conteúdo contido na página número 2
Contents Welcome/Features/Terminology 2 Phonebook (Storing Phone Numbers, Controls & Functions 5 Names, Distinctive Rings and Speed Dial) 38 Setting up the Phone 7 Chain Dialing 39 Safety Recommendations 7 Steps for Entering Names and Special Characters 40 Before You Start! 8 Viewing the Phonebook 42 Install the rechargeable battery pack into the handset 12 Making Calls Using the Phonebook 43 Expanding Your Phone 13 Speed Dialing 43 Ten Handset Expandability 13 Editing or Erasing a Phonebook En
Resumo do conteúdo contido na página número 3
WE L C O M E / FE AT URES/ With the UIP160P voice-over-Internet Protocol (VoIP) telephone, Packet8 VoIP service Welcome and your broadband connection, you can access the Internet and make phone calls simultaneously. The UIP160P can connect directly to your broadband modem or can connect to a router or switch in your home network. It generates and receives voice data and forwards data traffic to your computer or network. Note: Some illustrations in this manual may differ from the actual unit
Resumo do conteúdo contido na página número 4
WE L C O M E / FE AT URES/ This series features AutoTalk™ and AutoStandby™. AutoTalk allows you to answer a call by just removing the handset from the cradle so you don't have to waste time pushing buttons. AutoStandby allows you to hang up by simply returning the handset to the cradle. To protect you against mis-billed calls that might result from your phone being activated by other equipment, this series has Random Code™ digital security, which automatically selects one of more than 10,000
Resumo do conteúdo contido na página número 5
WE L C O M E / FE AT URES/ Terminology Standby Mode - The handset maybe sitting or off the cradle, but is NOT in use. talk/flash or has not been pressed. Talk Mode - The handset is off the cradle and talk/flash or has been pressed, and enabling a dial tone. VoIP - Voice over Internet Protocol, a method of sending voice signals over broadband Internet connections. Station - The main base or any registered handset. Configuration utility - The internal user interface that allows you
Resumo do conteúdo contido na página número 6
CONTROLS & F UNC TIONS Controls & Functions 1. Handset Antenna 1 2. Beltclip Hole 5 3. Speakerphone Speaker and Ringer 14 6 4. Handset Battery Compartment 2 5. New Message LED 6. Handset Earpiece 7 7. LCD Display 3 8. soft Keys (P. 18) 8 9. cid/vol/ (volume up) (P. 47, 34 & 20) 15 9 16 10.redial/p/vol/ (volume down) (P. 33, 31, 34 & 20) 17 10 11. /tone/< (P. 40) * 12. 4 13. (speaker) (P. 30) 14.intcom (intercom)/hold (P. 54 & 32) 11 18 15.Headset Jack Cover 12 19 16.talk/flash (P. 31 & 32) 13 2
Resumo do conteúdo contido na página número 7
CONTROLS & F UNC TIONS 23. Base Charging Contacts 33. RESET switch 24. Base Antenna 34. INTERNET (WAN) port 25. Charge LED 35. ETHERNET (LAN) port 26. find hs (handset) (P. 36) 36. PHONE port 27. pwr (power) LED 28. link LED 29. lan LED 30. wan LED 31. phone LED 32. POWER port www.uniden.com CONTROLS & FUNCTIONS [6]
Resumo do conteúdo contido na página número 8
SET T I NG UP THE PH ONE Setting up the Phone Safety Recommendations To ensure general safety, follow these guidelines: Do not open or disassemble this product. Do not expose the product to moisture. Do not perform any action that creates a potential hazard to people or makes the equipment unsafe. Ultimate disposal of this product should be handled according to all national laws and regulations. Do not touch the wires on the cable ports or the wires of cables connected to a port as
Resumo do conteúdo contido na página número 9
SET T I NG UP THE PH ONE 911 Service Notice Packet8 offers Enhanced 911 calling as a standard feature of its Internet phone note service. However, there are certain circumstances, when you dial 911 from a phone connected to the Packet8 service, where E911 service may not function, or the E911 service may be in some way limited by comparison to traditional 911 service. Please If you ordered your review the Terms and Conditions at www.packet8.net for additional information. UIP160P directly
Resumo do conteúdo contido na página número 10
SET T I NG UP THE PH ONE Check Your Broadband Configuration The UIP160P supports the two most common broadband connection protocols: DHCP and PPPoE. If your broadband connection uses DHCP, you do not need to change any settings on the UIP160P. If your broadband connection uses PPPoE, you will need to enter your user name and password in step 3. If your broadband provider has given you a static IP address, you will need to enter that information in the UIP160P. See the User Interface Guide
Resumo do conteúdo contido na página número 11
SET T I NG UP THE PH ONE 2) Use another Ethernet cable to connect your PC to the RJ-45 port labeled LAN. note PHONE is not a separate line. Any phone connected to PHONE will share your VoIP line with all the UIP160P's cordless handsets. 3) OPTIONAL: If you have a second phone you want to use connect it to RJ-11 port labeled PHONE. CAUTION Do not connect the UIP160P to a regular telephone wall jack. 4) Use the included AC adapter to connect the POWER port to a 100-240 Vac continuous p
