Manual do usuário Teledex 2011

Resumo do conteúdo contido na página número 1

REQUIREMENTS OF PART 68 - FCC RULES
This device has been granted a registration number by the Federal Communications Commission, under Part 68 rules
and regulations for direct connection to the telephone lines. In order to comply with these FCC rules, the following
users
instructions must be carefully read and applicable portions followed completely:
1. Direct connection to the telephone lines may be made only through the standard modular cord furnished, to the
utility installed jack. No connect

Resumo do conteúdo contido na página número 2

OPAL 2000 SERIES TELEPHONE DIAGRAM CONVERTING FROM DESK TO WALL MOUNT The Opal series can be changed for wall mounting applications. The conversion is easiest when the handset and line cords are not connected. 1) Located on the top of the telephone above the speaker grill is the wall/desk mount clip. Remove this clip by firmly pushing upward (towards the hookswitch). 2) Flip the clip over (top to bottom) so that the protruding edge is towards the top of the phone. This edge will hold the handse

Resumo do conteúdo contido na página número 3

PROGRAMMING THE AUTO DIAL KEYS INCLUDED IN YOUR PACKAGE Handset Line Cord The Opal 2000 series has up to eleven (11) programmable AUTO DIAL keys. Follow the Base Unit Clear Plastic Overlay steps below to program the keys to automatically dial telephone numbers, or to activate tele- Coiled Handset Cord User Guide phone system features. To program the auto dial keys, the telephone must be connected to an active telephone line. 1) Lift the handset from the cradle or press the SPEAKERPHONE key. CON

Resumo do conteúdo contido na página número 4

USING THE SPEAKERPHONE TO ACTIVATE THE SPEAKERPHONE FROM HANDSET MODE: 1. With the handset in the cradle, press the line key associated with the ringing line. The (SPEAKERPHONE-EQUIPPED MODELS ONLY) Opal will go off hook answering the ringing line with the speakerphone active. 1) Press the SPEAKER key. OR 2) The red SPEAKER LED will indicate speakerphone selection. 2. Press the SPEAKER key. The Opal will select the ringing line and answer with the 3) Place the handset back into the cradle. s