Resumo do conteúdo contido na página número 1
Resumo do conteúdo contido na página número 2
Congratulations on your purchase of the EXS 2060 cordless telephone. This phone is designed for reliability, long life, and outstanding performance utilizing the latest in 900 MHz Spread Spectrum technology. Note: Some illustrations in this manual may differ from the actual unit for explanation purposes. • 900 MHz Spread Spectrum Technology • Caller ID and Call Waiting Caller ID • 50 Number Caller ID Memory • Lighted Keypad • 3-Line, 16 Character Backlit Handset Display • 20 Enhanced Memory Dia
Resumo do conteúdo contido na página número 3
1. Handset antenna 22. Handset retainer clip 2. Headset jack cover 23. Base charging contacts 3. Handset battery compartment 24. Base antenna 4. Ringer off-on switch 25. Status LED 5. Handset earpiece 26. Power LED 6. LCD display 27. Page/Find key 7. Talk key 28. Pulse-Tone switch 8. Volume/Cursor down key 29. DC power input 1 9. Call ID key 30. Phone jack 10. Tone key/Left cursor 11. Redial/Pause key 2 5 12. Setup key 13. Handset microphone 14. Volume/Cursor up key 6 15. Flash key 14 16. Memory
Resumo do conteúdo contido na página número 4
Getting Started Introduction / Features...............inside front cover Controls and Functions ..............inside front cover Getting Started Basics Read this first..........................................................3 Step 1: Checking the package contents...............4 Step 2: Setting up the base unit ...........................5 Mounting the base unit on a wall ...........8 Step 3: Preparing the battery pack.....................10 Basics Making a call ................................
Resumo do conteúdo contido na página número 5
This cordless telephone must be set up before use. Follow these steps; Step 1 (page 4) Unpack and check the telephone and accessories. Step 2 (page 5 to 9) Next, choose the best location to set up the base unit. Base unit Step 3 (page 10 to11) Then, insert the battery pack into the handset. You must charge the battery pack for 15-20 hours before using the phone. Handset About the digital security code This cordless telephone uses a digital security code to prevent unauthorized access to your ba
Resumo do conteúdo contido na página número 6
Make sure you have received the following items in the package. • Base unit • Handset • AC adapter (AD-310) • Rechargeable • Telephone line • Wall mount adapter battery pack cord (2) (BT-905) • This Owner's Manual • Precautions and Important Safety Instructions • Quick Reference Guide • Registration Card • Beltclip Uniden Parts Department (800) 554-3988 Hours: M-F 8:30 AM to 5:00 PM CST. We can also be reached on the web at www.uniden.com. 4
Resumo do conteúdo contido na página número 7
Do the following steps. • Choose the best location • Connect the base unit • Choose the dialing mode Choose the best location Before choosing a location for your new phone, read the INSTALLATION CONSIDERATIONS included in the PRECAUTIONS AND IMPORTANT SAFETY INSTRUCTIONS brochure. Here are some important guidelines you should consider: Avoid heat sources, such as Avoid noise sources such as a window radiators, air ducts, and sunlight by a street with heavy traffic Avoid microwave ovens Avoid te
Resumo do conteúdo contido na página número 8
Connect the base unit If you want to install the base unit on the wall, see page 8. Place the power cord so it does not create a trip hazard, or where it could become chafed and create a fire or electrical hazard. 1 Connect the telephone line cord to the TEL LINE jack and to a telephone outlet. 2 Connect the AC adapter to the DC IN 9V jack and to a standard 120V AC wall outlet. 3 Set the base unit on a desk or tabletop and place the handset on the base unit. Then raise the antenna to a verti
Resumo do conteúdo contido na página número 9
Use only the supplied AD-310 AC adapter. Do not use any other AC Polarity of the plug adapter. Connect the AC adapter to a continuous power supply. Place the base unit close to the AC outlet so that you can unplug the AC adapter easily. Modular If your telephone outlet isn't modular, contact your telephone company for assistance. Choose the dialing mode Depending on your dialing system, set the PULSE-TONE switch as follows: If your dialing system is Set the switch to Tone TONE Pulse PULSE If yo
Resumo do conteúdo contido na página número 10
Standard wall plate mounting This phone can be mounted on any standard telephone wall plate. 1 Snap the wall mount 1 adapter into the notches on the base. 2 Plug the telephone line cord to the TEL LINE jack and the AC adapter to the DC IN 9V jack. 3 Plug the telephone line cord into the telephone outlet. 4 Wrap the AC adapter 2 - 7 cord inside the molded wiring channel. Then wrap the cord around the strain relief notch. 5 Plug the AC adapter into a standard 120V AC wall outlet. 6 Raise the an
Resumo do conteúdo contido na página número 11