Resumo do conteúdo contido na página número 12
SET T I NG UP THE PH ONE All the LEDs will flash several times, and the PWR LED will remain on. If the UIP160P was properly recognized by Packet8's network, the link LED will remain on. Test your connection by making a call with the handset and browsing to a web page from your PC. If you have any difficulty, see the Troubleshooting section. See the User Interface Guide at www.uniden.com/voip for more information on configuring your UIP160P. Step 3 Activate your Packet8 Service Once you hav
Resumo do conteúdo contido na página número 13
SET T I NG UP THE PH ONE Install the rechargeable battery pack into the handset note 1) Press down on the handset battery case cover (use the finger indention for a better grip) and slide the cover downward to remove. Use only the Uniden (BT- 446) rechargeable battery 2) Plug the battery pack connector (red & black wires) into pack supplied with your cordless telephone. the jack inside the battery compartment. (The connector Replacement battery packs notches fit into the grooves of the
Resumo do conteúdo contido na página número 14
E X PA NDING YOUR PH ONE Expanding Your Phone Ten Handset Expandability 10 Handsets Your phone supports up to ten handsets, including any handsets supplied with your phone. Expansion handsets can be placed anywhere AC power is available to connect the handset charger. Up to 2 handsets can be used in DirectLink Mode or on an intercom call without interfering with incoming calls. You can also have a 3-way conference among 2 handsets and an outside line. All handsets ring when a call is rec
Resumo do conteúdo contido na página número 15
E X PANDING YOUR PHONE Register the Handset Expansion handsets must be registered to the base before you can use them. note Only one handset can be registered at a time. Handsets supplied with the phone are registered to the base by the factory. When An extra handset can you register an extra handset to the base, the handset ID will be assigned. be registered when the main base is in standby mode. Before an expansion handset is registered, the battery pack MUST be charged for 15 If a ha
Resumo do conteúdo contido na página número 16
De-register the Handset You can deregister the handset's ID from the main base unit or the base ID from the handset. You will usually only deregister the handset if you want to change the base you use it with, if you are having a problem with your phone, or if you need to change the digital security code. The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the code is not necessary. In the rare situation that you suspect
Resumo do conteúdo contido na página número 17
I N STA LLING TH E BE LTCLI P Installing the Beltclip To attach the beltclip Insert the beltclip into the holes on each side of the handset. Press down until it clicks. To remove the beltclip Pull either side of the beltclip to release the tabs from the holes. Headset Installation Your cordless handset may be used with an optional headset. To use this feature, insert the headset plug into the headset jack. Your phone is ready for hands-free conversations. (Headsets may be purchased by calli
Resumo do conteúdo contido na página número 18
Display and Icons Example of the standby mode display Ringer off icon (when the ringer is off)/ day of the week and time / battery icon Handset ID and Banner Number of new Caller ID calls received (If there are no new Caller ID messages, the Handset ID appears here.) ICON Appears During DESCRIPTION Battery icons indicate the handset battery status. This icon changes depending on Standby/Talk the battery status (empty, low, medium and full). Standby The Ringer off icon indicates that ringer
Resumo do conteúdo contido na página número 19
S O FT KEY FUNCTION Soft Key Function "Soft" keys are keys that change function during the operation of the phone. There are three soft keys on each handset. Soft Keys allow you to: - Access the main menu - Redial one of the last three numbers dialed from the handset The function of each soft key is determined by the icon that appears directly above it. For example, when the handset is in standby mode, pressing soft key 2 will access the main menu. When the handset is in talk mode, p
Resumo do conteúdo contido na página número 20
MA IN ME NU OP TIONS Main Menu Options note Your phone has five main menu options: DirectLink Mode, Room Monitor, Handset Setup, Global Setup and Deregister HS. For Global Setup and Default Settings Deregister HS menu The default settings set from the factory match the features that most people use. options, make sure the line is not in use and You may not need to change them. The table below lists the default settings. the handsets are within range of the Function Default Settings Fun