8 On the base unit, pull the handset retainer out of the slot. Rotate it clockwise 180 degrees. 9 Flip the retainer from front to back. Slide it back into the slot If the handset beltclip is attached, you cannot so that the lip of the retainer is charge the handset facing up and the oval is down. The forward when the phone is retainer holds the handset mounted on the wall. (See in place. page 36.) Direct wall plate mounting If you don't have a standard wall plate, you can mount your phone direc
Resumo do conteúdo contido na página número 12
Preparing the battery pack Charge the battery pack for 15-20 hours before you start using your phone. 1 Press in on the battery cover release and slide the cover down until it comes off. 2 Connect the battery pack connector with the correct polarity (black and red wires), then insert the battery pack into the battery compartment. 3 Securely close the battery compartment cover by sliding it up until it snaps into place. 4 Place the handset on the base. 5 Make sure that the “status” LED lights. If
Resumo do conteúdo contido na página número 13
Battery use time (per charge) From fully charged • Six hours coutinuous use. • Ten days when the handset is in the standby mode. Even when the battery When the battery charge becomes low pack is not being used, it When the voltage of battery pack will gradually in the handset is very low and discharge over a long Low Battery period. For optimum needs to be charged, the phone is performance, be sure to programmed to eliminate return the handset to the functions in order to save power. If th
Resumo do conteúdo contido na página número 14
Dialing from standby 1 Enter the phone number. (Up to 32 digits.) Example: Enter 8178583300 Press if you enter a
wrong number at the 8178583300
step 1. 2 Press . “Talk” flashes on the display. Talk
8178583300
You must press a key within 20 seconds, or the Then the volume setting is displayed. phone will return to For example, if the volume is set to standby. high, the display shows: Talk
3 The number is dialed. After Talk 0:00
8178583300
about 5
Resumo do conteúdo contido na página número 15
Dialing from talk mode 1 Press . “Talk” flashes on the display. Talk
Then the volume setting is displayed. For example, if the volume is set to high the display shows: Talk
2 Dial the phone number. Example: Enter 8178583300 Talk 0:17
8178583300
3 To hang up, press or place the handset on the base. The call-time will be displayed for about 5 seconds. 10:03
13
Resumo do conteúdo contido na página número 16
From the handset 1 Phone rings.
Incoming Call 2 Press . “ Talk” and volume setting appears on the display. Talk 0:00
3 Talk with the caller. Talk 0:02
4 To hang up, press or place the handset on the base. The call time will be displayed for about 5 seconds. 115:35
AutoTalk when ringing When the AutoTalk setting is on and there is an incoming call, simply lift the handset from the base unit to answer the phone. See “Setting Caller ID options” on pag
Resumo do conteúdo contido na página número 17
ringer off on ringer off on Ringer tone and volume The phone has four types of ringer tone and volume combinations. In the standby mode, press on the handset. Every time you press , the display shows the setting. Ringer on/off switch This switch turns the handset ringer on or off. Earpiece volume Pressing or will change the earpiece volume of the handset. This setting will remain in effect after the telephone call has ended.
Resumo do conteúdo contido na página número 18
The last three phone numbers dialed can be quickly redialed. Redial from standby 1 Press . The phone number that was last dialed appears on the display. If the number exceeds 32 2 Press again. digits, only the first 32 Each press of will display digits are retained for one of the last three numbers dialed. redialing.
Most 8178583300
recent
2145551234
9725554321
3 Press . “Talk” appears on the display, th
Resumo do conteúdo contido na página número 19
Redial from talk mode 1 Press . “Talk” appears flashing on the display. Talk
Talk
2 Press . The last number dialed will be displayed. 3 To hang up, press or place the handset on the base. The call-time will be displayed for about 5 seconds. Only the last number dialed can be accessed after has been pressed. During a call, as you begin to move your handset too far from your base unit, noise increases. If you pass the range limits of the base unit,
Resumo do conteúdo contido na página número 20
Memory Dialing allows you to dial a number using just a few key strokes. You can store up to 20 phone numbers in the memory. In memory dialing operation, you must press 1 Press and hold until a key within 20 seconds or “Memory Store” is displayed. the phone will return to standby. If you return the Memory Store
handset in the cradle the 01
phone will also return to 02 standby. 2 Press and or enter a two- digit number (01 - 20) to select the memory location where you would
